Bedienungsanleitung American Standard 7038.400

12 Seiten 1.37 mb
Download

Zur Seite of 12

Summary
  • American Standard 7038.400 - page 1

    3 5 4 4 Cer tified to comply with ANSI A112.18.1 Installation Instructions Bidet Faucet and T ransfer V alve with Ev erClean™ Finish & SpeedC onnec t™ Drain Congr atulations on purchasing your A merican Standard faucet with E verClean finish and Speed Connect drain, two features f ound only on American Standard faucets. *Y our new American ...

  • American Standard 7038.400 - page 2

    M968893 POP-UP DRAIN Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B. 3 5 4 2 TIGHTEN LOCKNUT 1 REMOVE FLANGE Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B. Remove ...

  • American Standard 7038.400 - page 3

    Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate connectors, and COUPLING NUTS. Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to waste outlet. 10 Connect water supply to V AL VE BODIES (7,7a) with 1/2" IPS FLEXIBLE SUPPLIES (8) or 3/8" O.D. BULL-NOSE RISERS (9) . Use adjusta ...

  • American Standard 7038.400 - page 4

    CHECK DRAIN CONNECTIONS 12 13 TEST INST ALLED FITTING With HANDLES (1) in OFF position, turn on W A TER SUPPLIES (2) and check all connections for leaks. Operate both HANDLES (1) to flush water lines thoroughly . Rotate TRANSFER V AL VE (5) from rim wash to spray several times to check operation. Pull up POP-UP KNOB (3) and fill Bidet with water . ...

  • American Standard 7038.400 - page 5

    M968893 SpeedConnect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration. Fig. B. Use fingers or small screwdriver under ei ...

  • American Standard 7038.400 - page 6

    M968893 6 STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper. Fig. G. To install the stopper in “Locked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the rear of the Sink and the American Standard logo is fa ...

  • American Standard 7038.400 - page 7

    3 5 4 4 Cer tified to comply with ANSI A112.18.1 Installation Instructions Bidet Faucet and V acuum Br eaker with Ev erClean™ Finish & SpeedC onnec t™ Drain Congr atulations on purchasing your A merican Standard faucet with Ev erClean finish and Speed Connect drain, two featur es found only on American Standard fauc ets. *Y our new American ...

  • American Standard 7038.400 - page 8

    POP-UP DRAIN Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B. 3 5 4 2 TIGHTEN LOCKNUT 1 REMOVE FLANGE Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B. Remove CLEAR PL ...

  • American Standard 7038.400 - page 9

    Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate connectors, and COUPLING NUTS. Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to waste outlet. 10 Connect water supply to V AL VE BODIES (7,7a) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3) . Use adjusta ...

  • American Standard 7038.400 - page 10

    CHECK DRAIN CONNECTIONS 12 13 TEST INST ALLED FITTING With HANDLES (1) in OFF position, turn on W A TER SUPPLIES (2) and check all connections for leaks. Operate both HANDLES (1) to flush water lines thoroughly . Rotate TRANSFER V AL VE (5) from rim wash to spray several times to check operation. Pull up POP-UP KNOB (3) and fill Bidet with water . ...

  • American Standard 7038.400 - page 11

    SpeedConnect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration. Fig. B. Use fingers or small screwdriver under either sid ...

  • American Standard 7038.400 - page 12

    M968894 6 STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper. Fig. G. To install the stopper in “Locked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the rear of the Sink and the American Standard logo is fa ...

Produzent American Standard Kategorie Indoor Furnishings

Dokumente, die wir vom Produzenten des Geräts American Standard 7038.400 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen American Standard
- Bedienungsanleitungen 7038.400
- Produktkarten American Standard
- Informationsbroschüren
- oder Energieetiketten American Standard 7038.400
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung American Standard 7038.400.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen American Standard 7038.400, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen American Standard 7038.400. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts American Standard 7038.400 ansehen.

Die komplette Bedienungsanleitung des Geräts American Standard 7038.400, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von American Standard 7038.400 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von American Standard 7038.400 verständlich ist.

Eine gänzliche Bedienungsanleitung von American Standard sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von American Standard 7038.400 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von American Standard 7038.400 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich American Standard 7038.400, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts American Standard 7038.400 - die uns die ersten Schritte während der Nutzung von American Standard 7038.400 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit American Standard 7038.400 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von American Standard 7038.400 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich American Standard 7038.400?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit American Standard 7038.400 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit American Standard 7038.400 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)