-
Sears RO 2000 - page 1
WaterWorks TM Undersink Reverse Osmosis HOME DRINKING WATER SYSTEM Model RO 2000 Installation Operation Maintenance Repair Parts IF YOU HAVE QUESTIONS WHEN INSTALLING, OPERATING AND MAINTAINING YOUR REVERSE OSMOSIS SYSTEM... CALL TOLL FREE 1-800-86 WATER System Tested and Certified to ANSI/NSF Standard 58. See performance data sheet for details, Ma ...
-
Sears RO 2000 - page 2
- TABLE OF CONTENTS - Safety Guides ................................................ 2-3 What Your Home Drinking Water System Will Do ..................... 3 Things To Check Before You Start To Install ....................... 4-5 How To Install Your Home Drinking Water System ................. 5-11 How Your Home Drinking Water System Works ........ ...
-
Sears RO 2000 - page 3
- SAFETY GUIDES - DO NOT USE THE SYSTEM ON MICROBIOLOGICALLY UNSAFE WATER, OR WATER OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts. CHECK WITH YOUR LOCAL PUBLIC WORKS DEPARTMENT FOR PLUMBING AND SANITATION CODES. YOU ...
-
Sears RO 2000 - page 4
- THINGS TO CHECK BEFORE YOU START TO INSTALL - • PARTS IN THE SHIPPING CARTON -- Unpack the carton carefully so needed parts are not discard- ed by mistake. Included are: _ _ WATER (_ _ _ t SUPPLY _,/_1 _b') _tl SADDLE VALVE _,,_ --. RO , I ASSEMBLY _ .t _ BATTERY HOLDER _ WITH BATTERIES (4) I ELECTRONIC FAUCET BASE DRAIN ADAPTER £ FAUCET ...
-
Sears RO 2000 - page 5
- THINGS TO CHECK BEFORE YOU START TO INSTALL - REMOTE LOCATION -- You can install the RO assembly or water supply saddle valve in another place away from the RO faucet (please see page 2O). • REPLACING ANOTHER RO SYSTEM -- We suggest you remove all parts of another RO system, and use everything included with your new RO system. - TOOLS AND MATER ...
-
Sears RO 2000 - page 6
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - STEP 1 -- INSTALL THE COLD WATER SUPPLY SADDLE VALVE (FIG. 2) • Install this valve on the COLD water pipe to the kitchen sink (FIG. 2). • This valve has a cutting pin and will make its own hole in copper or plastic pipe. To install on iron pipe, you have to drill a 1/8" diameter hole for t ...
-
Sears RO 2000 - page 7
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - INSTALL THE DRAIN ADAPTER • Use FIG. 3 and the following guides. Note: Consult a plumber if you are not familiar with plumbing procedures• 1. Use a ferrule and nut to assemble the drain tubing connector to the drain adapter. Turn the connector to about 45 ° from the 12:00 position, as shown (t ...
-
Sears RO 2000 - page 8
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - ASSEMBLE FAUCET AND INSTALL - continued B. ASSEMBLE FAUCET (FIG. 4) 1. Remove the hex nut, and all other parts shown in the dotted line box, FIG. 4. 2. Insert the faucet stud through the top gasket and faucet base. Then, replace the hex nut and tighten. DO NOT OVERTIGHTEN AND BREAK THE FAUCET BASE. ...
-
Sears RO 2000 - page 9
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - tighten the nut. NOTE: Cut tubing as needed for neat appearance, but keep long enough to alllow easy service of the RO system. 7. If needed, cut the 1/4" tubing (marked "1/4" BARB ON FAUCET") to length. Then, push the end all the way onto the 1/4" barb fiting on the faucet. ...
-
Sears RO 2000 - page 10
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - MAKE REMAINING RO CONNECTIONS - continued B. CONNECT TUBING, FAUCET TO DRAIN TUB- ING CONNECTOR Looking at FIG. 7 and page 16, run the 3/8" x 27" tubing from the RO faucet, to the connector at the adapter you installed in the sink drain pipe. Cut this tubing as needed to route in as strai ...
-
Sears RO 2000 - page 11
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM - the RO system. At that time, carefully check all fit- tings and tubing connections for any water leaks. Correct leaks if any are found. E. IMPORTANT PURGING INSTRUCTIONS: The RO cartridge contains a food grade preser- vative that you should clean from it before using the system. The preservative wi ...
