Manual ATEN ATEN MasterView KVM CS-62

16 pages 13.84 mb
Download

Go to site of 16

Summary
  • ATEN ATEN MasterView KVM CS-62 - page 1

    User Manual CS-62 Read this guide thoroughly and follo w the installation and operation procedures carefully in order to pr event any damage to the units and/or any devices that connect to them. This package contains: M 1 CS-62 Two Port Petite KVM Switch with Attached Cables M 1 User Manual M 1 Quick Start Guide If anything is damaged or mi ssing, ...

  • ATEN ATEN MasterView KVM CS-62 - page 2

    Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec tion against harmful interference in a residential installation. This equipment generat es, uses and can radiate radio frequency energy, and if not instal ...

  • ATEN ATEN MasterView KVM CS-62 - page 3

    Overview The CS-62 Petite KVM Switch Switch is a control unit that allows access to two computer systems from a single console (keyboard, monitor, and mouse). Before the development of the CS-62, the only way to control multiple computer configurat ions from a single console was through a complex and costly network system. Now, with the CS-62 Pet i ...

  • ATEN ATEN MasterView KVM CS-62 - page 4

    Features M One console controls two computers M Compact design features two molded-in KVM (keyboard, video, mouse) cables M Supports Microsoft IntelliMouse and the scrolling wheel on most mice M Easy to install - No software required - connecting cables to the computers is all it takes M Easy to operate - computer selection via hotkeys - auto scan ...

  • ATEN ATEN MasterView KVM CS-62 - page 5

    Hardware Requirements Console M A VGA, SVGA, or Multisync monit or capable of the highest resolution that you will be using on any computer in the installation M A PS/2 Mouse M A PS/2 Keyboard Computers The following equipment must be installed on each computer that is to be connected to the system: M A VGA, SVGA or Multisync card. M A 6-pin mini-D ...

  • ATEN ATEN MasterView KVM CS-62 - page 6

    Front View 1. Port LEDs A LED lights to indicate its corresponding port is the one that has the KVM focus. Depending on the port’s status, the LED may flash according to a specific pattern (see the LED Display Table , p. 8, for details). 2. KVM Cables These 3-in-1 cables connect to the keyboard, video, and mouse ports on the computers you are ins ...

  • ATEN ATEN MasterView KVM CS-62 - page 7

    Installation Refer to the Installation diagram on the next page as you perform the following steps: 1. Plug your keyboard, monitor, and mouse into the appropriate Console ports of the CS-62. Each port is labeled with an appropriate icon to indicate itself. 2. Plug the keyboard, monitor, and mouse connectors of the attached KVM cables into their res ...

  • ATEN ATEN MasterView KVM CS-62 - page 8

    - 6 - 2003-06-20 ...

  • ATEN ATEN MasterView KVM CS-62 - page 9

    Operation The CS-62 Petite KVM Switch uses hotkey combinations to provide KVM focus to the computers. The hotkey combinations allow you to: M Select the Active Port M Invoke Auto Scan Mode M Set the Auto Scan Time Interval Selecting the Active Port You can toggle the KVM focus between the two computers by pressing and releasing the Scroll Lock key ...

  • ATEN ATEN MasterView KVM CS-62 - page 10

    Changing the Scan Interval Before you invoke Auto Scan, you can change the amount of time that Auto Scan dwells on each port (the time interval), wit h the following hotkey combination: [Left shift] [Right shift] [S] [ n ] Where n represents a number from 1 to 4 that specifies the desired scan interval time, as shown in the table below; n Scan Inte ...

  • ATEN ATEN MasterView KVM CS-62 - page 11

    Specifications Function Specification Computer Connections 2 Port Selection Hot Keys LEDs Selected 2 Connectors Keyboard 1 x 6 pin mini-DIN female (PS/2 style) - Console 2 x 6 pin mini-DIN male (PS/2 style) - CPU Ports Mouse 1 x 6 pin mini-DIN female (PS/2 style) - Console 2 x 6 pin mini-DIN male (PS/2 style) - CPU Ports Video 1 x HDB-15 female (st ...

  • ATEN ATEN MasterView KVM CS-62 - page 12

    Troubleshooting Symptom Possible Cause Action Keyboard Not Responding 1 Loose cables. Check all ke yboard cable connections to make sure they are completely seated in their sockets. Keyboard needs to be reset. Unplug the keyboard from the Console Keyboard Port, then plug it back in. Switch needs to be reset Turn off the computers. Unplug the KVM ca ...

  • ATEN ATEN MasterView KVM CS-62 - page 13

    Symptom Possible Cause Action Mouse Not Detected, or Does Not Respond Correctly 2 Switch needs to be reset. Turn off the computers and unplug the KVM cables. Wait five seconds; then plug the cables back in and turn the computers on. Mouse set to Serial Mode. Some mice can be set to act as either a PS/2 or serial mouse. Make sure the mouse is set to ...

  • ATEN ATEN MasterView KVM CS-62 - page 14

    Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR’ S LIABILITY E XCEED THE PRICE PA ID FOR THE PRODUCT FROM THE DIRECT, INDIRECT, SPECIAL, INCIDE NTAL OR CONSEQUE NTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK OR ITS DOCUMENTATION. The direct vendor makes no warranty or representation, ex pressed, implied, or statutory with res pect ...

  • ATEN ATEN MasterView KVM CS-62 - page 15

    Notes: - 13 - 2003-06-20 ...

  • ATEN ATEN MasterView KVM CS-62 - page 16

    Notes: - 14 - 2003-06-20 ...

Manufacturer ATEN Category Switch

Documents that we receive from a manufacturer of a ATEN ATEN MasterView KVM CS-62 can be divided into several groups. They are, among others:
- ATEN technical drawings
- MasterView KVM CS-62 manuals
- ATEN product data sheets
- information booklets
- or energy labels ATEN ATEN MasterView KVM CS-62
All of them are important, but the most important information from the point of view of use of the device are in the user manual ATEN ATEN MasterView KVM CS-62.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals ATEN ATEN MasterView KVM CS-62, service manual, brief instructions and user manuals ATEN ATEN MasterView KVM CS-62. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product ATEN ATEN MasterView KVM CS-62.

Similar manuals

A complete manual for the device ATEN ATEN MasterView KVM CS-62, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use ATEN ATEN MasterView KVM CS-62 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of ATEN ATEN MasterView KVM CS-62.

A complete ATEN manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual ATEN ATEN MasterView KVM CS-62 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the ATEN ATEN MasterView KVM CS-62, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the ATEN ATEN MasterView KVM CS-62, that we can find in the current document
3. Tips how to use the basic functions of the device ATEN ATEN MasterView KVM CS-62 - which should help us in our first steps of using ATEN ATEN MasterView KVM CS-62
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with ATEN ATEN MasterView KVM CS-62
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of ATEN ATEN MasterView KVM CS-62 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning ATEN ATEN MasterView KVM CS-62?

Use the form below

If you did not solve your problem by using a manual ATEN ATEN MasterView KVM CS-62, ask a question using the form below. If a user had a similar problem with ATEN ATEN MasterView KVM CS-62 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)