Bedienungsanleitung Extron electronic SF 26X

17 Seiten 3.93 mb
Download

Zur Seite of 17

Summary
  • Extron electronic SF 26X - page 1

    User Guide SF 26X Speakers SpeedMount ® Ceiling Mount Speakers 68-2222-01 Rev . A 12 13 ...

  • Extron electronic SF 26X - page 2

    Safety Instructions  WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated danger ous voltage within the product’ s enclosur e that may present a risk of electric shock.   ...

  • Extron electronic SF 26X - page 3

    Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: A caution indicates a situation that may result in minor injury . W ARNING: A warning indicates a situation that has the  to result in death or severe injury . A TTENTION: Attention indicates a situation that may dama ...

  • Extron electronic SF 26X - page 4

    Contents Introduction .................................................... 1 About the SF 26X Speaker ................................ 1 Features ............................................................. 1 Application Example ........................................... 2 Installation ...................................................... 3 Inst ...

  • Extron electronic SF 26X - page 5

    Intr oduction This user guide contains information about the Extron SF 26X Ceiling Mount Speaker . About the SF 26X Speaker The SF 26X speaker is a two-way , low impedance, ceiling-mount speaker system that features an 8 ohm open back speaker with a 6.5 inch woofer and a 3/4 inch tweeter designed for use in non-plenum airspace environments. Featur ...

  • Extron electronic SF 26X - page 6

    Application Example The illustration below is one example of configuring a system using the SF 26X speakers. L R SIG LINK DTP IN SIG LINK DTP OUT 50/60 Hz 100-240V X.XA MAX 1 2 RGB OUT HDMI MIC MIX RS-232 MPS 602 SA Tx Rx G MUTE HDMI AUDIO PHANTOM POWER SELECT 3 4 5 6 OUTPUTS AMP OUT REMOTE OVER DTP OVER DTP RS-232 IR Rx G Tx Tx Rx RS-232 IR Rx G ...

  • Extron electronic SF 26X - page 7

    Installation The Installation section describes: • Installing the SF 26X in a Suspended Ceiling • Painting the Baffle and Grille Installing the SF 26X in a Suspended Ceiling 1. Remove power from all devices. NOTE: If the baffle or grille is to be painted, see the Painting the Baf fle and Grille section on page 12. The maximum ceiling tile ...

  • Extron electronic SF 26X - page 8

    6. Attach speaker wires fr om the ceiling tile hole to the included four -pole captive screw connector using one of the following three methods below . NOTES: • Be sure that the combined impedance of the speaker system does not equal a value less than the rated minimum load impedance of the amplifier . • The maximum number of wires per te ...

  • Extron electronic SF 26X - page 9

    • Wiring Multiple Speakers Using Loop-through: A loop-through electrical connection is made on the cr ossover board of the SF 26X. Connect the wires to the captive scr ew connectors of the speakers, as shown below . Be sur e to tighten the screws. NOTES: • Be sure that the combined impedance of the speaker system does not equal a value le ...

  • Extron electronic SF 26X - page 10

    • T o test the impedance of the entire speaker system, first disconnect the speaker wires fr om the amplifier and then measure the impedance fr om the disconnected wires, as shown below . Impedance Te st Points Captive Screw Connector Te st Points + _ _ + To next speaker Red Wi re (+) disconnected from Amplifier Black Wi re (-) disconnected f ...

  • Extron electronic SF 26X - page 11

    • Wiring Speakers in Parallel: Connect the wires to the captive scr ew connectors of the speakers, as shown below . Be sur e to tighten the screws. NOTES: • Be sure that the combined impedance of the speaker system does not equal a value less than the rated minimum load impedance of the amplifier . • When a chain of speakers is wire ...

  • Extron electronic SF 26X - page 12

    T o test the impedance of the entire speaker system, first disconnect the speaker wires fr om the amplifier and then measure the impedance fr om the disconnected wires, as shown below . Impedance Te st Points Captive Screw Connector Te st Points + _ _ + To next speake r Red Wi re (+) disconnected from Amplifier Black Wi re (-) disconnected from Am ...

  • Extron electronic SF 26X - page 13

    7. Insert the captive screw connector into the four -pole receptacle on the speaker crossover boar d as shown below . Zip Tie Captive Sc re w Connector Strain Relief Tie off Point Figure 3. Strain Relief Tie Off Point 8. Secure the speaker wir e to the strain relief tie of f point using the included zip tie as shown above. 9. Mount the SF 26X. a. I ...

  • Extron electronic SF 26X - page 14

    10. Attach the secondary support line if r equired, as shown below . Secondary Support Line Secondary Tie off Point Figure 5. Attaching the Secondary Support Line a. Remove the ceiling tile adjacent to the tile where the speaker is mounted. b. Attach the secondary support line. A TTENTION:  Do not allow any slack in the secondary support line. c ...

  • Extron electronic SF 26X - page 15

    12. Position the outer perimeter of the grille into the gr oove of the speaker baffle. Six magnets pull the grille securely into place, as shown below . Speaker Grille Figure 7. Installing the SF 26X Grille NOTE:  Grillehooksarepr ovidedforremovalofthegrilleafterinstallation. SF 26X User Guide • Installation 11 ...

  • Extron electronic SF 26X - page 16

    Painting the Baf fle and Grille NOTE: The cutout template that was used in step 2 of the previous section will be used as a paint shield when painting the outer circumfer ence of the baffle. Painting the Baffle 1. Remove the grille using the provided grille hooks and set the grille aside. 2. Place cutout template over the center of the tweeter so ...

  • Extron electronic SF 26X - page 17

    Extron Headquarters +1.800.633.9876 (Inside USA/Canada Only) Extron USA - W est Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 F AX +1.919.850.1001 F AX Extron Europe +800.3987.6673 (Inside Europe Only) +31.33.453.4040 +31.33.453.4050 F AX Extron Asia +65.6383.4400 +65.6383.4664 F AX Extron Japan +81.3.3511.7655 +81.3.3511.7656 F ...

Produzent Extron electronic Kategorie Speaker

Dokumente, die wir vom Produzenten des Geräts Extron electronic SF 26X erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Extron electronic
- Bedienungsanleitungen SF 26X
- Produktkarten Extron electronic
- Informationsbroschüren
- oder Energieetiketten Extron electronic SF 26X
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Extron electronic SF 26X.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Extron electronic SF 26X, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Extron electronic SF 26X. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Extron electronic SF 26X ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Extron electronic SF 26X, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Extron electronic SF 26X hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Extron electronic SF 26X verständlich ist.

Eine gänzliche Bedienungsanleitung von Extron electronic sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Extron electronic SF 26X bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Extron electronic SF 26X befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Extron electronic SF 26X, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Extron electronic SF 26X - die uns die ersten Schritte während der Nutzung von Extron electronic SF 26X erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Extron electronic SF 26X hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Extron electronic SF 26X im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Extron electronic SF 26X?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Extron electronic SF 26X nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Extron electronic SF 26X hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)