Bedienungsanleitung Vivotek FD7130

14 Seiten 2.12 mb
Download

Zur Seite of 14

Summary
  • Vivotek FD7130 - page 1

    Quick Installation Guide This guide describes the basic functions of FD7130 All detailed information is described in the user's manual. FD7130 IP Surveillance V andal-proof . T amper Detection . PoE English ᖅϛ Рҏᇭ Español Português ᙏϛ Français Deutsch Italiano Türkçe Polski Ру сский Česky Svenska ...

  • Vivotek FD7130 - page 2

    EN - 1 English Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water . If the Network Camera becomes wet, power off immediately . Do not place the Network Camera around heat sources, such as a television or oven. Refer to your user ? ...

  • Vivotek FD7130 - page 3

    EN - 2 Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network Camera. ...

  • Vivotek FD7130 - page 4

    EN - 3 English Software CD FD7130 with an RJ45 or M12 Cable Quick Installation Guide / W arranty Card Screwdriver Alignment Sticker Ground Wire / Screws Liquid Tight Connectors for RJ45 or M12 Cable Package Contents 1 RJ45 M12 RJ45 Silica Gel ...

  • Vivotek FD7130 - page 5

    EN - 4 Network Camera Model No: FD7130 Made in Taiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,930,709 MAC:00 ...

  • Vivotek FD7130 - page 6

    EN - 5 English 1 2 3 4 5 6 7 8 (D) (B) (C) (A) (E) Cabling Assembly 3 Components of the W aterproof Connector Screw Nut (C) Housing (D) Gasket (E) Seal (B) Sealing Nut (A) RJ45 Cable Dimension (unit: mm) Prepare an Ethernet cable and strip part of the sheath. Insert the housing into the screw nut. Insert the seal into the housing. Insert the stripp ...

  • Vivotek FD7130 - page 7

    EN - 6 1 2 3 4 5 6 7 Ø4.5mm~Ø6.5mm (C) (D) (B) (A) (E) M12 Cable Connector Components of the W aterproof Connector M12 Cable Dimension (unit: mm) Assembling Steps Clamp Ring (C) Gasket (D) Plastic Nut (E) Seal (B) Sealing Nut (A) Prepare an Ethernet cable and strip part of the sheath. Insert the seal into the clamp ring. Insert the gasket into th ...

  • Vivotek FD7130 - page 8

    EN - 7 English First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/SDHC Card if necessary . Then, follow the steps below to install the camera to either the ceiling or the wall: 1. Attach the supplied alignment sticker to the ceiling/wall. 2. Using the 3 screw circles on the sticker , drill 3 pilot ...

  • Vivotek FD7130 - page 9

    EN - 8 1 2 B A 3 4 Wall Mount Installing the Ground Wire As shown in the following figure, please secure one side of the supplied ground wire to the screw hole, then route the other side of the ground wire to the ground. Please secure the screws tightly to avoid moisture. ...

  • Vivotek FD7130 - page 10

    EN - 9 English Network Deployment 5 Po wer ov er Ether net (PoE) POWER COLLISION LINK RECEIVE PARTIT ION 1 2 3 4 5 PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch. When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power ...

  • Vivotek FD7130 - page 11

    EN - 10 Network Camera Model No: FD7130 Made in T aiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,930,709 MAC: ...

  • Vivotek FD7130 - page 12

    EN - 1 1 English For further setup, please refer to the user's manual on the software CD. Ready to Use 7 1. Access the Network Camera on the LAN. 2. Retrieve live video through a web browser or recording software. T o adjust the viewing angle Adjust the lens to a desired viewing angle as the diagram shown below . 10° 10° 90° Adjusting the L ...

  • Vivotek FD7130 - page 13

    EN - 12 Attach the dome cover to camera. Secure the dome screws with the supplied screwdriver . Finally , make sure all parts of the camera are securely installed. Completion 9 Fine-tune the Camera Focus The focus of this network camera is set from 1.0m to infinity by factory default. If you want to focus on objects closer than 1.0m or the lens ha ...

  • Vivotek FD7130 - page 14

    P/N: 625008801G Ver.1.1 Copyright 2009 VIVOTEK INC. All right reserved. ...

Produzent Vivotek Kategorie Home Security System

Dokumente, die wir vom Produzenten des Geräts Vivotek FD7130 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Vivotek
- Bedienungsanleitungen FD7130
- Produktkarten Vivotek
- Informationsbroschüren
- oder Energieetiketten Vivotek FD7130
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Vivotek FD7130.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Vivotek FD7130, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Vivotek FD7130. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Vivotek FD7130 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Vivotek FD7130, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Vivotek FD7130 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Vivotek FD7130 verständlich ist.

Eine gänzliche Bedienungsanleitung von Vivotek sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Vivotek FD7130 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Vivotek FD7130 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Vivotek FD7130, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Vivotek FD7130 - die uns die ersten Schritte während der Nutzung von Vivotek FD7130 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Vivotek FD7130 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Vivotek FD7130 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Vivotek FD7130?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Vivotek FD7130 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Vivotek FD7130 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)