Bedienungsanleitung Pelco C3420M

16 Seiten 0.44 mb
Download

Zur Seite of 16

Summary
  • Pelco C3420M - page 1

    ® INSTALLATION Heavy-Duty Spectra ® IV Series C3420M (8/06) Pendant Back Box ...

  • Pelco C3420M - page 2

    2 C3420M (8/06) Installation 1 3 2 ...

  • Pelco C3420M - page 3

    C3420M (8/0 6) 3 1. Install the mount for th e pendant dome . Refer to the instruct ions supplied with the mount. If the moun t is outdoors, make sure it is properly se aled to keep moisture out. 2. Open t he hinged do or to the back box. P ush the tab lock towards the wall o f the unit and lift t he door op en. Pull wiring into the back box. Refer ...

  • Pelco C3420M - page 4

    4 C3420M (8/06) 5 4 VIDEO UTP+ UTP- RX- RX- TX- TX- PWR- PWR+ GND AUX2 GND GND NO NC COM 7 6 5 4 3 2 1 ALARMS AUX1 ...

  • Pelco C3420M - page 5

    C3420M (8/0 6) 5 4. Connect wiring to the circuit board inside the back box. Whe n finished, clos e the door to th e back box and turn o n the power . The green LED will light. NOTES: • Aux 1: Maximum 2 A at low voltage (<40 V) Aux 2: Maximum 30 mA at 32 VDC • If you are u sing both u nshielded twi ste d pair (UTP) wiring and a transla tor b ...

  • Pelco C3420M - page 6

    6 C3420M (8/06) BARREL LOCK CENTER PIN   SWITCH 1 AND 2 6 7 8 9 ...

  • Pelco C3420M - page 7

    C3420M (8/0 6) 7 6. Configu re DIP switc hes SW1 and SW2 lo cated on th e top of the dome drive. For DIP switch settin gs, refer to the labels locat ed on the top of the dome dr ive or to t he Switch Settings section of this manual. NOTE: When co nnecting more than on e Spectra dome to a single controller , termin ate the unit farth est from the co ...

  • Pelco C3420M - page 8

    8 C3420M (8/06) T roubleshooting If your dome do es not power up proper ly after installati on, use the following steps. 1. Check the fuse on the circuit board inside the ba ck box for continuity . Replace the fuse if needed. 2. Check th e wiring with a volt meter to ensure p r oper voltage is being received in to the back box. If your dome powers ...

  • Pelco C3420M - page 9

    C3420M (8/0 6) 9 Switch Settings WAR N I NG : If you are using D-ty pe or P-type control, your system may no t operate if the baud rate and address switches are not set cor rectly . The switches ar e set at t he factory at the defau lts for D-t ype control (2400 baud and address 1). T able D. Switch Settings for SW2 Special Sy stems S w i t c h N u ...

  • Pelco C3420M - page 10

    10 C3420M (8/06) T able E. Switch Settings for SW1, P-T ype Control NOTE: For Coaxitron controls, SW1 is not us ed; set all switches OFF . For D-type con trol systems, refer to T abl e F . T able F . Switch Settings for SW1, D-T ype Control NOTE: For Coaxitron controls, SW1 is not used; set all switches OFF . For P-t ype control systems, re fer to ...

  • Pelco C3420M - page 11

    C3420M (8/0 6) 11 SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 71 ON ON ON OFF OFF OFF ON OFF 72 OFF OFF OFF ON OFF OFF ON OFF 73 ON OFF OFF ON OFF OFF ON OFF 74 OFF ON OFF ON OFF OFF ON OFF 75 ON ON OFF ON OFF OFF ON OFF 76 OFF OFF ON ON OFF OFF ON OFF 77 ON OFF ON ON OFF OFF ON OFF 78 OFF ON ON ON OFF OFF ON OFF ...

  • Pelco C3420M - page 12

    12 C3420M (8/06) SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 151 ON ON ON OFF ON OFF OFF ON 152 OFF OFF OFF ON ON OFF OFF ON 153 ON OFF OFF ON ON OFF OFF ON 154 OFF ON OFF ON ON OFF OFF ON 155 ON ON OFF ON ON OFF OFF ON 156 OFF OFF ON ON ON OFF OFF ON 157 ON OFF ON ON ON OFF OFF ON 158 OFF ON ON ON ON OFF OFF ON ...

  • Pelco C3420M - page 13

    C3420M (8/0 6) 13 SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 223 ON ON ON ON ON OFF ON ON 224 OFF OFF OFF OFF OFF ON ON ON 225 ON OFF OFF OFF OFF ON ON ON 226 OFF ON OFF OFF OFF ON ON ON 227 ON ON OFF OFF OFF ON ON ON 228 OFF OFF ON OFF OFF ON ON ON 229 ON OFF ON OFF OFF ON ON ON 230 OFF ON ON OFF OFF ON ON ON 2 ...

  • Pelco C3420M - page 14

    14 C3420M (8/06) Weight (approximate) Back Box Pendant 4.45 lb (2.02 kg) Environmental Pendant 4.75 lb (2.1 5 kg) Dome Drive 3.3 lb (1.48 kg) Lower Dome Pendant 1.83 lb (0.83 kg) Pendant with Ca ge 3.83 lb (1.74) ELECTRICAL (Dome Drive Only) Input V oltag e 18-32 V AC; 24 VAC nomina l 22-27 VDC; 24 VDC nominal Input Power 24 V AC 23 V A nominal (in ...

  • Pelco C3420M - page 15

    PRODUCT WARRANTY AND RETURN INFORMA TION WARRA NTY Pelco will r epair or repla ce, without charge, any merchandise p roved defectiv e in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are a s noted below: • Five years on FR/F T/FS Series fiber opt ic products and TW3 000 Series unshielded ...

  • Pelco C3420M - page 16

    W orldwide Headquarters 3500 Pelco W ay Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www .pelco.com ISO 9001 Australia | Canada | Finland | France | Italy | Russia | Singapore | Spain | Sweden | The Netherl ands | United Ar ab Emirat es | United Kingdom | U ...

Produzent Pelco Kategorie Landscape Lighting

Dokumente, die wir vom Produzenten des Geräts Pelco C3420M erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Pelco
- Bedienungsanleitungen C3420M
- Produktkarten Pelco
- Informationsbroschüren
- oder Energieetiketten Pelco C3420M
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Pelco C3420M.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Pelco C3420M, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Pelco C3420M. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Pelco C3420M ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Pelco C3420M, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Pelco C3420M hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Pelco C3420M verständlich ist.

Eine gänzliche Bedienungsanleitung von Pelco sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Pelco C3420M bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Pelco C3420M befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Pelco C3420M, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Pelco C3420M - die uns die ersten Schritte während der Nutzung von Pelco C3420M erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Pelco C3420M hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Pelco C3420M im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Pelco C3420M?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Pelco C3420M nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Pelco C3420M hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)