-
Autostart AS-1725 SH - page 1
AUTOMATIC TRANSMISSION REMOTE STARTER AS-1725 SH Installation Guide Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either damage to the vehicle itself o r to the Unit. This Unit must be installed by a certified technician using all safety devices supplied. ...
-
Autostart AS-1725 SH - page 2
P. 2 Installation Guide AS-1725 SH Table of Contents Table of Contents ...................................... 2 Introduction ................................................ 2 Included in the Kit ...................................... 2 Installation Points to Remember ................ 3 Harness Description .................................. 4 Flash ...
-
Autostart AS-1725 SH - page 3
AS-1725 SH Installation Guide P. 3 x 1 – User Guide The plug-in Valet button is not included with t his Remote Car Starter. INDUSTRY CANADA USER NOTICE: Operation is subject to th e following tw o conditions: (1) this device may not cause interference, and (2) this devic e must accept any interference, including i nterference that may cause undes ...
-
Autostart AS-1725 SH - page 4
P. 4 Installation Guide AS-1725 SH Wiring a Clutch Bypass and a Transponder Module to the GROUND OUT WHEN RUNNING wire: At the junctio n point, where the GROUND OUT WHEN RUNNING wire “splits” and connects to each device, a diode is inserted on each of these lines. Multiple or separate Door pin C onnec- tions: When joining all Door Pins togeth e ...
-
Autostart AS-1725 SH - page 5
AS-1725 SH Installation Guide P. 5 This wire will power the Heater Blower Motor. Usually connected to the Accessories wire of the vehicle. The source wire must have power with the Ignition Key in the IGNITION ON (RUN) position only ( no power in the CRANK position). E ORANGE (+) Accessories output (30 A) Warning: at the Ign ition Switch of certain ...
-
Autostart AS-1725 SH - page 6
P. 6 Installation Guide AS-1725 SH 12-Pin Accessories Harness Wire Colour Function Description 1 BLUE (–) Trunk / AUX 3 output 500 mA negative output. This output can be used to control the Trunk release (1-sec. pulse), or it can be set to operate as a constant output as long as the TRUNK button is held pressed (for Sunroof or Window closure) 2 B ...
-
Autostart AS-1725 SH - page 7
AS-1725 SH Installation Guide P. 7 9 PURPLE (–) External Trigger The External Trigger wire can be used for remote-starting the vehicle with an external device. When the vehicle is running, triggering this input will activate Idle Mo de. The External Trigger wire can also be used to operate as a negative trigger with the Trunk Pin-switch, the Key ...
-
Autostart AS-1725 SH - page 8
P. 8 Installation Guide AS-1725 SH 12 YELLOW (+) Glow-Plug input In Diesel Mode, this positive input will monitor the Glow Plug Light: it will wait for up to 18 seconds until the Glow-plug Light goes out before allowing the Remote Car Starter to proceed to cranking the Engine. Connect to the side of th e Glow-plug Light which is positive when the L ...
-
Autostart AS-1725 SH - page 9
AS-1725 SH Installation Guide P. 9 2-Pin Harness Wire Colour Function Description 1 BLUE/ WHITE (–) N/A This pin is not used. Leave it empty. 2 YELLOW (–) Parking Light output 500 mA negative Parking Light output Note: Ensure that the voltage does not vary when the dimmer control switch is turned up or down. If this is the case, it is not the r ...
-
Autostart AS-1725 SH - page 10
Remember: Once the Parking Lights are ON (solid), you have up to 20 seconds to selec t a sub-menu. If you do not select a sub-menu within 20 seconds, the Remote Car Starter will exit Programm ing Mode and you will have to flash th e Hood Pin switc h once again. The Programming Assistance Button (A.k.a. the PAB .) Mounted on the Rem ote Car Starter, ...
-
Autostart AS-1725 SH - page 11
AS-1725 SH Installation Guide P. 11 To program a Transmitter on the second vehicle for Multi-car Operati on, you must press the TRUNK and LOCK buttons simultaneously (instead of LOCK or UNLOCK ) in ste p 2 of the Transmitter code-learning procedure: Entering Programming Options Mode The Remote Car Starter is equipped with three custom programming M ...
