-
RBH Sound RBH 180 - page 1
101 89 59-26 R BH 1 80 Please read these instructions carefully and make sure you understand them before using the machine. Operator´ s manual ...
-
RBH Sound RBH 180 - page 2
Svenska – 31 Sve-5 225/232/235 Bruk 97-11-25, 08.46 31 ...
-
RBH Sound RBH 180 - page 3
English – 1 INTERNA TIONAL SYMBOLS ....................................................................................... 1 SAFETY RULES ........................................................................................................... 2 ASSEMBL Y .......................................................................................... ...
-
RBH Sound RBH 180 - page 4
2 – English 1. GENERAL OPERA TION: • Know controls and how to stop quickly . • Read, understand, and follow all instructions in the manual and on the machine before starting. • Only allow responsible adults, who are familiar with instructions, to operate the machine. • W ear safety glasses or eye shields when assembling or operating the m ...
-
RBH Sound RBH 180 - page 5
English – 3 UNP ACKING The tractor is not completely assembled at the factory , for transportation reasons. After removing the packaging, check the machine for any damage during the shipment, locate the hardware bag and loose parts. T ake care while removing the machine from the pallet, to avoid any damage to the mower deck. ST ANDARD P ACKING ? ...
-
RBH Sound RBH 180 - page 6
4 – English TRAILER HITCH (FIG. 4) ASSEMBL Y The grass collector has been pre-assembled. However , to assemble it correctly (to fit the collector cover with tractor fenders). It is recommended to follow the instructions below: 1. T ake the pre-assembled basket (item 1) out the box, tilt the front tube (item 3), insert the upper bolts (item 2) and ...
-
RBH Sound RBH 180 - page 7
English – 5 ASSEMBL Y PLACING THE GRASS COLLECTOR ON THE TRACTOR (FIG. 6) Fig. 6 Proceed to the following steps: 1. Lift the grass collector assembly with both hands. Slant it to an angle of approximately 40° (fig. 6). 2. Slide the grass collector on the two support brackets located on the rear of the tractor . 3. When the grass collector is pro ...
-
RBH Sound RBH 180 - page 8
6 – English ASSEMBL Y CHECK THE BA TTERY If it is necessary proceed to the following steps: 1. Remove the battery from the tractor . 3. Charge the battery at a rate of 6 amps for 1 hour . Use a 12-volt battery char ger . Observe all precautions required for battery char ging. Complete the assembly of your unit while waiting for battery to charge. ...
-
RBH Sound RBH 180 - page 9
English – 7 CONTROLS 1. Dash panel (fig. 1 1) a. throttle control lever b. ignition switch c. headlight switch d. switch MAN-AUTO, collector fill gauge e. re-engage switch f. ON/OFF switch, cutting system. 2. Steering wheel 3. Choke control 4. Cutting height adjustment lever 5a. Forward speed pedal 5b. Reverse speed pedal 6. Parking brake lever 7 ...
-
RBH Sound RBH 180 - page 10
8 – English OPERA TION ! ! DANGER Never run the engine indoors, or in enclosed or poorly ventilated areas. Engine exhaust contains carbon monoxide. TO ST AR T THE ENGINE T o start the engine, proceed as follows: 1. Open the fuel valve. The handle should point down as shown in the fig.13. Fig. 13 2. T ake a comfortable riding position on the seat. ...
-
RBH Sound RBH 180 - page 11
English – 9 OPERA TION Move the throttle to slow position before turning ignition off, in order to reduce muf fler pop. Failure to do so will result in engine and exhaust damages. ! ! W ARNING The mower deck must be in the highest position, when you drive the tractor in transport mode off the lawn. If not, damages will be caused to the blades. IM ...
-
RBH Sound RBH 180 - page 12
10 – English OPERA TION Fig. 19 IMPOR T ANT In T -position the cutting system will STOP automati- cally and it will stay in the STOP status even when the cutting height lever is lower ed down again. For the continuing- of the cutting you must push the re-engage button (See Fig. 1 1, item 1. e). MOWER DECK GAUGE WHEELS (FIG. 20) The mower deck gau ...
-
RBH Sound RBH 180 - page 13
English – 11 OPERA TION SLOPE OPERA TION • All slopes need extra caution. • Do not cut grass, when slope is more than 10° (17%). • Mow slopes, riding up and down, never across. • A void sudden changes in direction. • Remove obstacles such as rocks, tree limbs, ruts, etc. ! ! W ARNING While travelling downhill, never coast! When parking ...
-
RBH Sound RBH 180 - page 14
12 – English After each cut, remove dirt and debris from the machine surface, the discharge tunnel and the grass collector . W ASHING (FIG. 22) MAINTENANCE CLEANING Before cleaning, washing, servicing or repairing, remove the ignition key! Always wear substantial steel toe foot wear , gloves and work clothes. Be aware of any spilled fuel, oil or ...
-
RBH Sound RBH 180 - page 15
English – 13 MAINTENANCE ll l l l l l l l l l l 1,2 l 1,2 l 2 SER VICE RECORD FILL IN DA TES AS YOU COMPLETE REGULAR SER VICE MAINTENANCE CHECKLIST BEFORE STORAGE BEGINNING EACH SEASON EVER Y 100 HOURS EVER Y 50 HOURS EVER Y 25 HOURS MONTHL Y FREQUENTL Y AFTER FIRST 20 HOURS AFTER FIRST 5 HOURS AFTER FIRST 2 HOURS BEFORE EACH USE Check engine oil ...
