Bedienungsanleitung Sunfire SRS210W-G

20 Seiten 1.78 mb
Download

Zur Seite of 20

Summary
  • Sunfire SRS210W-G - page 1

    Installation Instructions SRS–210W -C Cabine t SRS–210W -B Baffle SRS–210W -G Grille ...

  • Sunfire SRS210W-G - page 2

    User's Manual W ARNING: THIS SUBWOOFER SYSTEM IS CAP ABLE OF PRODUCING VERY HIGH SOUND PRESSURE LEVELS. YOU MUST T AKE EVERY PRECAUTION TO PROTECT YOUR HEARING FROM PERMANENT DAMAGE. Important Safety Instructions 1. Read Instructions 2. Keep these Instructions 3. Heed all W arnings. 4. Follow all Instructions 5. Do not use this apparatus near ...

  • Sunfire SRS210W-G - page 3

    User's Manual For more information on this and other Sunre products, please visit our website: www .sunre.com Safety Instructions ............ 2 Introduction ...................... 4 Unpacking ........................ 5 Dimensions ...................... 6 Location ............................ 7 Framing ............................ 9 Cabi ...

  • Sunfire SRS210W-G - page 4

    User's Manual Introduction Thank you for purchasing this Sunre SubRosa™ Subwoofer . We hope you enjoy it and the music it makes as much as we have enjoyed creating it for you. The breakthrough features of the subwoofer include: • I-BEAM™ anti-shake mechanism to reduce wall vibration • Dual ten-inch, High Back-emf woof- ers with neod ...

  • Sunfire SRS210W-G - page 5

    User's Manual Installation overview The cabinet may be mounted vertically between wall studs. The width is ideal for tting between vertical 2x4 studs, spaced 16 inches apart. It may also be tted horizontally . A cardboard debris shield is supplied to ll the front aperture and prevent any dust, paint, or debris from entering during ins ...

  • Sunfire SRS210W-G - page 6

    User's Manual Dimensions 0 1.261 in/ 32.1 mm 13.045 in/ 331.343 mm 14.250 in/ 362 mm 3.533 in/ 89.7 mm 10.717 in/ 272.2 mm 0 35.590 in/ 904 mm 44.500 in/ 1,130.3 mm 3.500 in 88.9 mm Front View Back View Side View 8.830 in/ 224.3 mm Front Cutout required in wall to fit woofer assembly 11.784 in/ 299.3 mm 26.76 in/ 679.7 mm Dimensions 6 ...

  • Sunfire SRS210W-G - page 7

    User's Manual The suggestions below will typi- cally result in outstanding performance. However , although low frequencies are non-directional, factors such as room reections, standing waves, resonance and absorption will strongly affect your subwoofer ’s performance. Since your SubRosa subwoofer is de- signed to be professionally install ...

  • Sunfire SRS210W-G - page 8

    User's Manual Center location Installing the subwoofer closer to the center of the front wall will still provide adequate bass, but will tend to be less “heavy” and somewhat tighter . This is ideally suited for: • For rooms smaller than 200 square feet • Dedicated music listening rooms. Using T wo Subwoofers If you wish to use two subw ...

  • Sunfire SRS210W-G - page 9

    User's Manual Framing V ertical mounting Due to residential construction meth- ods, vertical mounting of the cabinet is recommended. The subwoofer cabinet will t between 2 x 4 inch studs on 16 inch centers. Horizontal mounting is also possible, but needs additional framing steps. See page 10 for horizontal mounting details. Notes: • Use t ...

  • Sunfire SRS210W-G - page 10

    User's Manual Cabinet Installation 1. With the help of an assistant to lift the cabinet, check the t of the cabinet into the framing. Use wood shims if there is any gap between the cabinet sides and the vertical studs. 2. If it makes it easier , you can con - nect the wiring to the cabinet before you secure it in place. See the next page fo ...

  • Sunfire SRS210W-G - page 11

    User's Manual Wiring 1. Install the speaker wires following all local codes for electrical wiring installation. Use class 2 wiring, and 12 gauge is recommended, 16 gauge is the minimum. 2. Follow common low voltage practices like avoiding high voltage electrical wiring, or crossing them perpendicularly . This will reduce the chance of picking ...

