-
Light & Motion HC3 - page 1
Bluefin HC3 Owner’ s Manual www .uwimaging.com For the Son y HDR-HC3 camcorder ...
-
Light & Motion HC3 - page 2
W elcome Congratulations on your pur chase of the Bluefin underwater video housing. Please inspect the packaging of your pr oduct to verify that there was no damage during shipping. If you ar e not familiar with your camcorder’ s features, please tak e time to become familiar with the camcorder befor e you pr oceed in this manual.This manual assu ...
-
Light & Motion HC3 - page 3
3 T able of Contents Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Camera Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 P-Menu Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
Light & Motion HC3 - page 4
4 Getting Star ted Illustrated below ar e the locations of Bluefin’ s features and functions. T ake time to familiarize yourself with the housing. Monitor Base Light Arm Base Lens Lock ON/MODE Button Monitor Bulkhead P-Menu Selector Easy Button Flip Filter Lev er Manual Button Camera Control Knob Self-Locking Rotary Latch ...
-
Light & Motion HC3 - page 5
5 Camera Pr eparation 1. Install a fully charged Son y NP-FP90 batter y . 2. Install a HD D VC tape into your camcor der . 3. If still images are desir ed, install a Memor y Stick Duo. Press the Flash button on the right side of the camcor der to disable the camcorder’ s built-in flash pre venting the flash from r eflecting back into the camcorde ...
-
Light & Motion HC3 - page 6
6 P-Menu Setup The P-Menu is a customizable menu that allo ws quick access to commonly used camera featur es.This is ver y useful underwater since controls such as White Balance can only be accessed thr ough the camera’ s menu system. The Bluefin HC3 uses a window mounted r otar y control (P-Menu Selector) that will allow access to the right colu ...
-
Light & Motion HC3 - page 7
7 (Fig. 5) (Fig. 6) (Fig. 7) (Fig. 8) ...
-
Light & Motion HC3 - page 8
8 Mounting the Camera 1. Remov e the rear plate b y pushing the Latch Lock in and rotating the latch do wn and forward of the housing body . (Refer fig. 9) 2. Remov e the Camera T ray . A. Push forward on the Camera T ray . B. Press the Camera T ra y Release Latch down. (Refer fig. 10) The Camera T ray is spring loaded and will slide out of the hou ...
-
Light & Motion HC3 - page 9
9 and that the O-rings seat ev enly . Operation Left Smar t Grip Controls (Refer fig. 12) Far - Moves focus point further from camcor der . Near - Mov es focus point closer to camcorder . Photo - Records still video captur e to Memor y Stick (in either mode). Light - After initial power up fr om batter y pod, cycles Elite Lights through thr ee outp ...
-
Light & Motion HC3 - page 10
10 Rear Plate (Refer fig. 15) On/Mode - T urns the camcorder on and cycles thr ough modes. Housing Left Side (Refer fig. 16 and 17) Manual - Activates the camera’ s manual button. Briefly pushing this button activates manual contr ol of the active function. Y ou can change the active function by pushing and holding the button until the menu of op ...
-
Light & Motion HC3 - page 11
11 Smooth Slo w Recording Set up the P-Menu as described in this manual under P-Men u Setup . Befor e loading the camera into the housing set the mode for the Smooth Slow Recording function to either captur e images seen by the camera before or after the Record button is pushed. (See camera manual) Use of Smooth Slow Recording Use the P-Menu Select ...
-
Light & Motion HC3 - page 12
12 Lens Installation / Remo val T o Install Lens 1. Perf orm o-ring inspection. 2. Align lens to housing details. 3. Press lens into housing. 4. Rotate clockwise until Locking pin engages. T o Remove Lens 1. Slide Locking pin outward a wa y from lens. 2. Rotate lens counter clockwise. 3. Pull a way fr om housing. (Fig. 18) (Fig. 19) Using the Bluef ...
-
Light & Motion HC3 - page 13
13 Bluefin Monitors - Getting Star ted Illustrated below ar e the components of the Compact Monitor and the Remote Monitor . T ake time to identify and become familiar with each part. Compact Monitor Remote Monitor Bulkhead Clamp Assembly Monitor Cable Lens Shade Re versing Smart Grip Button Functions Smart Grips can be programmed to swap left and ...
