-
Jonsered LT2220 CMA2 - page 1
Operator's Manual L T2220 CMA2 02764 ...
-
Jonsered LT2220 CMA2 - page 2
2 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAP ABLE OF AMPUT A TING HANDS AND FEET AND THROW ING OBJECTS. F AILURE TO OBSERVE THE FOLL OWING SAFETY INSTRUCTIONS COULD RESUL T IN SERIOUS INJURY OR DEA TH. I. GENERAL OPERA TION • Read, understand, and follow all instructions on the machine and in the ...
-
Jonsered LT2220 CMA2 - page 3
3 SAFETY RULES Safe Operation Practices for Ride-On Mowers • Be sure the area is clear of bystanders before operat- ing. Stop machine if anyone enters the area. • Never carry passengers. • Do not mow in reverse unless absolutely necessary . Al ways look down and behind before and while backing. • Never carry children, even with the blades s ...
-
Jonsered LT2220 CMA2 - page 4
4 CONGRA TUL A TIONS on your purchase of a new tractor . It has been designed, engineered and manu fac tured to give you the best possible dependability and per for mance. Should you experience any problem you cannot easily remedy , please contact your nearest authorized service center . We have competent, well-trained tech ni cians and the proper ...
-
Jonsered LT2220 CMA2 - page 5
5 UNAS SEMBLED P ARTS Steering Seat Keys (2) Keys Slope Sheet (1) Oil Drain T ube F or F uture Use Steering Wheel Adapter Steering Wheel Insert Steering Boot (1) Steering Wheel (1) Flat W asher (1) Locknut (1) W asher (1) Seat (1) Knob ...
-
Jonsered LT2220 CMA2 - page 6
6 AS SEMBL Y Y our new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. T o ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely . Use the correct tools as necessary to ensure proper tightness. A TT ACH STEERING WHEEL (See Fig. ...
-
Jonsered LT2220 CMA2 - page 7
7 AS SEMBL Y INST ALL SEA T (See Fig. 3) Adjust seat before tightening adjustment knob. • Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor . • Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard. • Place seat on seat pan so h ...
-
Jonsered LT2220 CMA2 - page 8
8 Fig. 4D NOTE: The strap hook must go through the discharge chute only . Do not allow the hook to enter the slot in the tractor back plate. This will allow the dis charge chute to float with the mower deck when moving on uneven terrain. 02306 HOOK BACKPL A TE SL OT DIS CHARGE CHUTE Fig. 5A TO ASSEMBLE BAGGER (See Figs. 5A-5C) • Unfold bag by piv ...
-
Jonsered LT2220 CMA2 - page 9
9 AS SEMBL Y TO ASSEMBLE AND INST ALL MULCHER PLUG (See Fig. 8) • Remove spring retainer and pin from handle. • Insert plug into handle. Make sure that the letter "A" on both the plug and handle are on the same side and that they can both be seen from the top when laying on the ground. • Secure with pin and retainer spring provided. ...
-
Jonsered LT2220 CMA2 - page 10
10 OPERA TION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) OVER TEMP LIGHT KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FORWARD FAST SLOW ENGINE ON ENGINE OFF OIL PRESSURE ...
-
Jonsered LT2220 CMA2 - page 11
11 OPERA TION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Our tractors conform to the applicable safety standards of the American Nat ...
-
Jonsered LT2220 CMA2 - page 12
12 OPERA TION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while op- erating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. HOW TO USE ...
-
Jonsered LT2220 CMA2 - page 13
13 OPERA TION TO OPERA TE ON HILLS WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills. • If stopping is absolutely necessary , push clutch/brake pedal quickly to brake position and engag ...
-
Jonsered LT2220 CMA2 - page 14
14 Fig. 14 TOWING CARTS AND OTHER A T T ACH MENTS T ow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor . Use common sense when towing. T oo heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor . OPERA T ...
-
Jonsered LT2220 CMA2 - page 15
15 OPERA TION TO ST ART ENGINE (See Fig. 9) When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. • Be sure freewheel control is in the transmission en gaged position. • Sit on seat in operating position, depress clutch/brake pedal and set par ...
-
Jonsered LT2220 CMA2 - page 16
16 OPERA TION 02207 Fig. 15 TO DUMP BAGGER (See Fig. 15) Y our tractor is equipped with a Dump Bag Alarm. T o turn off the alarm disengage the attachment clutch switch. • P osition tractor in location you wish to dump bag ger . • Place motion control lever in Neu tral po si tion and set parking brake. • Raise dump handle to its highest positi ...
-
Jonsered LT2220 CMA2 - page 17
17 MULCHING MOWING TIPS IMPORT ANT : FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUIL T -UP GRAS S AND TRASH. CLEAN AFTER EACH USE. • The spe cial mulch ing blade will recut the grass clip- pings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass ...