  • Sunfire SRS210W-G - page 12

    User's Manual Final Rough-in 1. Make sure the debris shield is tted into the cabinet opening using the plastic push rivets supplied. This will prevent dust and sheetrock debris from entering the cabinet. Rough-in 12 Debris shield ...

  • Sunfire SRS210W-G - page 13

    User's Manual Sheetrock installation 1. Apply glue to the framing surround- ing the cabinet. Also apply glue to the front surface of the cabinet, wherever it will be in contact with the sheetrock. 3. Fit the sheetrock in place with sheetrock screws spaced 4 inches apart. 4. Carefully cut away the sheetrock to reveal the cabinet's aperture ...

  • Sunfire SRS210W-G - page 14

    User's Manual Horizontal mounting In this position, the subwoofer's longest side is horizontal. This may be required for some installations, although it requires more framing work. The procedure for mounting is basically the same as the vertical mounting. 1. The cabinet should be mounted off the oor as shown, to prevent nails from punc ...

  • Sunfire SRS210W-G - page 15

    User's Manual 3. With the help of an assistant to lift the cabinet, check the t into the framing, and use shims if required. 4. Wiring the subwoofer is the same as described previously , except that there is not much room to make the connections to the binding posts. 5. Use wood glue, such as Liquid Nails™ along the cabinet top and side. ...

  • Sunfire SRS210W-G - page 16

    User's Manual W oofer bafe installation With the cabinet installed, and all the sheetrock, nishing and decorating done, the woofer bafe can be installed. The woofer bafe assembly consists of the following components already installed: • The bafe, upon which all the com - ponents are assembled • T wo subwoofer drivers • I-B ...

  • Sunfire SRS210W-G - page 17

    User's Manual Bafe installation procedure 1. Remove the debris shield from the front of the in-wall cabinet. Y ou can do this by cutting the cardboard with a sharp knife and pulling out the cardboard pieces and the plas- tic rivets holding it in place. Do not cut the two wires inside the cabinet, and do not remove any sound- proong mater ...

  • Sunfire SRS210W-G - page 18

    User's Manual Grille installation With the woofer bafe installed, and the subwoofer tested, the grille can now be installed. The grille assembly consists of the fol- lowing components: • The grille frame. This screws to the woofer bafe and holds the grille in place. It forms a nice frame around the subwoofer opening in the wall, hiding ...

  • Sunfire SRS210W-G - page 19

    User's Manual Installing the grille assembly 1. Secure the grille frame to the woofer bafe using 12 screws supplied in the grille package. 2. If you have already painted the frame and grille, please jump to step 6. 3. Fit the supplied cardboard paint shield into the frame to cover the woofers and bafe. Press the grille in place temporari ...

  • Sunfire SRS210W-G - page 20

    Manual 913-142-00 Rev 7 SRS–210W -C Cabinet SRS–210W -B Baffle SRS–210W -G Grille ...

Produzent Sunfire Kategorie Speaker

Dokumente, die wir vom Produzenten des Geräts Sunfire SRS210W-G erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Sunfire
- Bedienungsanleitungen SRS210W-G
- Produktkarten Sunfire
- Informationsbroschüren
- oder Energieetiketten Sunfire SRS210W-G
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Sunfire SRS210W-G.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Sunfire SRS210W-G, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Sunfire SRS210W-G. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Sunfire SRS210W-G ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Sunfire SRS210W-G, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Sunfire SRS210W-G hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Sunfire SRS210W-G verständlich ist.

Eine gänzliche Bedienungsanleitung von Sunfire sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Sunfire SRS210W-G bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Sunfire SRS210W-G befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Sunfire SRS210W-G, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Sunfire SRS210W-G - die uns die ersten Schritte während der Nutzung von Sunfire SRS210W-G erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Sunfire SRS210W-G hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Sunfire SRS210W-G im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Sunfire SRS210W-G?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sunfire SRS210W-G nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sunfire SRS210W-G hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)