-
Sanyo KS3632 - page 1
INSTRUCTION MANUAL Split System Air Conditioner W all-mounted type Ceiling-mounted type Recessed type KS2432 TS2432 XS1822, XS1852 KS3032 TS3632 XS2432 KS3632 TS4232 XS3632 XS4232 COOL/F AN Model Sav e Thes e Instructions! Pub . OI-8546418920100 4 ©SANY O 200 3 ...
-
Sanyo KS3632 - page 2
Features These air conditioners are equipped with cooling function. Details on this function are provided below; refer to these descriptions when using the air conditioner . • Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, easy logically displaye ...
-
Sanyo KS3632 - page 3
Contents Page Features .................................................................................................................. 2 Product Information .............................................................................................. 3 Alert Symbols ............................................................................... ...
-
Sanyo KS3632 - page 4
Installation Location • We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. • Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. • Do ...
-
Sanyo KS3632 - page 5
Names of Parts Each air conditioner as shown below consists of an indoor unit and an outdoor unit. Y ou can control the air conditioner with the remote control unit. NOTE This illustration is based on the external view of a standard model. Consequently , the shape may differ from that of the air conditioner which you have selected. Air intake The r ...
-
Sanyo KS3632 - page 6
Unit Display and Operation Selector OPERA TION lamp TIMER lamp Remote control receiver Recessed type Ceiling mounted type Air filter Recessed type Air intake grille Operation selector Ceiling mounted type Air intake grille Finger -hold Operation selector 6 OI-201-06EG oi201001 ...
-
Sanyo KS3632 - page 7
Unit Display and Operation Selector (continued) REMOTE CONTROL receiver This section picks up infrared signals from the remote control unit (transmitter). Operation selector ON position This position is for operating the air conditioner with the wireless remote control unit. Set the selector normally in this position. OFF position Switch the select ...
-
Sanyo KS3632 - page 8
Remote Control Unit (Display) (1) Operation mode COOL ....................................... F AN .......................................... (2) Fan speed Automatic operation .............. HIGH ........................................ MEDIUM .................................. LOW ......................................... F HR. 1 A A A A A A Symbo ...
-
Sanyo KS3632 - page 9
9 OI-20 1-09E G Remote Contr ol Unit Sensor T r ansmitter Display NIGHT SETBACK but ton 1 HR. TIMER but t on MODE selector but ton FLAP butt on ADDRESS switch (Cov er closed) ON/OFF operation but ton T emper ature set ting butt ons F AN SPEED selector but ton TIMER SELECT butt on TIMER AND PRESENT TIME setting but tons PROGRAM but ton ACL but ton S ...
-
Sanyo KS3632 - page 10
10 OI-20 1-1 0E G Remot e Contr ol Unit (continued) Pr ogram but ton For details, see “Set ting the Timer” . Press this but ton to select the mode you w ant to program. TIMER SELECT but ton No display : The timer does not operate. : The air conditioner stops at the set time. : The air conditioner starts at the set time. : The air conditioner st ...
-
Sanyo KS3632 - page 11
11 OI-20 1-1 1EG The remote control unit may be operated either from a non-fixed position or from a wall-mounted position. T o ensure that the air conditioner operates correctly , DO NOT install the remote control unit in the following places: DO NO T • In direct sunlight • Behind a cur tain or other places where it is covered • More than 26 ...
-
Sanyo KS3632 - page 12
12 OI-20 1-1 2EG Using the Remot e Contr ol Unit (continued) Mounting the Remote Contr ol Unit When at taching t o wall 1) Confirm the indoor unit beeps when the ON/OFF but ton is pressed at the wall location where the remote control unit is to be at tac hed, then attac h the holder to the w all. 2) When taking out the remote control unit, pull it ...
-
Sanyo KS3632 - page 13
13 OI-20 1-1 3EG Operation with the R emote Control Unit 1 . Oper ation NO TE Chec k that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position. Press the set ting but tons as described below and c hange the settings as desired. S TEP 1 Set the MODE selector but ton to COOL. F o ...