-
RBH Sound RBH 180 - page 16
14 – English LUBRICA TION (FIG 23) Fig. 23 LUBRICA TION LIST Item Name Number T erm-hours Lubricant 1 Front wheel - grease fitting 2 25 Grease 2 Steering ball-joints 4 50 Oil 3 Steering sector gear 1 50 Grease 4 Steering pinion gear 1 25 Grease 5 Steering shaft bearing 1 50 Oil 6 Steering shaft bearing 1 50 Oil 7 Movement lever - grease fitting 1 ...
-
RBH Sound RBH 180 - page 17
English – 15 The bearings in idler pulley and retainer pulleys are life time lubricated. Gear box is filled with oil. ! ! DANGER Lead acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from battery . Always wear eye protection when around batteries. BA TTERY MAINTENANCE (FIG. 24) MAINTENANCE Fig. 24 When starte ...
-
RBH Sound RBH 180 - page 18
16 – English MAINTENANCE Fig. 26 FUSE EXCHANGE The fuse box is placed under the dash. Proceed as follows: 1. Lift the hood up. 2. Pick out the fuse and replace it by another one of the same value (15A). If it is still impossible to start the engine, call your service dealer . WHEEL EXCHANGE (FIG. 27) Fig. 27 Proceed as follows: 1. Switch off igni ...
-
RBH Sound RBH 180 - page 19
English – 17 ADJUSTMENTS TRACTOR BRAKE ADJUSTMENT (FIG. 28) Y our tractor is equipped with a disc brake mounted on the transaxle. T o check the brake operation: 1. Place the tractor on a flat surface, and stop the engine. 2. Place the shift control lever in neutral position. 3. Depress the brake pedal enough to latch the parking brake lever in th ...
-
RBH Sound RBH 180 - page 20
18 – English ADJUSTMENTS SER VICING In the event of system failure, there is a manual position "MAN" switch option which allows for a temporary over -ride of the overload warning system. It is recom- mended that this be only used as a back-up & only until necessary repairs can be arranged. A temporary by-pass service connector has b ...
-
RBH Sound RBH 180 - page 21
English – 19 ADJUSTMENTS TRANSMISSION DRIVE BEL T (FIG. 31) Fig. 31 TRANSMISSION DRIVE BEL T (FIG 31) 1. engine pulley 2. pulley 3. idler pulley Adjust the tension of the belt with the pulley 3. MOWER CLUTCH BEL T (FIG 32) The tension of the belt is automatically adjusted with the spring loaded idler pulley . MOWER DECK BEL T (FIG. 33) ADJUST THE ...
-
RBH Sound RBH 180 - page 22
20 – English ADJUSTMENTS tension bracket idler . 5. Adjust nut M10 until the specified tension at cog belt is reached. (See Fig 33) 6 Re-tighten the two hex nuts on the cog idler pulley and the belt is now adjusted correctly . 7. T o re-install the cutting pan - reverse the procedure. Note: It is possible but not desirable to adjust the cog belt ...
-
RBH Sound RBH 180 - page 23
English – 21 WIRING DIAGRAM COLOR LEGEND OF WIRES: B - BLUE R - RED BR - BROWN W - WHITE BLK - BLACK Y - YELLOW GRN - GREEN V - VIOLET GR Y - GREY LT B - LIGHT BLUE 1. Battery 2. Engine 3. Ignition switch 4. Starter relay 5. Starter 6. Magnetic clutch (diode + resistor) 7. Headlights 8. Seat switch 9. ST AR T -CUT switch 10. AUTO-MAN switch 1 1. ...
-
RBH Sound RBH 180 - page 24
22 – English TROUBLESHOOTING GUIDE PROBLEM CORRECTION Mower cuts ragged or uneven Mower leaves unmowed strip between blades Mower scalps lawn Mower will not discharge clippings Blade drive belt comes off during use Blade drive belt slips Blade drive belt wears excessively Blades will not engage 1. Remove any accumulation of grass clippings from u ...
-
RBH Sound RBH 180 - page 25
English – 23 TROUBLESHOOTING GUIDE PROBLEM 1. Check blades and make sure they are not bent, out of balance or loose. Replace if necessary . 2. Check belt for burn spots or irregularities that might cause vibrations. Replace if necessary . 3. Check quill assemblies for damage or wear . Replace if necessary . 4. Check for worn or damaged blade enga ...
-
RBH Sound RBH 180 - page 26
24 – English The tractor should be immediately prepared for storage at the end of the season, or if the unit is to be unused for 30 days or more. Fuel, if permitted to stand unused for extended periods (30 days or more), may develop gummy deposits which can adversely affect the engine carburettor and can cause engine malfunction. STORAGE Chart (p ...
-
RBH Sound RBH 180 - page 27
English – 25 TECHNICAL SPECIFICA TIONS Engine: 18 HP V ANGUARD V -TWIN Briggs & Stratton * Battery: 12 V olts/22 Ah Front tyres: 16 X 6.50 - 8 Rear tyres: 20 X 10.00 - 8 Front tyres pressure: 100 kPa (1 Bar) Rear tyres pressure: 70 kPa (0,7 Bar) T ransaxle: HYDRO-GEAR MODEL NO: 310-0650 Forward speed 0 - 9 km/h Reverse speed 0 - 4 km/h T urni ...
-
RBH Sound RBH 180 - page 28
26 – English ´*2°z¶1[¨ ...
У вас вопрос, касающийся RBH Sound RBH 180?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с RBH Sound RBH 180, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с RBH Sound RBH 180 со всей вероятностью он захочет поделиться методом ее решения.