Bedienungsanleitung TFA 35.1078.10.IT

18 Seiten Betrifft nicht
Download

Zur Seite of 18

Summary
  • TFA 35.1078.10.IT - page 1

    21 Stand LCD Display Function keys WEATHER STATION Instruction Manual INTRODUCTION: Congratulation s on purchasi ng this sta te-of-the-ar t weather station as an example of inn ovative de sign and quali ty piece o f engineerin g. Providing radio controlled time , date, cal endar, Moon phase, in door and outd oor temper ature, indoor and o utdoor re ...

  • TFA 35.1078.10.IT - page 2

    22 • Temperatu re display in ºC/ ºF • Indoor and outdoor tempe rature displa y with MIN/ MAX reco rds and time of reception • Humidity dat a display as R H% • Indoor and outdoor humidit y display wi th MIN/ MAX records • Relative air p ressure hPa/ i nHg with adj ustable refer ence value • W eather icon sensitivit y setting • Relati ...

  • TFA 35.1078.10.IT - page 3

    23 TO INSTALL A ND REPLACE BAT TERIES IN THE THERMO-HYGR O TRANSMITTER The outdoo r Thermo-h ygro transmitter uses 2 x AA IEC LR6, 1.5V batteries. T o install a nd replace t he batteries , please foll ow the steps belo w: 1. Remove th e battery cov er at the front si de with a sm all screwdriver. 2. Insert the ba tteries, obse rving the cor rect po ...

  • TFA 35.1078.10.IT - page 4

    24 between the W eather Sta tion and the transmitter s hould not be more than 100 meters (s ee notes o n “ Positionin g” and “86 8 MHz Rec eption ”). Note: In the event of changing b atteries of th e units, ensur e the batteri es do not sp ring free from the c ontacts. Al ways wait at l east 1 minute after removi ng the batt eries before re ...

  • TFA 35.1078.10.IT - page 5

    25 8. In order to ens ure sufficie nt 868 MHz tr ansmission h owever, the distance between the W eather Sta tion and the transmitter s hould not be more than 100 meters (s ee notes o n “ Positionin g” and “86 8 MHz Rec eption ”). IMPORTAN T: Transmission problems will arise if th e setting for additional sen sors is not followed as describe ...

  • TFA 35.1078.10.IT - page 6

    26 IN key OUT/+ key SET key CH key • W ithin ferro-concrete room s (basemen ts, supe rstructures), th e received signal is nat urally weak ened. In extrem e cases, ple ase place the unit close to a windo w and/ or point its front or ba ck towards t he Frankfu rt transmitter. • During nighttim e, the atmos pheric dist urbances a re usuall y less ...

  • TFA 35.1078.10.IT - page 7

    27 Weather tendency indicator Calendar Indoor relative humidity in RH% Time reception icon (for DCF time) Indoor temperature in ºC/ ºF Weather forecast icon Outdoor data signal reception indicator * Outdoor temperature in ºC/ ºF Outdoor relative humidity in RH% Relative air pressur e history bar graph Relative air pressur e in hPa / inHg LCD SC ...

  • TFA 35.1078.10.IT - page 8

    28 LCD CONTRA ST SETTING: The LCD co ntrast can b e set within 8 le vels, from L CD 0 to LCD 7 (Default s etting is LCD 4): 1. Press and h old the SET key until the di git starts flas hing. 2. Use the OUT /+ key to vie w all levels of contrast. 3. Select the d esired LCD c ontrast. Confi rm with th e SET ke y and enter in t he Time Zone s etting . ...

  • TFA 35.1078.10.IT - page 9

    29 The hour dis play can be sel ected to s how hours in 12-hour o r 24-hour setti ngs. (Default 24-Ho ur) 1. Use the OUT/+ key to t oggle betwee n “12H” or “24H”. 2. Confirm with the SET key a nd enter the M anual ti me setting. M A NUA L TIME SETTING: In case the W eather Statio n cannot de tect the D CF-signal (fo r example d ue to distur ...

  • TFA 35.1078.10.IT - page 10

    30 5. Press the SE T ke y again to c onfirm and to enter the d ate setting m ode. The date sta rts flashing. 6. Use the OUT /+ key to se t the date. 7. Confirm all c alendar settin gs with the S ET ke y and enter the Tem perature unit setting . °C/°F TEMPERAT URE SETTING: The temperatu re displa y can be selecte d to show tem perature d ata in ° ...

