-
DCS BGB131-BI - page 1
THE PROFESSIONAL SIDE BURNER Use a nd Ca re Guide MODELS: BGB131 BGB132 BGB131-BI BGB132-BI ...
-
DCS BGB131-BI - page 2
1 A MESSA GE T O OUR CUST OMERS We are glad that you selected the Professional Side Burner by DCS. Because this appliance c ontains features not found on any other burner , we recommend that you read this entire booklet before your first use . Keep it in a handy place as it has answers to questions that may occur during future use. F eel free to co ...
-
DCS BGB131-BI - page 3
TA B L E O F CO N T ENTS 2 SAFET Y PRACTICES AND PRECA UTIONS ..................................................................................................3-4 SIDE BURNER 131/132 SIDE MOUNT MODEL INST ALLA TION ...................................................4-5 SIDE BURNER BUIL T-IN MODEL INST ALLA TION .................................... ...
-
DCS BGB131-BI - page 4
3 SAFET Y PRACTICES & PRECA UTIONS Improper use or installation is dangerous. Car efully follow these instructions. Always remov e the cover bef ore lighting the Prof essional Side Burner . Never use the Side Burner if a leak is present. Do not use a flame to check for gas leaks. Do not let children use the Prof essional Side Burner ...
-
DCS BGB131-BI - page 5
INST ALLA TION OF SIDE BURNER: All BGB131 and BGB132 models can be installed in c ombustible enclosure with zero clear ance from the back, sides and bottom. A minimum of 6” from the back and sides must be maintained from the Pr ofessional Side Burner above the cooking sur face and a minimum of 1” below the co oking sur face to combustible const ...
-
DCS BGB131-BI - page 6
5 SIDE BURNER 131/132 SIDE MOUNT MODEL INST ALLA TION 2 " 23- 3/4" 10-3/8" 26- 3/4" 12- 3/4 " 2 " 15 -3 / 4 " Standard construction 13-1/8" 10 - 1/4" 2" X 2" opening for gas supply line A MODEL A BGB131 12-7/8" BGB132 23-7/8" 10-3/8" REAR FRONT IGNITION IGNITION BURNER 13 " ...
-
DCS BGB131-BI - page 7
SIDE BURNER BUIL T-IN MODEL INST ALLA TION 6 INST ALLA TION OF SIDE BURNER BUIL T-IN: All BGB131-BI and BGB132-B I models can be installed in combustible enclosure with zero clearance from the back, side and bottom. A minimum of 6” from the back and sides must be maintained from the Pr ofessional Side Burner above the cooking sur face to combusti ...
-
DCS BGB131-BI - page 8
7 SIDE BURNER BUIL T-IN MODEL INST ALLA TION 22- 1/8" 2 " 25- 1/2" 10-1/16" 25- 1/2" 11- 3/4" 2 " 14 -3 / 4 " Single Side Burner Dual Side Burner Standard construction 12" 10- 1/16" 2" X 2" opening for gas supply line A MODEL A BGB131-BI 12" BGB132-BI 22-3/8" 10-1/16" note: ...
-
DCS BGB131-BI - page 9
8 GAS REQUIREMENTS GAS REQUIREMENTS: Ve rify the type of gas supply to be used, either natural or LP . Make sure the marked gas on the appliance rating plate(s) and hook-up kit agrees with that of the supply . Never c onnect an unregulated gas line to the appliance. An installer supplied gas shut-off valve must be installed in an easily acc essible ...
-
DCS BGB131-BI - page 10
9 GAS REQUIREMENTS LP T ANK REQUIREMENTS A dented or rusty LP tank may be hazardous and should be checked by y our LP supplier . Never use a cylinder with a damaged valve . T he LP gas cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Depar tment of T ransportation (DOT ) and desi ...
-
DCS BGB131-BI - page 11
10 LEAK TESTING & LIGHTING INSTRUCTIONS WA R N ING: Do not sm oke while leak testing . Extinguish all open flames. Ma ke a soap solution of one par t liquid detergent, and one par t water . Never test for leaks with an open flame. F or LP units, check with a full cylinder . Make sure all control valv es are in the “OFF” position. T urn the ...
-
DCS BGB131-BI - page 12
11 LIGHTING INSTRUCTIONS MA TCH LIGHTING Hold a fireplace lit match near the burner ports, turn the control knob counterclockwise to “HI” .M o v e y our hand immediately once the burner is lit. Rotate the control k nob to the desired setting . Note: If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds ...
