-
Ford 2002 Windstar - page 1
Quick Start — How to get going 2 Introduction 4 Description 8 Operating Instructions 17 Videocassette Player Display Messages 21 In-Home Use 23 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitt ...
-
Ford 2002 Windstar - page 2
QUICK START — HOW TO GET GOING T o operate the system: 1. Y our AutoVision t Video Entertainment System is automatically activated when the vehicle ignition and the audio system are ON. 2. If a movie is desired, insert a VHS cassette into the VCP and the video should start playing. 3. Press the MEDIA control to toggle to any other desired media s ...
-
Ford 2002 Windstar - page 3
T o play a video game: 1. Connect the video line from your game device to the VIDEO jack. 2. Connect the left and right audio cables to the left (L) and right (R) audio jacks. 3. Ensure that the system is in AUX mode. The LCD screen will turn on and the AUX indicator will illuminate. 4. If desired, press the / control and plug a 3.5mm headphone int ...
-
Ford 2002 Windstar - page 4
Y our AutoVision t Video Entertainment System allows you to watch movie rentals and your favorite home videocassettes. It also allows you to plug in and play a variety of standard video games. Please review this user manual to become familiar with the AutoVision t V ideo Entertainment System features and controls as well as the very important safet ...
-
Ford 2002 Windstar - page 5
Disconnect video games and video equipment power cords and/or cables when not in use. A void touching auxiliary input jacks with your fingers. Do not blow on them or allow them to get wet or dirty . Do not clean any part of the AutoVision t V ideo Entertainment System with benzene, paint thinner or any other solvent. FEDERAL COMMUNICATION COMMISSIO ...
-
Ford 2002 Windstar - page 6
T emperature extremes When the vehicle is parked under direct sunlight or in an extremely cold place for a long period of time, wait until the cabin temperature of the vehicle is at normal temperature before operating the system. High/low temperature sensor circuit • Excessively high or low temperatures may cause damage to the VCP . • When the ...
-
Ford 2002 Windstar - page 7
Cleaning video heads Magnetic video heads convert the videocassette into pictures on the screen during playback. Over a period of time, particles rub off the tape and are left on the heads. Using an old or poor quality tape together with dust and air particles, high temperature and humidity cause dirty heads. Dirty heads generally cause “snowy” ...
-
Ford 2002 Windstar - page 8
AUTOVISION T V IDEO ENTERTAINMENT SYSTEM Features • 2–head hi-fi playback • AutoPlay feature • Digital auto tracking • Dual stereo headphone with electric volume control • Self docking connection for easy mobile installation • Latching system for secure safety • Carrying handle for portability • W ater resistant tape door • On s ...
-
Ford 2002 Windstar - page 9
VCP CONTROLS 1. LED display The display lamp will light up in green when power is supplied to the videocassette player . 2. POWER key Press to toggle between ON/OFF . When the power is ON, other keys (PLA Y , FF , REW , STOP) will illuminate. 3. PLA Y key Press to playback a videocassette tape. 4. REWIND/REVIEW button Press to enter the reverse pic ...
-
Ford 2002 Windstar - page 10
REMOTE CONTROL 1. POWER button Press to turn the videocassette player (VCP) ON or OFF . 2. ENCORE button Press to reverse the cassette for 5 seconds. Normal playback will then resume when in PLA YBACK mode. 3. STILL/ADV ANCE (frame advance button) Press to temporarily suspend playback. Press again to make the tape advance one frame at a time. 4. RE ...
-
Ford 2002 Windstar - page 11
8. REW button Press to rewind the tape. 9. FF button Press to fast forward the tape. 10. STOP button Press to stop the tape. BATTERY REPLACEMENT Batteries are supplied with the remote control unit. However , they are simply for operation check and will only work for a short time. Slide battery cover off as shown on remote control to access the batt ...
-
Ford 2002 Windstar - page 12
AUTOVISION T V IDEO ENTERTAINMENT SYSTEM CONTROLS The AutoVision t V ideo Entertainment System controls allow the rear seat passengers to operate the radio, tape, CD or CD DJ (if equipped). PARENTAL CONTROL Y our AutoVision t Video Entertainment System allows you to have control over the rear seat controls. The system is automatically activated whe ...