  • TFA 35.1078.10.IT - page 11

    31 WE A T HER FORECASTING ICON SENSITIVITY SETTING: For locations with rapid c hanges of weather conditio ns, the weather icons sensitivity can be set to a di fferent level for faster dis play of weat her conditio ns. 1. The current se nsitivity val ue will start fl ashing. 2. Use the OUT /+ key to se t the weathe r sensitivit y level. There a re 3 ...

  • TFA 35.1078.10.IT - page 12

    32 Note: The MIN or MA X data needs to be reset indi vidually. WE A T HER FORECAST AND WEA THER TENDENCY: WE A T HER FORECASTING ICONS: W eather icons in the third section of LC D can be dis played in a ny of the follo wing combinations: Su nny C loudy wit h sunn y intervals Rai ny For every su dden or signifi cant change in the air pres sure, the ...

  • TFA 35.1078.10.IT - page 13

    33 WE A T HER TENDENCY INDICA TOR W orking together with the weather icon s is the weat her tendenc y indicators (located on t he left and ri ght sides of th e weather icon s). W hen the indicator points upwards , it means that the air -pressure is inc reasing and the weather is expected to im prove, but when indicat or points do wnwards, t he air- ...

  • TFA 35.1078.10.IT - page 14

    34 TOGGLING A ND RESETTING THE OUTDOOR DA TA 1. To toggle be tween the ou tdoor current, MAX/ MIN temperatu re and humidit y data and the times (for t emperature d ata onl y) they were recor ded press the OUT/+ k ey: Once to sho w the MA X outdoor temper ature and hum idity data with the recorded tim e and date. Twice to show the MIN out door tempe ...

  • TFA 35.1078.10.IT - page 15

    35 CHECKING FOR 868 MHz RECEPTION If the outdoo r temperatur e and humidit y data are not being r eceived withi n three minutes after setting up (o r outdoor dis play al ways show “- -. - ” in the out door section of the W eather st ation during normal operati on), please c heck the following poi nts: 1. The distance of the W eather station or ...

  • TFA 35.1078.10.IT - page 16

    36 The foldout t able stand le g is located o n the back side. Pull the stand out from t he bottom c enter edge of the weathe r station, below the batt ery compartm ent. Once t he foldout ta ble stand is extended, pl ace the weather station in an app ropriate location. POSITIONING THE THER MO-HYGRO TRA NSMITTER The Thermo- hygro transm itter can be ...

  • TFA 35.1078.10.IT - page 17

    37 SPECIFICAT IONS: Recommende d operating t emperature r ange: 0ºC t o 50ºC Temperature measurin g range: Indoor : -9.9ºC to +59. 9ºC with 0.1 °C resoluti on 14.2ºF to 139. 8ºF with 0. 2ºF resolutio n (“OF.L” displ ayed if outside this range) Outdoor : -39.9ºC to +59 .9ºC with 0. 1°C resoluti on -39.8ºF to +1 39.8ºF with 0.2ºF re ...

  • TFA 35.1078.10.IT - page 18

    38 • The manufac turer and sup plier cann ot accept an y responsibilit y for any incorrect rea dings and an y consequenc es that occ ur should an i naccurate reading take place. • This product is not to be us ed for medic al purposes o r for public information. • This product is only desig ned to be us ed in the hom e as indic ation of the fu ...

Produzent TFA Kategorie Weather station

Dokumente, die wir vom Produzenten des Geräts TFA 35.1078.10.IT erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen TFA
- Bedienungsanleitungen 35.1078.10.IT
- Produktkarten TFA
- Informationsbroschüren
- oder Energieetiketten TFA 35.1078.10.IT
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung TFA 35.1078.10.IT.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen TFA 35.1078.10.IT, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen TFA 35.1078.10.IT. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts TFA 35.1078.10.IT ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts TFA 35.1078.10.IT, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von TFA 35.1078.10.IT hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von TFA 35.1078.10.IT verständlich ist.

Eine gänzliche Bedienungsanleitung von TFA sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von TFA 35.1078.10.IT bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von TFA 35.1078.10.IT befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich TFA 35.1078.10.IT, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts TFA 35.1078.10.IT - die uns die ersten Schritte während der Nutzung von TFA 35.1078.10.IT erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit TFA 35.1078.10.IT hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von TFA 35.1078.10.IT im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich TFA 35.1078.10.IT?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit TFA 35.1078.10.IT nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit TFA 35.1078.10.IT hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)