-
Jura Capresso F90/F9 - page 1
IMPRESSA F90/F9 Instructions for use 3/05 Art. Nr. 65382 ...
-
Jura Capresso F90/F9 - page 2
JURA IMPRESSA F90/F9 Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip JURA Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.jura.com ...
-
Jura Capresso F90/F9 - page 3
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 11 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 12 Fig. 9 Fig. 10 Fig. 13 Fig. 14 Fig. 15 1 2 3 Fig. 16 ...
-
Jura Capresso F90/F9 - page 4
7 8 11 12 13 14/15 16 17 18 4 3 2 1 5 6 9 10 19 20 Control elements A) Display dialog system B) Symbols (navigation in programming mode) C) Large cup D) Coffee E) Espresso F) Start (to start the draw-off operation) G) Coffee strength «mild» H) Coffee strength «Normal» I) Coffee strength «strong» 1 Programming key 2 Selection key for pre-groun ...
-
Jura Capresso F90/F9 - page 5
5 Contents JURA IMPRESSA 1. Description of control panel .............................. page 6 2. Safety information .......................................... page 6 2.1 Warning ................................................. page 6 2.2 Precautions ............................................. page 6 2.3 Power Switch ............................ ...
-
Jura Capresso F90/F9 - page 6
6 Important information Thank you very much for purchasing this IMPRESSA coffee machine. Before using your new coffee machine for the first time, carefully read this operating manual and keep it for future reference. Should you need more information or if you meet with particular problems not specified in these operating instructions in sufficient ...
-
Jura Capresso F90/F9 - page 7
7 2.3 Power switch Actuate the power switch (21) on your IMPRESSA before using the machine for the first time. We recommend that you switch off your IMPRESSA with the power switch (21) if you intend not to use the machine for longer periods of time (e.g.during holidays) 3. Preparing the coffee machine for use 3.1 Check the mains voltage The coffee ...
-
Jura Capresso F90/F9 - page 8
8 WWW.IMPRESSA-F-LINE.COM HELLO, MACHINE HEATING UP FILL SYSTEM / WATER PORTION Place an empty cup under the hot water jet (15). Press water portion draw-off key SYSTEM FILLING MACHINE HEATING UP PRESS MAINTENANCE MACHINE RINSING PLEASE SELECT Press symbol . COFFEE NORMAL If FILL BEANS is displayed, t ...
-
Jura Capresso F90/F9 - page 9
9 Press symbol until the following message is displayed: WATER HARDNESS 3 Press symbol , you will hear an acoustic signal and the hardness degree flashes. Now, press symbols to adjust the required hardness degree. Press symbol to confirm the new settings. WATER HARDNESS 4 Press programming key to leave Programming Mode. ...
-
Jura Capresso F90/F9 - page 10
10 FILTER RINSING. The water draw-off operation is stopped automatically. MACHINE HEATING UP PLEASE SELECT 7. Rinsing the coffee machine When the coffee machine was switched off and has cooled down in the meantime, a rinsing operation is started when the machine is switched on again. When the machine is switched off, a rinsing operation ...
-
Jura Capresso F90/F9 - page 11
11 MACHINE RINSING PLEASE SELECT Place 1 cup under the adjustable coffee spout (16) and press symbol . LARGE CUP NORMAL Press (/ / ) to select the strength of your coffee. LARGE CUP MILD Press symbol . LARGE CUP MILD Your product is being prepared. PLEASE SELECT 8.3 Drawing off pre-ground coffee Never use instant ...
-
Jura Capresso F90/F9 - page 12
12 PLEASE SELECT Press steam portion draw-off key . MACHINE HEATING UP PLEASE SELECT Place a cup under the 2-stage frothing jet (14) and immerse the frothing aid in the milk to be frothed or the liquid to be heated. Press steam draw-off key again. STEAM PORTION. Your product is being prepared. You can stop the draw-o ...
-
Jura Capresso F90/F9 - page 13
13 11.2 Drawing off cappuccino and hot milk with Professional-Cappuccino Frother Fill the milk container with milk or immerse the hose in the milk directly. Place a cup under the Professional-Cappuccino Frother. Press the steam portion draw off key (13) MACHINE HEATING UP PLEASE SELECT Press the steam portion draw off key (1 ...
