Manuel d’utilisation Vivotek FD7130

14 pages 2.12 mb
Télécharger

Aller à la page of 14

Summary
  • Vivotek FD7130 - page 1

    Quick Installation Guide This guide describes the basic functions of FD7130 All detailed information is described in the user's manual. FD7130 IP Surveillance V andal-proof . T amper Detection . PoE English ᖅϛ Рҏᇭ Español Português ᙏϛ Français Deutsch Italiano Türkçe Polski Ру сский Česky Svenska ...

  • Vivotek FD7130 - page 2

    EN - 1 English Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water . If the Network Camera becomes wet, power off immediately . Do not place the Network Camera around heat sources, such as a television or oven. Refer to your user ? ...

  • Vivotek FD7130 - page 3

    EN - 2 Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network Camera. ...

  • Vivotek FD7130 - page 4

    EN - 3 English Software CD FD7130 with an RJ45 or M12 Cable Quick Installation Guide / W arranty Card Screwdriver Alignment Sticker Ground Wire / Screws Liquid Tight Connectors for RJ45 or M12 Cable Package Contents 1 RJ45 M12 RJ45 Silica Gel ...

  • Vivotek FD7130 - page 5

    EN - 4 Network Camera Model No: FD7130 Made in Taiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,930,709 MAC:00 ...

  • Vivotek FD7130 - page 6

    EN - 5 English 1 2 3 4 5 6 7 8 (D) (B) (C) (A) (E) Cabling Assembly 3 Components of the W aterproof Connector Screw Nut (C) Housing (D) Gasket (E) Seal (B) Sealing Nut (A) RJ45 Cable Dimension (unit: mm) Prepare an Ethernet cable and strip part of the sheath. Insert the housing into the screw nut. Insert the seal into the housing. Insert the stripp ...

  • Vivotek FD7130 - page 7

    EN - 6 1 2 3 4 5 6 7 Ø4.5mm~Ø6.5mm (C) (D) (B) (A) (E) M12 Cable Connector Components of the W aterproof Connector M12 Cable Dimension (unit: mm) Assembling Steps Clamp Ring (C) Gasket (D) Plastic Nut (E) Seal (B) Sealing Nut (A) Prepare an Ethernet cable and strip part of the sheath. Insert the seal into the clamp ring. Insert the gasket into th ...

  • Vivotek FD7130 - page 8

    EN - 7 English First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/SDHC Card if necessary . Then, follow the steps below to install the camera to either the ceiling or the wall: 1. Attach the supplied alignment sticker to the ceiling/wall. 2. Using the 3 screw circles on the sticker , drill 3 pilot ...

  • Vivotek FD7130 - page 9

    EN - 8 1 2 B A 3 4 Wall Mount Installing the Ground Wire As shown in the following figure, please secure one side of the supplied ground wire to the screw hole, then route the other side of the ground wire to the ground. Please secure the screws tightly to avoid moisture. ...

  • Vivotek FD7130 - page 10

    EN - 9 English Network Deployment 5 Po wer ov er Ether net (PoE) POWER COLLISION LINK RECEIVE PARTIT ION 1 2 3 4 5 PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch. When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power ...

  • Vivotek FD7130 - page 11

    EN - 10 Network Camera Model No: FD7130 Made in T aiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,930,709 MAC: ...

  • Vivotek FD7130 - page 12

    EN - 1 1 English For further setup, please refer to the user's manual on the software CD. Ready to Use 7 1. Access the Network Camera on the LAN. 2. Retrieve live video through a web browser or recording software. T o adjust the viewing angle Adjust the lens to a desired viewing angle as the diagram shown below . 10° 10° 90° Adjusting the L ...

  • Vivotek FD7130 - page 13

    EN - 12 Attach the dome cover to camera. Secure the dome screws with the supplied screwdriver . Finally , make sure all parts of the camera are securely installed. Completion 9 Fine-tune the Camera Focus The focus of this network camera is set from 1.0m to infinity by factory default. If you want to focus on objects closer than 1.0m or the lens ha ...

  • Vivotek FD7130 - page 14

    P/N: 625008801G Ver.1.1 Copyright 2009 VIVOTEK INC. All right reserved. ...

Fabricant Vivotek Catégorie Home Security System

Les documents que nous recevons du fabricant de l'appareilVivotek FD7130 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Vivotek
- manuels d’utilisations FD7130
- fiches produit Vivotek
- dépliants
- ou étiquettes-énergie Vivotek FD7130
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Vivotek FD7130.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Vivotek FD7130, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Vivotek FD7130. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Vivotek FD7130.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Vivotek FD7130, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Vivotek FD7130 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Vivotek FD7130.

Le manuel d’utilisation complet Vivotek, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Vivotek FD7130 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Vivotek FD7130, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lVivotek FD7130 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Vivotek FD7130 - qui devraient nous aider dans les premières étapes lors de l'utilisation Vivotek FD7130
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Vivotek FD7130
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Vivotek FD7130 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Vivotek FD7130?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Vivotek FD7130, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Vivotek FD7130 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)