-
Sears RO 2000 - page 12
- HOW YOUR HOME DRINKING WATER SYSTEM WORKS - POSTFILTER - continued water. High quality drinking water flows from the postfilter and to the faucet. NOTE: Before going to the faucet, product water passes through the electronic box and remaining TDS is measured by a sensor. FAUCET - The sinktop or countertop faucet dispenses the drinking water. It h ...
-
Sears RO 2000 - page 13
- CARE OF YOUR HOME DRINKING WATER SYSTEM - PREFILTER CARTRIDGE - You must replace the prefilter cartridge often to protect the RO mem- brane from being destroyed by chlorine, and/or from plugging with sediments from the water supply. If you have chlorine in the water, replace the cartridge at least every 6 months. If the prefilter cartridge plugs ...
-
Sears RO 2000 - page 14
- CARE OF YOUR HOME DRINKING WATER SYSTEM - RO MEMBRANE CARTRIDGE - The useful life of the membrane cartridge depends mostly on the pH (see page 17) of your supply water. The lower the pH, the longer the membrane will last. For ex- ample, if the feed water has a pH of about 7.0, the cartridge may last for over 1 year; but if the pH is high, cartrid ...
-
Sears RO 2000 - page 15
- CARE OF YOUR HOME DRINKING WATER SYSTEM - 7. Install the RO housing, push downward and rotate 900 clockwise to lock in place. 8. Replace the tank shutoff valve and rotate 900 to lock. 9. Using the o-ring seal, replace the vacuum relief valve. 10. DO THE SANITIZING AND PURGING PRO- CEDURES, PAGE 10. AUTOMATIC SHUTOFF SERVICE If the shutoff assembl ...
-
Sears RO 2000 - page 16
- CARE OF YOUR HOME DRINKING WATER SYSTEM - RO CARE GUIDE MODEL RO 2000 WITH MONITOR IMPORTANT: BEFORE DOING THE FOLLOWING MAINTENANCE, BE SURETO RELIEVE PRESSURE AND ALLOW AIR TO ENTER THE TANK, STEPS 1, 2 AND 3, PAGE 12. t. Replace the prefilter cartridge and postfilter when the amber "FILT" light begins to flash while taking product wa ...
-
Sears RO 2000 - page 17
- DIMENSIONS / SPECIFICATIONS - • =-- 8_ 1/8,,--.-_ 21" Supply water pressure limits ...................................... 40-125 PSI Supply water temperature limits ..................................... 40-100OF Maximum total dissolved solids (TDS) ............................... 2000 PPM Maximum water hardness @ 6.9 pH ................... ...
-
Sears RO 2000 - page 18
- REPAIR PARTS - WaterWorks _ I 1 I O I I HOME DRINKING WATER SYSTEM Undersink Reverse Osmosis MODEL RO 2000 ] I 36 -----_(_ DRAIN I ADAPTER I 35 ---'-'-"_(_;J[ I"'---,_ 5 34 "'"""_ _ 33 .-.----.-_ "_ 37 32 --"--'-_,_ 27 i TO 7 AIRGAR i • 1/4" BARB 24 _ 26 Z 3 "' I ...
-
Sears RO 2000 - page 19
- REPAIR PARTS - WaterWorks TM HOME DRINKING WATER SYSTEM Undersink Reverse Osmosis MODEL RO 2000 KEY NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 PART NUMBER 7205465 1260600 7207734 9043201 7192230 9003204 7131331 7124986 7114509 7116763 7131349 9003203 7011272 7087485 42-34709 9004502 7128702 7118414 0900044 7140869 71 ...
-
Sears RO 2000 - page 20
- REMOTE INSTALLATION LOCATION - INSTALLING RO ASSEMBLY, AND/OR SUPPLY SADDLE VALVE IN REMOTE LOCATION Longer lengths of tubing are available from Sears (see page 19) for installingthe RO assembly, and/or water supply saddle valve away from the RO faucet. Examples: In the basement, under the kitchen or bathroom sink. In a closet or room nearby the ...
У вас вопрос, касающийся Sears RO 2000?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Sears RO 2000, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Sears RO 2000 со всей вероятностью он захочет поделиться методом ее решения.