Bedienungsanleitung AT&T 5635

19 Seiten 0.1 mb
Download

Zur Seite of 19

Summary
  • AT&T 5635 - page 1

    CORDLESS ANSWERING SYSTEM 5635 • I nstallation • Telephone Operation • Memory Dialing • Answering Sy stem • At the Base • Away From the Base Installation Table/De sk Installation 1. Choose a s pot near an electri cal outlet and a tel ephone jack . Your phon e requires a m odul ar telephon e jack and a st andard electrical ou tlet (110v ...

  • AT&T 5635 - page 2

    After th e batteries are charged, pick up the han dset and extend both the handset an d the base anten nas. Now press PHONE on the handset. The PHONE Light sh ould light, and y ou should hear a dial tone. 11. Set Answering System Features. To fully utilize this sy stem you n eed to: a) Set the clock. b) Record an ann ouncem ent. c) Set sys tem to a ...

  • AT&T 5635 - page 3

    sleeve tow ard the screw h ead. Insert the screw s into the holes y ou started. Tighten the screw s u ntil the small en d of the m ountin g sleeve is f lat against th e wall. 11. Connect the telephone line cord. The telephone line cord h as a snap in plug on each end. Inse rt one of the plu gs into th e jack in the rear of the base u nit. Ins ert t ...

  • AT&T 5635 - page 4

    Occasionally , especially wh en y ou pick up the h andset betw een ring s, you may not be conn ected. If this happens, press PHONE on the handset to connect the call. If the han dset rings w hen it’ s out of the base, pick up the han dset, extend the antenn a and press PHONE to answ er the call. Hanging up: To end a call, either place the handset ...

  • AT&T 5635 - page 5

    If y ou try to m ake a call w hen out of ran ge, y ou will h ear two sh ort beeps when y ou press PHONE. Move closer to the base, and press PHONE again to make the call. If y ou receive a call w hile y ou are out of range, the h andset m ight n ot ring – or if it does rin g, the call m igh t not connect w hen y ou press PHONE. Move closer to the ...

  • AT&T 5635 - page 6

    Using the Intercom During a Phone Call First place the call on h old by press ing HOL D. Then use the in tercom. While y ou are usin g the intercom , the Phone Light s on the handset and the base w ill blink to show th at your call has n ot been disconnected. The person on the other end of the phone call w ill not be able to hear y our intercom con ...

  • AT&T 5635 - page 7

    To use the directory card concealed in the back of y our han dset, press the arrow an d slide the door tow ard the top of the handset un til it snaps in place. The directory card has an erasable surface. If you w rite in penc i l, you’ll find it ea s y to c hange names when nece ssa ry. NOTE: If the door slips off the hands et, slide it onto the ...

  • AT&T 5635 - page 8

    Answering System Operation: At The Base About Mai lboxes This answ ering sy stem provides tw o voice m ailboxes. These m ailboxes provide a conv enient w ay to share an answering system with other members o f your househo l d or b usiness. Callers using a touch tone phone can choose the m ailbox in w hich their messag e will be recorded by pressing ...

  • AT&T 5635 - page 9

    Pre-recorded Announcem ent If y ou do not record your ow n announ cemen t, callers will h ear this announ cemen t: “Hello. Please leave a messag e after the tone.” The Message Window blink s to indicate that th e user n eeds to record an ann ouncem ent. To select the pre- recorded announ cemen t as y our annou ncem ent and stop th e display fro ...

  • AT&T 5635 - page 10

    While the sy stem is takin g a call, the Message Window displays “ -.” Af ter a messag e is recorded, the display chang es to show the total nu mber of recorded messages. NOTE: Messa ges are limited to a m axim um of two minutes each. If the caller is still speaking after two minutes , is silent for m ore than 7 seconds, or if system m em ory r ...

  • AT&T 5635 - page 11

    C (steady ) Change funct ion is a ctive C (fol low ed by 0-9) Displ a ying curre nt channel numbe r P Reviewing your anno uncement – OR- Temporary display w hile setting un it: setting indicates you w ill h ear your ann ouncem ent w hen system answers calls S Reviewing your a nno uncement ( no t hear d)-O R- Temporary display w hile setting un it ...