-
DCS BGB131-BI - page 13
12 FINAL CHECKLIST Specified clearances maintained to combustibles . Pr ofessional Side Burner is properly mounted . All internal packaging removed . Burner is seated properly and does not rock. Each burner lights satisfactorily , individually or with adjacent burner lit. K nob(s) turn freely . Bezel(s) centered . F lame ...
-
DCS BGB131-BI - page 14
13 GENERAL CLEANING BURNERS Fo r proper lighting and performance k eep the burners clean. I t is necessary to clean the burners if they do not light even though the igniter clicks , if there has been a severe boil o ver , or when the flame does not burn blue. B e cer tain all burner knobs are in the off position before attempting t o clean the burn ...
-
DCS BGB131-BI - page 15
14 TROUBLESHOO TING Burner won ’t light when the ignition is pushed. Burner flame is yellow or orange , in c onjunction with the odor of gas. Lo w heat with k nob in “HI” position. Remove the burner grat e. With the control knob in the “OFF” position, listen to the electrode while engaging the ignition. Y ou should hear a spark jump insid ...
-
DCS BGB131-BI - page 16
15 SINGLE SIDE BURNER P ARTS LIST FOR BGB131 & BGB131-BI NO TE: P art list t ypical for BGB131 & BGB131-BI models . Illustration sho ws BGB131-BI model. ITEM DESCRIPTION P ART NO. 1B URNER C OVER 33316 2P ULL HANDLE 18204-01 3R UBBER BUMPER 18403 4T OP GRA TE BK 12020 5D BURNER CAP 12272 6P ORT RING ASSEMBL Y 12333 7 VENTURI 12332 8B ASE D ...
-
DCS BGB131-BI - page 17
16 DOUBLE SIDE BURNER P ARTS LIST FOR BGB132 & BGB132-BI NO TE: P art list t ypical for BGB132 & BGB132-BI models . Illustration sho ws BGB132-BI model. ITEM DESCRIPTION P ART NO. 1B URNER C OVER 33299 2P ULL HANDLE 18204-01 3R UBBER BUMPER 18403 4T OP GRA TE BK 12013-1 5D BURNER CAP 12272 6P ORT RING ASSEMBL Y 12333 7 VENTURI 12332 8B ASE ...
-
DCS BGB131-BI - page 18
17 SINGLE & DOUBLE SIDE BURNER WIRING DIA GRAM SP ARK ELECTRODE (P/N 12224) SP ARK ELECTRODE (P/N 12224) SINGLE SIDE B URNER DOUBLE SIDE B URNER 1.5 VOL T ALKALINE BA T TERY P/N 16567) GND TERMINAL TERMINAL NO TE: HIGH VOL T A GE A T TERMINALS (Switch is built into module) (Switch is built into module) SP ARK ELECTRODE (P/N 12224) BA T TERY IGN ...
-
DCS BGB131-BI - page 19
18 WA R R A N T Y LENGTH OF W ARRANT Y DCS warrants all other Side Burner components parts and labor to the original purchaser to be free of factor y defects in material and workmanship for a period of one (1) y ear from the original date of purchase. This does not apply if the unit was subjected to other than normal residential use. Limited F ive ...
-
DCS BGB131-BI - page 20
19 SERVICE HOW T O OBT AIN SERVICE: F or warranty ser vice, please contact your local service provider or DCS Customer Car e Center at (888) 281-5698, Monday thru Frida y , 6 am- 4:30 pm PST . Before y ou call, please hav e the following information ready: Model Number (located on the inside of the left side of the appliance) Se rial Number ...
-
DCS BGB131-BI - page 21
NO TES 20 ...
-
DCS BGB131-BI - page 22
21 Pa rt No. 17712 Rev. B Litho in USA 03/2004 As product improvement is an ongoing pr ocess at DCS, we r eserve the right to change specifications or design without notice. 5800 Skylab Road, Huntington Beach, CA 92647 T el: 714.372.7000 • Fax: 714.372.7001 C ustomer Service: (888) 281.5698 www .dcsappliances.com ...
У вас вопрос, касающийся DCS BGB131-BI?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с DCS BGB131-BI, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с DCS BGB131-BI со всей вероятностью он захочет поделиться методом ее решения.