Bedienungsanleitung ATEN ATEN MasterView KVM CS-62

16 Seiten 13.84 mb
Download

Zur Seite of 16

Summary
  • ATEN ATEN MasterView KVM CS-62 - page 1

    User Manual CS-62 Read this guide thoroughly and follo w the installation and operation procedures carefully in order to pr event any damage to the units and/or any devices that connect to them. This package contains: M 1 CS-62 Two Port Petite KVM Switch with Attached Cables M 1 User Manual M 1 Quick Start Guide If anything is damaged or mi ssing, ...

  • ATEN ATEN MasterView KVM CS-62 - page 2

    Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec tion against harmful interference in a residential installation. This equipment generat es, uses and can radiate radio frequency energy, and if not instal ...

  • ATEN ATEN MasterView KVM CS-62 - page 3

    Overview The CS-62 Petite KVM Switch Switch is a control unit that allows access to two computer systems from a single console (keyboard, monitor, and mouse). Before the development of the CS-62, the only way to control multiple computer configurat ions from a single console was through a complex and costly network system. Now, with the CS-62 Pet i ...

  • ATEN ATEN MasterView KVM CS-62 - page 4

    Features M One console controls two computers M Compact design features two molded-in KVM (keyboard, video, mouse) cables M Supports Microsoft IntelliMouse and the scrolling wheel on most mice M Easy to install - No software required - connecting cables to the computers is all it takes M Easy to operate - computer selection via hotkeys - auto scan ...

  • ATEN ATEN MasterView KVM CS-62 - page 5

    Hardware Requirements Console M A VGA, SVGA, or Multisync monit or capable of the highest resolution that you will be using on any computer in the installation M A PS/2 Mouse M A PS/2 Keyboard Computers The following equipment must be installed on each computer that is to be connected to the system: M A VGA, SVGA or Multisync card. M A 6-pin mini-D ...

  • ATEN ATEN MasterView KVM CS-62 - page 6

    Front View 1. Port LEDs A LED lights to indicate its corresponding port is the one that has the KVM focus. Depending on the port’s status, the LED may flash according to a specific pattern (see the LED Display Table , p. 8, for details). 2. KVM Cables These 3-in-1 cables connect to the keyboard, video, and mouse ports on the computers you are ins ...

  • ATEN ATEN MasterView KVM CS-62 - page 7

    Installation Refer to the Installation diagram on the next page as you perform the following steps: 1. Plug your keyboard, monitor, and mouse into the appropriate Console ports of the CS-62. Each port is labeled with an appropriate icon to indicate itself. 2. Plug the keyboard, monitor, and mouse connectors of the attached KVM cables into their res ...

  • ATEN ATEN MasterView KVM CS-62 - page 8

    - 6 - 2003-06-20 ...

  • ATEN ATEN MasterView KVM CS-62 - page 9

    Operation The CS-62 Petite KVM Switch uses hotkey combinations to provide KVM focus to the computers. The hotkey combinations allow you to: M Select the Active Port M Invoke Auto Scan Mode M Set the Auto Scan Time Interval Selecting the Active Port You can toggle the KVM focus between the two computers by pressing and releasing the Scroll Lock key ...

  • ATEN ATEN MasterView KVM CS-62 - page 10

    Changing the Scan Interval Before you invoke Auto Scan, you can change the amount of time that Auto Scan dwells on each port (the time interval), wit h the following hotkey combination: [Left shift] [Right shift] [S] [ n ] Where n represents a number from 1 to 4 that specifies the desired scan interval time, as shown in the table below; n Scan Inte ...

  • ATEN ATEN MasterView KVM CS-62 - page 11

    Specifications Function Specification Computer Connections 2 Port Selection Hot Keys LEDs Selected 2 Connectors Keyboard 1 x 6 pin mini-DIN female (PS/2 style) - Console 2 x 6 pin mini-DIN male (PS/2 style) - CPU Ports Mouse 1 x 6 pin mini-DIN female (PS/2 style) - Console 2 x 6 pin mini-DIN male (PS/2 style) - CPU Ports Video 1 x HDB-15 female (st ...

  • ATEN ATEN MasterView KVM CS-62 - page 12

    Troubleshooting Symptom Possible Cause Action Keyboard Not Responding 1 Loose cables. Check all ke yboard cable connections to make sure they are completely seated in their sockets. Keyboard needs to be reset. Unplug the keyboard from the Console Keyboard Port, then plug it back in. Switch needs to be reset Turn off the computers. Unplug the KVM ca ...

  • ATEN ATEN MasterView KVM CS-62 - page 13

    Symptom Possible Cause Action Mouse Not Detected, or Does Not Respond Correctly 2 Switch needs to be reset. Turn off the computers and unplug the KVM cables. Wait five seconds; then plug the cables back in and turn the computers on. Mouse set to Serial Mode. Some mice can be set to act as either a PS/2 or serial mouse. Make sure the mouse is set to ...

  • ATEN ATEN MasterView KVM CS-62 - page 14

    Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR’ S LIABILITY E XCEED THE PRICE PA ID FOR THE PRODUCT FROM THE DIRECT, INDIRECT, SPECIAL, INCIDE NTAL OR CONSEQUE NTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK OR ITS DOCUMENTATION. The direct vendor makes no warranty or representation, ex pressed, implied, or statutory with res pect ...

  • ATEN ATEN MasterView KVM CS-62 - page 15

    Notes: - 13 - 2003-06-20 ...

  • ATEN ATEN MasterView KVM CS-62 - page 16

    Notes: - 14 - 2003-06-20 ...

Produzent ATEN Kategorie Switch

Dokumente, die wir vom Produzenten des Geräts ATEN ATEN MasterView KVM CS-62 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen ATEN
- Bedienungsanleitungen MasterView KVM CS-62
- Produktkarten ATEN
- Informationsbroschüren
- oder Energieetiketten ATEN ATEN MasterView KVM CS-62
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung ATEN ATEN MasterView KVM CS-62.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen ATEN ATEN MasterView KVM CS-62, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen ATEN ATEN MasterView KVM CS-62. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts ATEN ATEN MasterView KVM CS-62 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts ATEN ATEN MasterView KVM CS-62, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von ATEN ATEN MasterView KVM CS-62 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von ATEN ATEN MasterView KVM CS-62 verständlich ist.

Eine gänzliche Bedienungsanleitung von ATEN sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von ATEN ATEN MasterView KVM CS-62 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von ATEN ATEN MasterView KVM CS-62 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich ATEN ATEN MasterView KVM CS-62, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts ATEN ATEN MasterView KVM CS-62 - die uns die ersten Schritte während der Nutzung von ATEN ATEN MasterView KVM CS-62 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit ATEN ATEN MasterView KVM CS-62 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von ATEN ATEN MasterView KVM CS-62 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich ATEN ATEN MasterView KVM CS-62?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit ATEN ATEN MasterView KVM CS-62 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit ATEN ATEN MasterView KVM CS-62 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)