-
Jura Capresso F90/F9 - page 14
14 13.1 Programming the filter Refer to Chapter 6.1 «Inserting the filter». 13.2 Programming the water hardness Refer to Chapter 5 «Adjusting the water hardness». 13.3 Programming the aroma INTENSIVE or STANDARD The aroma for the powder quantities ( / / ) was adjusted to Intensive in the factory. If requested it can also be set to Standard. ...
-
Jura Capresso F90/F9 - page 15
15 SELECT PRODUCT Select the product, the water quantity of which you want to programme ( / / ) COFFEE 90 ML Press symbol , the value flashes. Use symbols to change the value in 5 ml increments. Press symbol to save the water quantity for this product. WATER QUANTITY Use the symbols to reach the next programming stag ...
-
Jura Capresso F90/F9 - page 16
16 13.8 Programming the water portion Use the key to switch on the coffee machine. WWW. IMPRESSA-F-LINE.COM HELLO, MACHINE HEATING UP PRESS MAINTENANCE MACHINE RINSING PLEASE SELECT Press programming key until you hear an acoustic signal. Press symbol until the following message is displayed: WATER PORTION Pr ...
-
Jura Capresso F90/F9 - page 17
17 Use the symbols to select the hours and confirm by pressing . Use symbols to adjust the minutes and confirm by pressing . The switch-on time is now programmed. Use the symbols to reach the next programming stage or press programming key to quit Programming Mode. 13.11 Programming the automatic switch-off time You can programme your c ...
-
Jura Capresso F90/F9 - page 18
18 Press symbol , you will hear an acoustic signal and DEUTSCH flashes. Press symbols to select the required language. Press symbol to save the new settings. LANGUAGE ENGLISH Use the symbols to reach the next programming stage or press programming key to quit Programming Mode. 13.14 Connectivity With the Connectivity system it i ...
-
Jura Capresso F90/F9 - page 19
19 14.6 Cleaning the coffee machine After 200 draw-off operations or after 160 rinsing operations, the coffee machine must be cleaned. A message appears on the display, telling you to start the cleaning programme. You can still draw off coffee or hot water/steam. However, we recommend that you should clean the machine (Chapter 15) within the next f ...
-
Jura Capresso F90/F9 - page 20
20 EMPTY TRAY. Take out the tray, empty it and reinstall it. PRESS MAINTENANCE Press maintenance key . MACHINE CLEANING TABLET / PRESS MAINTENANCE (Fig. 6). You will hear an acoustic signal. MACHINE CLEANING EMPTY TRAY. You will hear an acoustic signal. PRESS MAINTENANCE MACHINE CLEANING EMPTY TRAY. You will ...
-
Jura Capresso F90/F9 - page 21
21 PRESS MAINTENANCE / REFILL WATER MACHINE DE-SCALING The water comes out of the hot water jet in intervals. After some intervals the water is discharged directly in the drip tray. EMPTY TRAY. You will hear an acoustic signal. PRESS MAINTENANCE MACHINE RINSING: PLEASE SELECT After the de-scaling, clean the aluminium fro ...
-
Jura Capresso F90/F9 - page 22
22 19. Messages Cause Remedy REFILL WATER Water tank is empty. Refill water Float defective Rinse or de-scale water tank REFILL BEANS Bean tank is empty. Refill beans Although you have refilled beans, Draw off a cup of coffee. the message still appears. The message will disappear only after you have drawn off a cup of coffee EMPTY COFFEE Coffee gro ...
-
Jura Capresso F90/F9 - page 23
23 20. Problems Problem Cause Remedy Very loud noise coming Foreign body in grinding gear Drawing off pre-ground coffee is still possible from the grinding gear Have machine checked by JURA Service Too little froth when 2-stage frothing jet blocked Clean 2-stage frothing jet frothing milk 2-stage frothing jet in wrong position Draw off steam (Chapt ...
-
Jura Capresso F90/F9 - page 24
24 22. Technical Data Voltage: 230V AC Power: 1450 W Fuse: 10 A Safety check: Energy consumption Standby: approx. 3.5 Wh Energy consumption «Ready for draw-off»: approx. 11.5 Wh Pump pressure: static max. 15 bar Water tank: 1.9 litres Bean tank capacity: 200gr. Coffee grounds container capacity: max. 16 portions Length of mains cable: approx. 1.1 ...
У вас вопрос, касающийся Jura Capresso F90/F9?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Jura Capresso F90/F9, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Jura Capresso F90/F9 со всей вероятностью он захочет поделиться методом ее решения.