  • AT&T 5635 - page 12

    Saving Messag e s The system saves your m essages automatically if y ou do not delete them. NOTE: T he system can s ave about 12 m inu tes of m essages . When m em ory is full, you m u st delete som e or all of the m essages before any new m essages can be recorded. Deleting Selected Messages To delete only a specifi c mes sage, press an d release ...

  • AT&T 5635 - page 13

    Screening Incoming Calls To screen calls, adjust SPEAKER VOL UME so that you can hear the caller’ s voice. If y ou decide to take a call, either use the cordless handset or lift the h andset of any telephone on the sam e line to talk to the caller. NOTE: If the announcem ent does not stop right away, press PHONE on the cordless handset or press a ...

  • AT&T 5635 - page 14

    If it doesn’t receive any instru ctions in a few seconds, the sy stem w ill autom atically play all of y our messages f or you. First Mailbox 1 follow ed by Mailbox 2. You can allow the sy stem to play y our mes sages, or y ou can u se the n um ber buttons on the hands et to direct the sy stem to perform any of the oth er operations. The labels a ...

  • AT&T 5635 - page 15

    If y ou enter an inv alid code, the system will beep fiv e times. NOTE: If AC power fails and there are no base batteries ins talled, or the batteries are low on power, the Access Code returns to 50. Listen ing to Your Messages • Playing Al l of your Messages Press and release 1 (A LL MSG). The sy stem w ill play all of the m essages and then bee ...

  • AT&T 5635 - page 16

    You can w ork w ith the clock setting an y tim e after the sy stem has given y ou the tw o-beep signal to indicate that it is ready to accept a comm and. Reviewing the Day/ Tim e Setti ng Press and release 8 (CL OCK). The answerin g system w ill announ ce the current day /time settin g and then beep twice to in dicate that it is ready to accept a c ...

  • AT&T 5635 - page 17

    3. Speak into the phone in a n ormal tone of voice. Just as w ith m essages, the sy stem w ill accept m emos up to two minutes in lengt h. 4. To stop recording, pres s and release 5 (S TOP). The mem o is coun ted as a new m essage. Recordin g a Telephone Con versation Once y ou’ve es tablished a conn ection w ith the an sw ering sy stem y ou can ...

  • AT&T 5635 - page 18

    1. Af ter the tw o-beep sig nal w hich indicates that it is ready to accept a comm and, press and release 6 then #. 2. The sy stem beeps once an d “L” w ill be displayed in the Message Window of the base unit. 3. To stop room m oni toring , press and rel ease 5 or ha ng up . Turning the Answering System On or Off You can perform th e operations ...

  • AT&T 5635 - page 19

    If the batteries don’t charge properly The batteries can be recharg ed man y, m any tim es, but if y ou g et a low battery sig nal even after 10 hours of chargin g, the battery pack sh ould be replaced. ! CAUTION: To avoid thee risk of fire and dam age to th e telephone set, u se only AT&T Replacem ent Battery 4051. To purchase replacem ent b ...

Produzent AT&T Kategorie Answering Machine

Dokumente, die wir vom Produzenten des Geräts AT&T 5635 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen AT&T
- Bedienungsanleitungen 5635
- Produktkarten AT&T
- Informationsbroschüren
- oder Energieetiketten AT&T 5635
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung AT&T 5635.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen AT&T 5635, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen AT&T 5635. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts AT&T 5635 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts AT&T 5635, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von AT&T 5635 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von AT&T 5635 verständlich ist.

Eine gänzliche Bedienungsanleitung von AT&T sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von AT&T 5635 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von AT&T 5635 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich AT&T 5635, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts AT&T 5635 - die uns die ersten Schritte während der Nutzung von AT&T 5635 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit AT&T 5635 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von AT&T 5635 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich AT&T 5635?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit AT&T 5635 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit AT&T 5635 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)