-
Autostart AS-1725 SH - page 12
P. 12 Installation Guide AS-1725 SH Programming Options MODE 1 * INDICATES DEFAULT SE TTING FUNCTION 1 – Ignition-controlled Door Locks OPTION 1* Ignition Lock DISABLED OPTION 2 Ignition Lock ENABLED OPTION 3 Ignition UNLOCK ONLY OPTION 4 Ignition LOCK ONLY FUNCTION 2 – Secure Lock OPTION 1* Secure Lock DISABLED (1-sec. Disarm pulse) OPTION 2 S ...
-
Autostart AS-1725 SH - page 13
AS-1725 SH Installation Guide P. 13 OPTION 2* Ignition Valet ENABLED OPTION 3 Ignition Valet ENABLED MODE 3 * INDICATES DEFAULT SE TTING FUNCTION 1 – Home Valet TM OPTION 1 Home Valet ENABLED OPTION 2* Home Valet DISABLED OPTION 3 Home Valet DISABLED FUNCTION 2 – AUX 3 / Zone 3 Programmin g OPTION 1 1-sec. output when TRUNK button is pressed fo ...
-
Autostart AS-1725 SH - page 14
P. 14 Installation Guide AS-1725 SH of certain Ignition systems are sometimes too low or too hi gh for the Remote Car Starter, causing failed start-ups at var ious temper atures. 1. Flash the Hood Pin switch (see Table 1) – The Parking Lights will stay ON for up to 20 seconds. – Before the lights go out: 2. Press and hold the Brake Pedal , – ...
-
Autostart AS-1725 SH - page 15
AS-1725 SH Installation Guide P. 15 a. To increase the H orn pulse by 3 ms, press the LOCK button. b. To decr ease the p ulse by 3 ms, pr ess the UNLOCK butto n. c. To increase the pulse by 10 ms, pr ess the START or STOP button. d. To decrease the pulse by 10 ms, press the TRUNK button. 5. To save the new settings: press LOCK and UNLOCK . If 3 chi ...
-
Autostart AS-1725 SH - page 16
Closing Up Use tie-wraps or screws to properly secure the Remote Car Starter and kee p the wiring away from any moving parts such as the Parking Brake s or Steering Column S hafts. Mount all sw itches in good and acces sible locations where they do not ri sk getting kic ked or hit accidentally. Most comebacks are the res ult of misunders tandings a ...
-
Autostart AS-1725 SH - page 17
AS-1725 SH Installation Guide P. 17 Secure Lock This feature allows the Remote Car Starter to control certa in OEM factory Alarm systems without requiring the use of oth er wires for disarming the OEM Alarm. (Namely, this featu re is designed for OEM systems which use the factory Lock wire to arm the Alarm and the Unlock wire to disarm it.) Standar ...
-
Autostart AS-1725 SH - page 18
P. 18 Installation Guide AS-1725 SH x Active Arming : the Starter Kill will not arm autom atically. Press the LOCK button t o arm and the UNLOCK button to disarm it. x Passive Arming: the S tarter Kill will arm automatic ally if it is not armed by remot e within a 60-sec. delay. Press UNLOCK to disarm. x Passive Arming with 3- minute timeout: th e ...
-
Autostart AS-1725 SH - page 19
AS-1725 SH Installation Guide P. 19 Start Failure Codes through the Parking Lights 1 x = No Start 3 x = Hardware Reset 4 x = Brakes 5 x = No Tach Cut-off 6 x = Hood 7 x = Engine Running, no Ignition det ected, or Tach before St art Note : “ x ” stands for one flash of th e Parking Lights Diagnostics – Parking Light Flash Table Flashes Descrip ...
-
Autostart AS-1725 SH - page 20
P. 20 Installation Guide AS-1725 SH Constant flashes up to 30 sec. x Panic Mode is triggered. ...
У вас вопрос, касающийся Autostart AS-1725 SH?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Autostart AS-1725 SH, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Autostart AS-1725 SH со всей вероятностью он захочет поделиться методом ее решения.