-
Sunfire SRS210W-G - page 1
Installation Instructions SRS–210W -C Cabine t SRS–210W -B Baffle SRS–210W -G Grille ...
-
Sunfire SRS210W-G - page 2
User's Manual W ARNING: THIS SUBWOOFER SYSTEM IS CAP ABLE OF PRODUCING VERY HIGH SOUND PRESSURE LEVELS. YOU MUST T AKE EVERY PRECAUTION TO PROTECT YOUR HEARING FROM PERMANENT DAMAGE. Important Safety Instructions 1. Read Instructions 2. Keep these Instructions 3. Heed all W arnings. 4. Follow all Instructions 5. Do not use this apparatus near ...
-
Sunfire SRS210W-G - page 3
User's Manual For more information on this and other Sunre products, please visit our website: www .sunre.com Safety Instructions ............ 2 Introduction ...................... 4 Unpacking ........................ 5 Dimensions ...................... 6 Location ............................ 7 Framing ............................ 9 Cabi ...
-
Sunfire SRS210W-G - page 4
User's Manual Introduction Thank you for purchasing this Sunre SubRosa™ Subwoofer . We hope you enjoy it and the music it makes as much as we have enjoyed creating it for you. The breakthrough features of the subwoofer include: • I-BEAM™ anti-shake mechanism to reduce wall vibration • Dual ten-inch, High Back-emf woof- ers with neod ...
-
Sunfire SRS210W-G - page 5
User's Manual Installation overview The cabinet may be mounted vertically between wall studs. The width is ideal for tting between vertical 2x4 studs, spaced 16 inches apart. It may also be tted horizontally . A cardboard debris shield is supplied to ll the front aperture and prevent any dust, paint, or debris from entering during ins ...
-
Sunfire SRS210W-G - page 6
User's Manual Dimensions 0 1.261 in/ 32.1 mm 13.045 in/ 331.343 mm 14.250 in/ 362 mm 3.533 in/ 89.7 mm 10.717 in/ 272.2 mm 0 35.590 in/ 904 mm 44.500 in/ 1,130.3 mm 3.500 in 88.9 mm Front View Back View Side View 8.830 in/ 224.3 mm Front Cutout required in wall to fit woofer assembly 11.784 in/ 299.3 mm 26.76 in/ 679.7 mm Dimensions 6 ...
-
Sunfire SRS210W-G - page 7
User's Manual The suggestions below will typi- cally result in outstanding performance. However , although low frequencies are non-directional, factors such as room reections, standing waves, resonance and absorption will strongly affect your subwoofer ’s performance. Since your SubRosa subwoofer is de- signed to be professionally install ...
-
Sunfire SRS210W-G - page 8
User's Manual Center location Installing the subwoofer closer to the center of the front wall will still provide adequate bass, but will tend to be less “heavy” and somewhat tighter . This is ideally suited for: • For rooms smaller than 200 square feet • Dedicated music listening rooms. Using T wo Subwoofers If you wish to use two subw ...
-
Sunfire SRS210W-G - page 9
User's Manual Framing V ertical mounting Due to residential construction meth- ods, vertical mounting of the cabinet is recommended. The subwoofer cabinet will t between 2 x 4 inch studs on 16 inch centers. Horizontal mounting is also possible, but needs additional framing steps. See page 10 for horizontal mounting details. Notes: • Use t ...
-
Sunfire SRS210W-G - page 10
User's Manual Cabinet Installation 1. With the help of an assistant to lift the cabinet, check the t of the cabinet into the framing. Use wood shims if there is any gap between the cabinet sides and the vertical studs. 2. If it makes it easier , you can con - nect the wiring to the cabinet before you secure it in place. See the next page fo ...
-
Sunfire SRS210W-G - page 11
User's Manual Wiring 1. Install the speaker wires following all local codes for electrical wiring installation. Use class 2 wiring, and 12 gauge is recommended, 16 gauge is the minimum. 2. Follow common low voltage practices like avoiding high voltage electrical wiring, or crossing them perpendicularly . This will reduce the chance of picking ...
-
Sunfire SRS210W-G - page 12
User's Manual Final Rough-in 1. Make sure the debris shield is tted into the cabinet opening using the plastic push rivets supplied. This will prevent dust and sheetrock debris from entering the cabinet. Rough-in 12 Debris shield ...
-
Sunfire SRS210W-G - page 13
User's Manual Sheetrock installation 1. Apply glue to the framing surround- ing the cabinet. Also apply glue to the front surface of the cabinet, wherever it will be in contact with the sheetrock. 3. Fit the sheetrock in place with sheetrock screws spaced 4 inches apart. 4. Carefully cut away the sheetrock to reveal the cabinet's aperture ...
-
Sunfire SRS210W-G - page 14
User's Manual Horizontal mounting In this position, the subwoofer's longest side is horizontal. This may be required for some installations, although it requires more framing work. The procedure for mounting is basically the same as the vertical mounting. 1. The cabinet should be mounted off the oor as shown, to prevent nails from punc ...
-
Sunfire SRS210W-G - page 15
User's Manual 3. With the help of an assistant to lift the cabinet, check the t into the framing, and use shims if required. 4. Wiring the subwoofer is the same as described previously , except that there is not much room to make the connections to the binding posts. 5. Use wood glue, such as Liquid Nails™ along the cabinet top and side. ...
-
Sunfire SRS210W-G - page 16
User's Manual W oofer bafe installation With the cabinet installed, and all the sheetrock, nishing and decorating done, the woofer bafe can be installed. The woofer bafe assembly consists of the following components already installed: • The bafe, upon which all the com - ponents are assembled • T wo subwoofer drivers • I-B ...
-
Sunfire SRS210W-G - page 17
User's Manual Bafe installation procedure 1. Remove the debris shield from the front of the in-wall cabinet. Y ou can do this by cutting the cardboard with a sharp knife and pulling out the cardboard pieces and the plas- tic rivets holding it in place. Do not cut the two wires inside the cabinet, and do not remove any sound- proong mater ...
-
Sunfire SRS210W-G - page 18
User's Manual Grille installation With the woofer bafe installed, and the subwoofer tested, the grille can now be installed. The grille assembly consists of the fol- lowing components: • The grille frame. This screws to the woofer bafe and holds the grille in place. It forms a nice frame around the subwoofer opening in the wall, hiding ...
-
Sunfire SRS210W-G - page 19
User's Manual Installing the grille assembly 1. Secure the grille frame to the woofer bafe using 12 screws supplied in the grille package. 2. If you have already painted the frame and grille, please jump to step 6. 3. Fit the supplied cardboard paint shield into the frame to cover the woofers and bafe. Press the grille in place temporari ...
-
Sunfire SRS210W-G - page 20
Manual 913-142-00 Rev 7 SRS–210W -C Cabinet SRS–210W -B Baffle SRS–210W -G Grille ...
¿Tienes una pregunta acerca de Sunfire SRS210W-G?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sunfire SRS210W-G, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sunfire SRS210W-G probablemente compartirá una forma de solucionarlo.