-
Winegard LP-1000 - page 1
1 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 • 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2004, 2005 2452040 Rev. 12/19/05 INSTALLATION/OPERATION MANUAL SATELLITE SYSTEM MODEL LP-1000 Made in U.S.A. U.S. Patent Pending ...
-
Winegard LP-1000 - page 2
2 Disclaimer Although every ef fort has been made to insure the information in this manual is correct and complete, no company shall be held liable for any errors or omissions in this manual. All information contained in this manual is subject to change without notice. No warranty of any kind is made with regard to the information included in this ...
-
Winegard LP-1000 - page 3
3 1. Intr oduction ........................................................................................................................... 4 1.1 System Overview ............................................................................................................ 4 1.2 Parts Provided with RoadT rip LP ..................................... ...
-
Winegard LP-1000 - page 4
4 1. INTRODUCTION 1.1 System Overview The W inegard RoadT rip LP is a low profile, in-motion satellite system. RoadT rip LP utilizes GPS (global positioning system) and DVB (digital video broadcasting) technology . GPS is used to determine the present location of your antenna, and DVB is used to verify the antenna has located the correct satellite. ...
-
Winegard LP-1000 - page 5
5 2.2 Operational Safety: RoadT rip LP is capable of advanced on-road television satellite tracking. Satellite tracking systems are designed for reception of television programming while the vehicle is in motion and should only be used or operated by vehicle passengers while the vehicle is in motion. Antenna systems and associated equipment should ...
-
Winegard LP-1000 - page 6
6 3. INST ALLA TION 3.1 Installation Overview: 1. Gather the tools and materials required for installation 2. Unpack and inspect RoadT rip LP 3. Select a location to mount the antenna. . 4. Mount the antenna system 5. Adjust the antenna switch settings 6. Route and connect coax and wires. 3.2 T ools and Material Requir ed for Installation : 1. Dril ...
-
Winegard LP-1000 - page 7
7 If the height of the obstruction on the roof is 6 inches, the antenna should be mounted no closer than 18 inches from the obstruction. If the obstruction is higher than 6 inches, you should add an additional 10 inches in distance for every additional 3 inches in height. Obstruction Height Clearance distance 6"…………………………? ...
-
Winegard LP-1000 - page 8
8 3.5 Mounting the Antenna Hardware Kit: 1. Cable ties .............................................................. 2 2. Rocker switch ....................................................... 1 3. Surface mount box screw , #6 x 1/2 ...................... 2 4. W allplate, surface mount screw #6-32x1, white .. 2 5. Surface mount screw , #6 x 3/4, wh ...
-
Winegard LP-1000 - page 9
9 Fig 3.6 Sat. Rcvr. Mount Option Switch Set Position 1 2 34 5 6 7 8 DISH NETWORK ................. A ...................... 0 ... 0 ..... 0 .... 1 .... 0 .. 0 . . 1 .. 1 DISH NETWORK ................. B ...................... 1 .... 0 .... 0 .... 1 .... 0 .. 0 ... 1 .. 1 DIRECTV ............................. A ...................... 0 .... 0 ..... ...
-
Winegard LP-1000 - page 10
10 Using a 7/16" wrench, attach the weather-protected F-connec- tor to the feed-through coming from the dome. First, hand-tighten the connector onto the feed-through until it seats into the rubber seal. Using one 7/16" wrench to hold the center of the feed-through, lightly tighten the F-connector to the feed-through using the other 7/16&q ...
-
Winegard LP-1000 - page 11
11 T rim coax cable if necessary and strip RG-6 coax in- side the vehicle, illustration at right. Attach the provided F-connector to end of the coax and crimp connector . Connect the coax cable to the “Satellite In” connec- tion on satellite receiver , Fig 3.9 . Follow instructions provided with your satellite receiver to connect your televisio ...
-
Winegard LP-1000 - page 12
12 4. OPERA TION 4.1 Initial Satellite Receiver Setup It is very important to set up the satellite receiver for proper antenna operation. Receiver hardware and software varies, depending on manufacturer . If you have a new receiver or you have removed your satellite receiver from the vehicle, it may be necessary to repeat the satellite receiver set ...
-
Winegard LP-1000 - page 13
13 After the unit has acquired GPS, it will lower the reflector to the proper elevation for a satellite search in your location. As the unit scans the proper elevation, it will locate satellite signals. The antenna will return to a scanned satellite location and verify the satellite’ s DVB identification. If it is the correct satellite, the anten ...
-
Winegard LP-1000 - page 14
14 Appendix A Satellite Coverage Maps and Receiver Compatability A.1 DISH NETWORK The RoadT rip LP will operate with most standard DISH Network receivers. The antenna will continually track satellite 1 19 and will function while stationary with satellites 1 19 and 1 10. The RoadT rip LP will not operate with DISH Network HDTV receivers or with any ...
-
Winegard LP-1000 - page 15
15 A.2 DIRECTV RoadT rip LP will operate with most standard DIRECTV receivers. The antenna will continually track satellite 101 and will function while stationary with satellites 101 and 1 19. RoadT rip LP will not operate with DIRECTV HDTV receivers or on any other DIRECTV satellites other than 101 and 1 19. W inegard does not recommend using sate ...
-
Winegard LP-1000 - page 16
16 Appendix B Setup and Operation of Satellite Receivers B.1 DISH Network (T o activate your DISH Network receiver , call 1-888-ADD-DISH). Using your DISH Network Point Dish/Signal Scr een There are several applications where it is necessary and helpful to use the DISH Network Point Dish/Signal Screen. See Fig B.1.1 . The following instructions wil ...
-
Winegard LP-1000 - page 17
17 Using your DISH Network Receiver for Multidish Operation T o set your receiver to automatically switch from satellite 1 19 to satellite 1 10 in stationary mode, use the following instructions: In stationary position, be sure you have a clear view of satellites 1 19 and 110. Go to “Point Dish/Signal” screen and select the 1 19 satellite. T ur ...
-
Winegard LP-1000 - page 18
18 B.2 DIRECTV (T o activate your DIRECTV r eceiver , call 1-888-238-7177) There are many manufacturers of DIRECTV Receivers. These instructions are for use with common menus found in most DIRECTV Receivers. If they dif fer from your receiver , follow instructions provided with your receiver . Set up your DIRECTV Receiver Dish Select “Menu” on ...
-
Winegard LP-1000 - page 19
19 Appendix C. Maintenance and T r oubleshooting Maintenance It is advisable to perform monthly maintenance on your antenna. Clean of f bugs and dirt on the outside of radome using mild soap and water; treat radome with ProtectAll*. Check fasteners on radome, antenna and antenna mounting brackets and tighten if necessary . Be sure cables and wiring ...
-
Winegard LP-1000 - page 20
20 Specifications Frequency Band ........................... 12.2 to 12.7 GHz Elevation Scan Range ...... 17 degrees to 63 degrees relative to the horizon Azimuth Scan .......................................... Continous T racking V elocity ....................... 45 degrees/second Length ............................................................ ...
У вас вопрос, касающийся Winegard LP-1000?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Winegard LP-1000, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Winegard LP-1000 со всей вероятностью он захочет поделиться методом ее решения.