Bedienungsanleitung Enviro 1000

19 Seiten 0.8 mb
Download

Zur Seite of 19

Summary
  • Enviro 1000 - page 1

    ENVIROFIRE WOOD STOVE MODELS 1000, 1600, 1600INS, 2100 OWNERS AND OPERATORS MANUAL SHERWOOD INDUSTRIES LTD. 6782 OLDFIELD ROAD VICTORIA , BRITISH COLUMBIA V8M-2A3 ...

  • Enviro 1000 - page 2

    TABLE OF CONTENTS • PLEASE READ AND SAVE INSTRUCTIONS SAFETY WARNING 2 • OPERATING INSTRUCTIONS 3 - 4 • • PEDESTAL INSTALLATION 5 • BRICK INSTALLATION • M O D E L 1 0 0 0 6 • MODEL 1600 INSERT 7 • M O D E L 2 1 0 0 8 • FREESTANDING INSTALLATION 9 - 1 0 • MOBILE HOME INSTALLATION 1 1 • FIREPLACE INSERT INSTALLATION 1 2 • HOW ...

  • Enviro 1000 - page 3

    OPERATING INSTRUCTIONS STARTING: Place crumpled paper on t he stove floor and cover with ki ndling. Open the draft fully and ignite. Hold the door slightly a jar for a few minutes and then close tightly. A fter the wood is burning b rightly add more dry wood and, when the fire is hot, use the draft control to adjust the burn rate. This limits the a ...

  • Enviro 1000 - page 4

    DISPOSAL OF ASHES: If you let the ashes accumulate two or three in ches on the floor they tend to burn themselves up. Open the small trap door located on the floor of the unit. Push the ashe s that have accumul ated into the hole were the ashes would drop into the ash pan. Ensure tha t the trap door is closed properly before relighting the unit. Wh ...

  • Enviro 1000 - page 5

    PEDESTAL AND LEG INSTALLATION Please read and understand these instruction s before installing ash pan and leg option. Failure to follow these instructions caref ully c ould cause personal injury or prop erty damage. All screws are pre installe d on the base of the unit. PEDESTAL • Remove the bricks from the unit before starting. • Loosen the t ...

  • Enviro 1000 - page 6

    MODEL 1000 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING THESE BRICKS. 1. Place the bottom layers of the sides and ba ck of the firebox. 2. Place the floor bricks. The spaces betwe en the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept the top, ceiling bricks. 4. On the right and left ...

  • Enviro 1000 - page 7

    MODEL 1600 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING THESE BRICKS. 1. Place the bottom layers of the sides and ba ck of the firebox. 2. Place the floor bricks. The spaces betwe en the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept the top, ceiling bricks. 4. On the right and left ...

  • Enviro 1000 - page 8

    MODEL 2100 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE IN STALLATION BEFORE PLACING BRICKS. 1. Place the bottom layers of the sides and ba ck of the firebox. 2. Place the floor bricks. The spaces betwe en the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept the top, ceiling bricks. 4. On the right and left sides ...

  • Enviro 1000 - page 9

    FREESTANDING INSTALLATION: CHIMNEY : Vent the stove into a clean, lined, approved masonry chimney in good condition, conformi ng to local building codes or a listed 6” fa ctory built chimney suitable for use with solid fuels an d conforming to, ULC-S629 in CANADA or UL - 103HT in the U.S.A.. Connect the stove to this chimney with a short and stra ...

  • Enviro 1000 - page 10

    OUTSIDE AIR: Pedestal rear A 4” (10.16 cm) fresh air adapter kit is a vailable. This adapter can be installed either on the back pedestal or through the floor under the p edestal. Place the 1/4” mesh screen between the fresh air ad apter and the body of the pedestal. (AS SHOWN) NOTE: Fresh air connectio n to the unit must be a non combustible p ...

  • Enviro 1000 - page 11

    MOBILE HOME INSTALLATION SPECIAL REQUIREMENTS: Pedestal model s 1000 and 1600 are approved for mobile home s. All freestanding installation requirements o n the preceding page plus the following must be met: VENTING: In Canada: Any ULC-629 listed chimn ey system with t he accompanying double wall vent connector. In U.S.A. Any HT-103 listed chimne y ...

  • Enviro 1000 - page 12

    MODEL 1600 INS FIREPLACE INSERT Unless you are experienced, we recommend installation by your dealer or a professional installe r. Install only in a masonry fireplace at least 25” (63 5 mm) wide, 22” (560 mm) high and 1 4” (356 mm) deep with an approved lined chim ney at least 15 ft (4.6 m) high, both of which have been constructed in accorda ...