-
Jonsered LT2220 CMA2 - page 18
18 MAINTENANCE LUBRICA TION CHART ➀ General Purpose Grease ➁ Refer to Maintenance “ENGINE” Section IMPORT ANT : DO NOT OIL OR GREASE THE PIVOT POINTS WHICH HA VE SPECIAL NYL ON BEARINGS. VISCOUS LU BRI CANTS WILL A TTRACT DUST AND DIRT THA T WILL SHORT EN THE LIFE OF THE SELF-L U BRI CA T ING BEARINGS. IF YOU FEEL THEY MUST BE L U BRI CA T ...
-
Jonsered LT2220 CMA2 - page 19
19 MAINTENANCE Fig.21 Fig.20 5 ST AR P A TTERN BL ADE The center of this blade has a five (5) star pattern. The bolt that attaches this blade has nor mal Right Hand threads that loosens by turn ing ( ) counterclockwise and tight ens by turning ( ) clockwise. BL ADE CARE (See Figs.20-22) For best results mower blades must be kept sharp. Replace bent ...
-
Jonsered LT2220 CMA2 - page 20
20 6 ST AR P A TTERN BL ADE The center of this blade has a 6 star pattern. The bolt at- tach ing this blade has Left Hand threads that loosens by turning ( ) clockwise and tight en by turning ( ) coun ter - clock wise. Fig. 22 LH BL ADE BOL T LEFT HAND THREADED L OCK WASHER FL A T WASHER BL ADE MANDREL ASSEMBL Y 6 ST AR P ATTERN 6 ST AR CENTER HOLE ...
-
Jonsered LT2220 CMA2 - page 21
21 Fig. 23 TO CHANGE ENGINE OIL (See Fig. 23) Determine temperature range expected before oil change. All oil must meet API service classification SG-SL. • Be sure tractor is on level surface. • Oil will drain more freely when warm. • Catch oil in a suitable container . • Remove oil fill cap/dipstick. Be careful not to allow dirt to enter t ...
-
Jonsered LT2220 CMA2 - page 22
22 SERVICE AND ADJUSTMENTS TRACTOR TO REMOVE MOWER (See Fig. 25) Mower will be eas i er to re move from the right side of trac- tor . • Place attachment clutch control in “DISENGAGED” po si tion. • Move attachment lift lever forward to lower mower to its lowest position. • Roll belt off clutch pulley . • Disconnect anti-sway bar from ch ...
-
Jonsered LT2220 CMA2 - page 23
23 0 1156 SERVICE AND ADJUSTMENTS 00598 NUT "E" 01268 "D" "D" MANDREL Fig. 28 NUT "F" FRONT LINKS Fig. 29 • If links are not equal in length, adjust one link to same length as other link. • T o lower front of mower loosen nut “E” on both front links an equal number of turns. • When distance “D” ...
-
Jonsered LT2220 CMA2 - page 24
24 SERVICE AND ADJUSTMENTS Fig. 30 TO REPL ACE MOWER BL ADE DRIVE BEL T (See Fig. 30) P ark the tractor on level surface. Engage parking brake. BEL T REMOV AL - • Remove mower from tractor (See “TO REMOVE MOW ER” in this section of this manual). • Remove screws from RH mandrel cover and remove cover . • Remove screws from LH mandrel cover ...
-
Jonsered LT2220 CMA2 - page 25
25 TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer - ing wheel and reassemble per instructions in the Assembly section of this manual. FRONT WHEEL TOE-IN/CAMBER The front wheel toe-in and camber are not adjustable on your tractor . If damage ...
-
Jonsered LT2220 CMA2 - page 26
26 TRANSMISSION REMOVAL/REPL ACEMENT Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor . See “PURGE TRANS MIS SION” in the Operation section of this manual. SERVICE AND ADJUSTMENTS TO REMOVE HOOD AND GRILL ASSEMBL Y (See Fig. 36) • Raise hood. • Uns ...
-
Jonsered LT2220 CMA2 - page 27
27 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any en clo sure. TRACTOR Remove mower from t ...
-
Jonsered LT2220 CMA2 - page 28
28 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly . 2. See “TO ST ART ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air filter . 5. Clean/replace air filter . 6. Dirty fuel filte ...
-
Jonsered LT2220 CMA2 - page 29
29 TROUBLESHOOTING POINTS Engine continues to run 1. F aulty operator -safety presence control system. 1. Check wiring, switches and connections. If not when operator leaves seat corrected, contact an authorized service center/ with attachment clutch department. engaged Poor cut - uneven 1. Worn, bent or loose blade. 1. Replace blade. Tighten blade ...
-
Jonsered LT2220 CMA2 - page 30
30 SERVICE NOTES ...
-
Jonsered LT2220 CMA2 - page 31
31 15 DEGREES MAX. FOLD ALONG DOTTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mow slopes greater than 15 degrees. Make turns gradually to preven ...
-
Jonsered LT2220 CMA2 - page 32
532 41 02-74 Rev . 4 05.12.09 SR Printed in the U.S.A. Jonsered Motor AB, S-433 81 P artille, Sweden. ...
У вас вопрос, касающийся Jonsered LT2220 CMA2?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Jonsered LT2220 CMA2, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Jonsered LT2220 CMA2 со всей вероятностью он захочет поделиться методом ее решения.