-
Sanyo KS3632 - page 14
Operation with the Remote Control Unit (continued) NOTE • Choose the best position in the room for the remote control unit, which also acts as the sensor for room comfort and transmits the operating instructions. Once you’ve found this best position, always keep the remote control unit there. • This appliance has a built-in 3-minute time dela ...
-
Sanyo KS3632 - page 15
Operation with the Remote Control Unit (continued) 4. Night Setback Mode Night Setback Mode is used for saving energy . Press the NIGHT SETBACK button while operation. The mark appears in the display . T o release the night setback function, press the NIGHT SETBACK button again. NOTE The night setback mode cannot be used during automatic operation. ...
-
Sanyo KS3632 - page 16
Special Remarks Power failure during operation • In the event of power failure, the unit will stop. When the power is resumed, the unit will restart automatically after three minutes. Remote Control Unit • The remote control unit sends the setting condition to the air conditioner regularly at three minute intervals. 16 OI-201-16EG oi201001 ...
-
Sanyo KS3632 - page 17
17 OI-20 1-1 7EG S et ting the T imer 1 . Ho w to set the pr esent time (Example) T o set to 9:1 0 pm. Operation Indication 1 . Press the P rogram but ton ( ) three times. 2. • Press the HH but ton until PM 9 is displayed. • Press the MM but ton until 1 0 is displayed. The time indication alone blinks. The display will automatically stop blinki ...
-
Sanyo KS3632 - page 18
18 OI-20 1-1 8EG Set ting the Timer (continued) 3 . Ho w to set the ON time (Example) T o star t operation at 7:1 0 am. Operation Indication 1 . Press the P rogram but ton ( ) twice. 2. • Press the HH but ton until AM 7 is displayed. • Press the MM but ton until 1 0 is displayed. 3. Press the ON/OFF but ton to star t the air conditioner . 4. Pr ...
-
Sanyo KS3632 - page 19
19 OI-20 1-1 9EG 2 . Oper ation T ogether with the Pr ogram Timer Using the 1 -Hour OFF T imer 1 . 1 -Hour OFF Timer This function causes the unit to oper ate f or one hour and then stop, r egar dless of whether the unit is on or off when this but t on is pressed. The indicator in the display indicates that this function is operating. Setting pr oc ...
-
Sanyo KS3632 - page 20
Adjusting the Airflow Direction A. Horizontal (Wall mounted type only) The horizontal airflow can be adjusted by moving the vertical vane to the left or right. B. V ertical Confirm that the remote control unit has been turned on. Press the FLAP button to start the flap moving up and down ( ). If you want to stop the flap movement and to direct the ...
-
Sanyo KS3632 - page 21
Care and Cleaning 1. For safety , be sure to turn the air conditioner off and also to disconnect the power before cleaning. 2. Do not pour water or spray detergent on the indoor unit to clean it. This will damage the internal components and may cause an electric shock or fire. Air Intake and outlet side (Indoor Unit) Clean the air intake and outlet ...
-
Sanyo KS3632 - page 22
Care and Cleaning (continued) How to remove the filter Ceiling mounted type: 1. Remove the bolt screws on the latch using a screwdriver . (After cleaning, be sure to reattach the two bolt screws.) 2. T ake hold of two latches on the air intake grille and press it to the rear , and the grille will open downward. 3. T ake hold of the finger -hold on ...
-
Sanyo KS3632 - page 23
T roubleshooting If your air conditioner does not work properly , first check the following points before requesting service. If it still does not work properly , contact your dealer or service center . T rouble Possible Cause Remedy Air conditioner does not run at all. 1. Power failure. 1. Restore power . 2. Leakage breaker tripped. 2. Contact ser ...
-
Sanyo KS3632 - page 24
SANYO FISHER COMP ANY A DIVISION OF SANYO NORTH AMERICA CORPORA TION 21605 Plummer Street Chatsworth, CA 91311 U.S.A. In Canada SANYO Canada Inc. oi201001 300 Applewood Crescent, Concord, Ontar io, L4K 5C7 , Canada ...
У вас вопрос, касающийся Sanyo KS3632?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Sanyo KS3632, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Sanyo KS3632 со всей вероятностью он захочет поделиться методом ее решения.