  • Enviro 1000 - page 13

    HOW IT WORKS SPECIFICATIONS: MODEL 1000 MODEL 1600 MODEL 1600fpi MODEL 2100 WIDTH X DEPTH 24 X 21” (.61 X .53 M) 24 X 25.5” (.61 X ..64 M) 24 X 25.5” (.61 X ..64 M) 24 X 30” (.61 X .76 M) HEIGHT ON PEDESTAL 33 “ (.83 M) 33 “ (.83 M) N/A 33 “ (.83 M) HEIGHT OF BODY 22” (.56 M) 22” (. 56 M) 22” (.56 M) 22” (.56 M) FUEL CHAMBER D ...

  • Enviro 1000 - page 14

    DOOR INSTALLATION Remove the door from the packaging. Inspect the do or assembly for damage. DO NOT USE DOOR IF GLASS IS BROKEN. Place the door assembly on the two hinge pins moun ted on the body of the unit. Open and close the door, ap plying pressure down, to ensure the door assembly is pro perly seated on the hinges. NUT CAST LATCH WASHERS X 2 S ...

  • Enviro 1000 - page 15

    OPTIONAL FAN INSTALLATION The appliance when install ed, must be electrically connecte d and grounded in accordan ce with local codes or in the absence of local codes, with the current CSA C22.1 CANA DIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLA TIONS, or THE NATIONAL ELECTR ICAL CODE ANSI / NFPA 70 in the USA. CAUTION Labe ...

  • Enviro 1000 - page 16

    DO NOT REMOVE THIS LABEL WH- LISTED SOLID FUEL SPACE HEATER SERIAL NO . MODEL:  1000  1600  2100  1600 INS MODEL 1000 SUITABLE FOR USE IN MOBILE HOMES. CERTIFIED FOR CANADA AND THE U.S.A. REPORT NO. J99011443-231 TESTED TO CSA B366.2/ULC-S627, ULC-S628-M93, UL-1482-1994 REP ORT NO. 6385 INSTALL AND USE ONLY IN ACCORDANCE WI TH THE MANUF ...

  • Enviro 1000 - page 17

    PARTS AND ACCESSIORIES PLEASE CONTACT YOUR LOCAL E NVIROFIRE DEALER WHEN REPLACE MENT PARTS ARE REQUIRED. EF-163 WOOD STOVE PAINTED DOOR EF-164 WOOD STOVE GOLD DOOR EF-165 1600 FPI PANEL SET (REGULAR) EF-166 1600 FPI PANEL SET (OVERSIZE) EF-167 FAN KIT (1000, 1600, 2100, (FREESTANDING ONLY) EF-168 DOOR GASKET EF-169 CLAYBURN BRICKS EF-170 INNER DOO ...

  • Enviro 1000 - page 18

    WARRANTY Because of our high standard s Sherwood Industries Ltd. can offer a *Lifetim e Warranty on all it’s wood product s. Covered under this warranty are Cabin et Sides, Tops , Pedestals, Surround Panels, Removabl e Air Channel, and Chassis. These steel compone nts are covered against manuf acture’s defects for 1 year on parts an d labor and ...

  • Enviro 1000 - page 19

    SET OF FOUR (4) LEGS W/ ASH PAN EF 1000 PAINTED -EFW 250 GOLD -EFW 251 NICKEL- EFW 252 EF 1600-2100 PAINTED- EFW-265 GOLD- EFW-267 NICKEL- EFW-269 SPRING HANDLE GOLD 10-006 NICKEL 10-007 GLASS W/ TAPE 10-000 CAST DOOR W/ GLASS PAINTED EFW-258 GOLD EFW-259 NICKEL EFW-260 DOOR HANDLE ASSEMBLY 10-001 SOLID ASH COVER EF-196 SLIDER DAMPER SPRING HANDLE ...

Produzent Enviro Kategorie Stove

Dokumente, die wir vom Produzenten des Geräts Enviro 1000 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Enviro
- Bedienungsanleitungen 1000
- Produktkarten Enviro
- Informationsbroschüren
- oder Energieetiketten Enviro 1000
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Enviro 1000.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Enviro 1000, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Enviro 1000. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Enviro 1000 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Enviro 1000, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Enviro 1000 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Enviro 1000 verständlich ist.

Eine gänzliche Bedienungsanleitung von Enviro sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Enviro 1000 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Enviro 1000 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Enviro 1000, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Enviro 1000 - die uns die ersten Schritte während der Nutzung von Enviro 1000 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Enviro 1000 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Enviro 1000 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Enviro 1000?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Enviro 1000 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Enviro 1000 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)