-
Ford 2002 Windstar - page 13
ADJUSTING THE VOLUME This control allows the rear seat passengers to adjust the volume level of the audio system. Press the + control to increase the volume. Press the — control to decrease the volume. From the AutoVision t V ideo Entertainment System controls, the speaker volume cannot be set higher than the current volume radio setting. When in ...
-
Ford 2002 Windstar - page 14
Press the / control again to engage the rear speakers and deactivate the Personal Audio Feature. SINGLE PLA Y will appear in the radio display . For more information on Single Play and Dual Play , please refer to the Rear Seat Controls section in the Entertainment Chapter of your Owner’ s Guide. SPEAKERS ON/OFF MODE W ith the speakers ON, you can ...
-
Ford 2002 Windstar - page 15
MEMORY PRESET CONTROL In radio mode, press the MEM (Memory) control successively to scroll through the memory presets in AM, FM1 or FM2. In CDDJ mode, press the MEM (Memory) control to select the next disc in the compact disc changer . Play will begin with the first track. SEEK FUNCTION The SEEK control has varying functions depending on which mode ...
-
Ford 2002 Windstar - page 16
FLIP-DOWN SCREEN The screen rotates down to view and up into the housing to store when not in use. Ensure that the screen is latched into the housing when being stored. 1. 6.4” (diagonal) color liquid crystal display (LCD) screen. 2. Screen housing. 3. Dimmer switch. Rotate to increase/decrease the brightness of the screen. 1 3 2 Description 16 ...
-
Ford 2002 Windstar - page 17
GENERAL OPERATION • When the engine is not running, use the system sparingly otherwise it will run the battery down. • Do not leave the videocassette in the VCP overnight or for long periods of time. • When the ignition is turned ON, audio is through the headphones as LOW volume. Press the (+) control to increase volume. T o listen through th ...
-
Ford 2002 Windstar - page 18
2. Connect the left and right audio cables to the WHITE and RED jacks respectively . 3. Ensure that the system is in AUX mode. The LCD screen will turn on and the AUX indicator will illuminate. On-screen indicators Playback operation 1. Press the POWER control on the VCP . 2. Insert a videocassette into the VCP . 3. The videocassette should automat ...
-
Ford 2002 Windstar - page 19
If still playback/or frame-to-frame playback is engaged for five minutes or longer , the VCP will automatically begin playback to protect the tape. Automatic tracking is automatically activated the moment the VCP is turned ON or a cassette is inserted. If a videocassette is in poor shape (i.e., badly recorded), any tracking adjustment may result in ...
-
Ford 2002 Windstar - page 20
V ideo source selection The MEDIA control determines which video (VCP or Auxiliary input) is seen on the AutoVision t screen. When the vehicle ignition is ON and the system is not in VCP mode, the AutoVision t selects the Auxiliary input as the video source. (If there is not a video source connected to the Auxiliary input jack, the screen will be b ...
-
Ford 2002 Windstar - page 21
INDICATIONS ON THE VCP The operation and status of the VCP can be checked by the indications appearing on the LED display . 1. The Power indicator flashes on during POWER ON and will blink when in emergency mode. 2. The HI-FI indicator illuminates when a HI-FI tape is loaded. 3. The HP1 indicator illuminates when the headphone jack 1 is plugged in. ...
-
Ford 2002 Windstar - page 22
Illuminates during power off when there is not a cassette present in the system. Illuminates when the videocassette is in REW (rewind) mode. Illuminates when the videocassette is in FF (fast forward) mode. Illuminates when the videocassette is in STIL (pause) mode. Illuminates when the videocassette is in PLA Y mode. Illuminates when the videocasse ...
-
Ford 2002 Windstar - page 23
IN-HOME USE Y our AutoVision t Video Entertainment System is UL registered for in-home use. This system has the unique feature of also being a completely portable and able to be used in your home. T o remove your AutoVision t Video Entertainment System from your vehicle, depress the lever on the center console labeled VCP RELEASE. This will release ...
-
Ford 2002 Windstar - page 24
1. VIDEO IN Connect this terminal to the VIDEO OUT terminal of your other apparatus (DVD, game machine, etc.). 2. AUDIO IN LR Connect these terminal(s) to the AUDIO OUT terminals of your other apparatus (DVD, game machine, etc.). 3. Plug headphones into these jacks. In-Home Use 24 ...
У вас вопрос, касающийся Ford 2002 Windstar?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Ford 2002 Windstar, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Ford 2002 Windstar со всей вероятностью он захочет поделиться методом ее решения.