-
Light & Motion HC3 - page 14
14 Bluefin Monitor - Bulkhead Installation 1) Remov e the Rear Plate. 2) Using a flat head scre wdriver or coin, remove the P or t Plug. (Refer Fig. 16) 3) On the inside of the Rear Plate, remov e the four screws using a 3/32 allen k ey and remo ve cir cuit board. (Refer Fig. 17) 4) Feed Bulk Head cable thr ough Bulk Head por t. (Refer Fig. 18) 5) ...
-
Light & Motion HC3 - page 15
15 Compact Monitor Operation Po wer On/Off The monitor will pow er on and off with the camcorder . Remote Monitor Operation 1) If necessar y , activate pow er to the monitor by switching the pow er switch on the inside of the Rear Plate to the ON position. 2) Connect monitor cable to Bulkhead prior to entering the water . 3) Connect monitor cable t ...
-
Light & Motion HC3 - page 16
16 Charging the Remote and Compact Monitor 1) Remov e the Charging Port Plug using a coin or large flat head scre wdriver . (Refer fig. 20) 2) Plug charger into a 110v outlet. This charger is only rated at this v oltage. If you do not ha ve access to a 110v outlet, you must use a conv er ter . 3) Plug charging connector from charger into charging p ...
-
Light & Motion HC3 - page 17
17 Bluefin Light Systems - Getting Star ted Pictured belo w are the components of the Sunra y-S Mini Pro and Sunra y-S Mini Elite lighting system. T ak e a moment to familiarize yourself with each part for later identification and use. Battery Pods Light heads Charger and electrical cord Pod Lock er Light Arms HID light heads Li-ion Batteries Sunra ...
-
Light & Motion HC3 - page 18
18 Charging Ba tteries It is recommended that y ou charge your batteries when they ar e receiv ed. It is also r ecommended to charge batteries just prior to use. 1) The charger can accept an electrical range of 100 - 240v and 50 - 60hz. 2) The charger has two LED lights: Left LED: Orange when charging Li-ion batteries. Green when charging NiMH batt ...
-
Light & Motion HC3 - page 19
19 Mounting Battery P ods 1) Remov e the rear plate of the housing. 2) Slide the batter y pods into housing channels. 3) Insert Pod Lock er between the pods and tighten using 1/8” allen ke y . Do not ov er -tighten. Connecting Lights to Battery P ods 1) Plug in the cable connectors on the pod. 2) Tighten the locking sleev es by rotating clockwise ...
-
Light & Motion HC3 - page 20
20 (Fig. 25) (Fig. 26) (Fig. 27) (Fig. 28) 1) Using an allen k ey , remov e the two scre ws on the back of the handle . (Refer fig. 25) 2) Remov e the Handle Cap fr om the handle assembly . (Refer fig. 26) 3) Remov e old batteries from handle boar d. 4) Install new 1/3 N batteries into the handle boar d. (Refer . fig. 27) The +/- position of the ba ...
-
Light & Motion HC3 - page 21
21 First Time Use All Light & Motion equipment is pressur e tested prior to shipping. Howe ver , ther e could be unseen damage due to shipping. A test dive without the camcorder in the housing is highly r ecommended. After the initial dive with just the housing, mak e the following checks: 1. Dr y off housing exterior . 2. Remov e the Rear Plat ...
-
Light & Motion HC3 - page 22
Rear Plate O-rings Smart Grip O-ring Optic O-rings 4) T o check O-rings for damage, place the O-ring betw een the index finger and thumb. Then pull the O-ring through y our fingers, feeling for an y debris or wear . 5) If O-rings are dirty , it is best to replace them. W ashing dir ty O-rings with soap and water is not recommended. Soap breaks down ...
-
Light & Motion HC3 - page 23
Bluefin Accessories Bluefin T wo-Y ear Fault Free W arranty . . . . . . . . . . . . . .905-0201 Bluefin Super Macro Lens . . . . . . . . . . . . . . . . . . . . . . .802-0095 Bluefin T ripod Mount . . . . . . . . . . . . . . . . . . . . . . . . . . .802-0152 Bluefin Pole Cam Mounting Kit . . . . . . . . . . . . . . . . . . .802-0148 Bluefin Custom ...
-
Light & Motion HC3 - page 24
Light & Motion 300 Canner y Row • Monter ey , C A 93940 (831) 645-1525 • Fax (831) 375-2517 www .uwimaging.com 905-0266-A ...
У вас вопрос, касающийся Light & Motion HC3?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Light & Motion HC3, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Light & Motion HC3 со всей вероятностью он захочет поделиться методом ее решения.