-
AT&T 5635 - page 1
CORDLESS ANSWERING SYSTEM 5635 • I nstallation • Telephone Operation • Memory Dialing • Answering Sy stem • At the Base • Away From the Base Installation Table/De sk Installation 1. Choose a s pot near an electri cal outlet and a tel ephone jack . Your phon e requires a m odul ar telephon e jack and a st andard electrical ou tlet (110v ...
-
AT&T 5635 - page 2
After th e batteries are charged, pick up the han dset and extend both the handset an d the base anten nas. Now press PHONE on the handset. The PHONE Light sh ould light, and y ou should hear a dial tone. 11. Set Answering System Features. To fully utilize this sy stem you n eed to: a) Set the clock. b) Record an ann ouncem ent. c) Set sys tem to a ...
-
AT&T 5635 - page 3
sleeve tow ard the screw h ead. Insert the screw s into the holes y ou started. Tighten the screw s u ntil the small en d of the m ountin g sleeve is f lat against th e wall. 11. Connect the telephone line cord. The telephone line cord h as a snap in plug on each end. Inse rt one of the plu gs into th e jack in the rear of the base u nit. Ins ert t ...
-
AT&T 5635 - page 4
Occasionally , especially wh en y ou pick up the h andset betw een ring s, you may not be conn ected. If this happens, press PHONE on the handset to connect the call. If the han dset rings w hen it’ s out of the base, pick up the han dset, extend the antenn a and press PHONE to answ er the call. Hanging up: To end a call, either place the handset ...
-
AT&T 5635 - page 5
If y ou try to m ake a call w hen out of ran ge, y ou will h ear two sh ort beeps when y ou press PHONE. Move closer to the base, and press PHONE again to make the call. If y ou receive a call w hile y ou are out of range, the h andset m ight n ot ring – or if it does rin g, the call m igh t not connect w hen y ou press PHONE. Move closer to the ...
-
AT&T 5635 - page 6
Using the Intercom During a Phone Call First place the call on h old by press ing HOL D. Then use the in tercom. While y ou are usin g the intercom , the Phone Light s on the handset and the base w ill blink to show th at your call has n ot been disconnected. The person on the other end of the phone call w ill not be able to hear y our intercom con ...
-
AT&T 5635 - page 7
To use the directory card concealed in the back of y our han dset, press the arrow an d slide the door tow ard the top of the handset un til it snaps in place. The directory card has an erasable surface. If you w rite in penc i l, you’ll find it ea s y to c hange names when nece ssa ry. NOTE: If the door slips off the hands et, slide it onto the ...
-
AT&T 5635 - page 8
Answering System Operation: At The Base About Mai lboxes This answ ering sy stem provides tw o voice m ailboxes. These m ailboxes provide a conv enient w ay to share an answering system with other members o f your househo l d or b usiness. Callers using a touch tone phone can choose the m ailbox in w hich their messag e will be recorded by pressing ...
-
AT&T 5635 - page 9
Pre-recorded Announcem ent If y ou do not record your ow n announ cemen t, callers will h ear this announ cemen t: “Hello. Please leave a messag e after the tone.” The Message Window blink s to indicate that th e user n eeds to record an ann ouncem ent. To select the pre- recorded announ cemen t as y our annou ncem ent and stop th e display fro ...
-
AT&T 5635 - page 10
While the sy stem is takin g a call, the Message Window displays “ -.” Af ter a messag e is recorded, the display chang es to show the total nu mber of recorded messages. NOTE: Messa ges are limited to a m axim um of two minutes each. If the caller is still speaking after two minutes , is silent for m ore than 7 seconds, or if system m em ory r ...
-
AT&T 5635 - page 11
C (steady ) Change funct ion is a ctive C (fol low ed by 0-9) Displ a ying curre nt channel numbe r P Reviewing your anno uncement – OR- Temporary display w hile setting un it: setting indicates you w ill h ear your ann ouncem ent w hen system answers calls S Reviewing your a nno uncement ( no t hear d)-O R- Temporary display w hile setting un it ...
-
AT&T 5635 - page 12
Saving Messag e s The system saves your m essages automatically if y ou do not delete them. NOTE: T he system can s ave about 12 m inu tes of m essages . When m em ory is full, you m u st delete som e or all of the m essages before any new m essages can be recorded. Deleting Selected Messages To delete only a specifi c mes sage, press an d release ...
-
AT&T 5635 - page 13
Screening Incoming Calls To screen calls, adjust SPEAKER VOL UME so that you can hear the caller’ s voice. If y ou decide to take a call, either use the cordless handset or lift the h andset of any telephone on the sam e line to talk to the caller. NOTE: If the announcem ent does not stop right away, press PHONE on the cordless handset or press a ...
-
AT&T 5635 - page 14
If it doesn’t receive any instru ctions in a few seconds, the sy stem w ill autom atically play all of y our messages f or you. First Mailbox 1 follow ed by Mailbox 2. You can allow the sy stem to play y our mes sages, or y ou can u se the n um ber buttons on the hands et to direct the sy stem to perform any of the oth er operations. The labels a ...
-
AT&T 5635 - page 15
If y ou enter an inv alid code, the system will beep fiv e times. NOTE: If AC power fails and there are no base batteries ins talled, or the batteries are low on power, the Access Code returns to 50. Listen ing to Your Messages • Playing Al l of your Messages Press and release 1 (A LL MSG). The sy stem w ill play all of the m essages and then bee ...
-
AT&T 5635 - page 16
You can w ork w ith the clock setting an y tim e after the sy stem has given y ou the tw o-beep signal to indicate that it is ready to accept a comm and. Reviewing the Day/ Tim e Setti ng Press and release 8 (CL OCK). The answerin g system w ill announ ce the current day /time settin g and then beep twice to in dicate that it is ready to accept a c ...
-
AT&T 5635 - page 17
3. Speak into the phone in a n ormal tone of voice. Just as w ith m essages, the sy stem w ill accept m emos up to two minutes in lengt h. 4. To stop recording, pres s and release 5 (S TOP). The mem o is coun ted as a new m essage. Recordin g a Telephone Con versation Once y ou’ve es tablished a conn ection w ith the an sw ering sy stem y ou can ...
-
AT&T 5635 - page 18
1. Af ter the tw o-beep sig nal w hich indicates that it is ready to accept a comm and, press and release 6 then #. 2. The sy stem beeps once an d “L” w ill be displayed in the Message Window of the base unit. 3. To stop room m oni toring , press and rel ease 5 or ha ng up . Turning the Answering System On or Off You can perform th e operations ...
-
AT&T 5635 - page 19
If the batteries don’t charge properly The batteries can be recharg ed man y, m any tim es, but if y ou g et a low battery sig nal even after 10 hours of chargin g, the battery pack sh ould be replaced. ! CAUTION: To avoid thee risk of fire and dam age to th e telephone set, u se only AT&T Replacem ent Battery 4051. To purchase replacem ent b ...
У вас вопрос, касающийся AT&T 5635?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с AT&T 5635, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с AT&T 5635 со всей вероятностью он захочет поделиться методом ее решения.