Manual Extron electronic SF 26X

17 pages 3.93 mb
Download

Go to site of 17

Summary
  • Extron electronic SF 26X - page 1

    User Guide SF 26X Speakers SpeedMount ® Ceiling Mount Speakers 68-2222-01 Rev . A 12 13 ...

  • Extron electronic SF 26X - page 2

    Safety Instructions  WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated danger ous voltage within the product’ s enclosur e that may present a risk of electric shock.   ...

  • Extron electronic SF 26X - page 3

    Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: A caution indicates a situation that may result in minor injury . W ARNING: A warning indicates a situation that has the  to result in death or severe injury . A TTENTION: Attention indicates a situation that may dama ...

  • Extron electronic SF 26X - page 4

    Contents Introduction .................................................... 1 About the SF 26X Speaker ................................ 1 Features ............................................................. 1 Application Example ........................................... 2 Installation ...................................................... 3 Inst ...

  • Extron electronic SF 26X - page 5

    Intr oduction This user guide contains information about the Extron SF 26X Ceiling Mount Speaker . About the SF 26X Speaker The SF 26X speaker is a two-way , low impedance, ceiling-mount speaker system that features an 8 ohm open back speaker with a 6.5 inch woofer and a 3/4 inch tweeter designed for use in non-plenum airspace environments. Featur ...

  • Extron electronic SF 26X - page 6

    Application Example The illustration below is one example of configuring a system using the SF 26X speakers. L R SIG LINK DTP IN SIG LINK DTP OUT 50/60 Hz 100-240V X.XA MAX 1 2 RGB OUT HDMI MIC MIX RS-232 MPS 602 SA Tx Rx G MUTE HDMI AUDIO PHANTOM POWER SELECT 3 4 5 6 OUTPUTS AMP OUT REMOTE OVER DTP OVER DTP RS-232 IR Rx G Tx Tx Rx RS-232 IR Rx G ...

  • Extron electronic SF 26X - page 7

    Installation The Installation section describes: • Installing the SF 26X in a Suspended Ceiling • Painting the Baffle and Grille Installing the SF 26X in a Suspended Ceiling 1. Remove power from all devices. NOTE: If the baffle or grille is to be painted, see the Painting the Baf fle and Grille section on page 12. The maximum ceiling tile ...

  • Extron electronic SF 26X - page 8

    6. Attach speaker wires fr om the ceiling tile hole to the included four -pole captive screw connector using one of the following three methods below . NOTES: • Be sure that the combined impedance of the speaker system does not equal a value less than the rated minimum load impedance of the amplifier . • The maximum number of wires per te ...

  • Extron electronic SF 26X - page 9

    • Wiring Multiple Speakers Using Loop-through: A loop-through electrical connection is made on the cr ossover board of the SF 26X. Connect the wires to the captive scr ew connectors of the speakers, as shown below . Be sur e to tighten the screws. NOTES: • Be sure that the combined impedance of the speaker system does not equal a value le ...

  • Extron electronic SF 26X - page 10

    • T o test the impedance of the entire speaker system, first disconnect the speaker wires fr om the amplifier and then measure the impedance fr om the disconnected wires, as shown below . Impedance Te st Points Captive Screw Connector Te st Points + _ _ + To next speaker Red Wi re (+) disconnected from Amplifier Black Wi re (-) disconnected f ...

  • Extron electronic SF 26X - page 11

    • Wiring Speakers in Parallel: Connect the wires to the captive scr ew connectors of the speakers, as shown below . Be sur e to tighten the screws. NOTES: • Be sure that the combined impedance of the speaker system does not equal a value less than the rated minimum load impedance of the amplifier . • When a chain of speakers is wire ...

  • Extron electronic SF 26X - page 12

    T o test the impedance of the entire speaker system, first disconnect the speaker wires fr om the amplifier and then measure the impedance fr om the disconnected wires, as shown below . Impedance Te st Points Captive Screw Connector Te st Points + _ _ + To next speake r Red Wi re (+) disconnected from Amplifier Black Wi re (-) disconnected from Am ...

  • Extron electronic SF 26X - page 13

    7. Insert the captive screw connector into the four -pole receptacle on the speaker crossover boar d as shown below . Zip Tie Captive Sc re w Connector Strain Relief Tie off Point Figure 3. Strain Relief Tie Off Point 8. Secure the speaker wir e to the strain relief tie of f point using the included zip tie as shown above. 9. Mount the SF 26X. a. I ...

  • Extron electronic SF 26X - page 14

    10. Attach the secondary support line if r equired, as shown below . Secondary Support Line Secondary Tie off Point Figure 5. Attaching the Secondary Support Line a. Remove the ceiling tile adjacent to the tile where the speaker is mounted. b. Attach the secondary support line. A TTENTION:  Do not allow any slack in the secondary support line. c ...

  • Extron electronic SF 26X - page 15

    12. Position the outer perimeter of the grille into the gr oove of the speaker baffle. Six magnets pull the grille securely into place, as shown below . Speaker Grille Figure 7. Installing the SF 26X Grille NOTE:  Grillehooksarepr ovidedforremovalofthegrilleafterinstallation. SF 26X User Guide • Installation 11 ...

  • Extron electronic SF 26X - page 16

    Painting the Baf fle and Grille NOTE: The cutout template that was used in step 2 of the previous section will be used as a paint shield when painting the outer circumfer ence of the baffle. Painting the Baffle 1. Remove the grille using the provided grille hooks and set the grille aside. 2. Place cutout template over the center of the tweeter so ...

  • Extron electronic SF 26X - page 17

    Extron Headquarters +1.800.633.9876 (Inside USA/Canada Only) Extron USA - W est Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 F AX +1.919.850.1001 F AX Extron Europe +800.3987.6673 (Inside Europe Only) +31.33.453.4040 +31.33.453.4050 F AX Extron Asia +65.6383.4400 +65.6383.4664 F AX Extron Japan +81.3.3511.7655 +81.3.3511.7656 F ...

Manufacturer Extron electronic Category Speaker

Documents that we receive from a manufacturer of a Extron electronic SF 26X can be divided into several groups. They are, among others:
- Extron electronic technical drawings
- SF 26X manuals
- Extron electronic product data sheets
- information booklets
- or energy labels Extron electronic SF 26X
All of them are important, but the most important information from the point of view of use of the device are in the user manual Extron electronic SF 26X.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Extron electronic SF 26X, service manual, brief instructions and user manuals Extron electronic SF 26X. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Extron electronic SF 26X.

A complete manual for the device Extron electronic SF 26X, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Extron electronic SF 26X by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Extron electronic SF 26X.

A complete Extron electronic manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Extron electronic SF 26X - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Extron electronic SF 26X, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Extron electronic SF 26X, that we can find in the current document
3. Tips how to use the basic functions of the device Extron electronic SF 26X - which should help us in our first steps of using Extron electronic SF 26X
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Extron electronic SF 26X
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Extron electronic SF 26X in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Extron electronic SF 26X?

Use the form below

If you did not solve your problem by using a manual Extron electronic SF 26X, ask a question using the form below. If a user had a similar problem with Extron electronic SF 26X it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)