-
DCS -IVH-48 - page 1
Dynamic Cook ing Sys tems, Inc. ISLAND VENT HOOD USE AND CARE INST ALLA TION INSTRUCTIONS DCS-IVH-48 DCS-IVH-36 ...
-
DCS -IVH-48 - page 2
A MESSAGE TO OUR CUSTOMERS Thank you for selecting this Dynamic Cooking Systems Professional Island Vent Hood. Because of this appliance ’ s unique features we have developed this Installation and Use Guide. It contains valuable information on how to properly operate and maintain your new appliance for years of safe and enjoyable use. To help ser ...
-
DCS -IVH-48 - page 3
Introduction 1 Before proceeding with installation, please read this installation guide and observe all safety precautions and warnings. NOTE: Installation of this DCS Island Vent Hood must comply with all local codes. IMPORTANT- Save these instructions for the Local Electrical Inspector ’ s use. INSTALLER- Please leave these instructions with th ...
-
DCS -IVH-48 - page 4
Follow These Precautions Important Safety Instructions 2 CAUTION - TO REDUCE THE RISK OF ELECTRICAL SHOCK OR INJURY TO PERSONS ALL VENT HOODS MUST BE INSTALLED WITH VENTILATORS THAT HAVE BEEN APPROVED FOR USE WITH THE HOOD. Make up air may be necessary to prevent air flowing down chimney, unsealed door, window, or fire place opening. WARNING - TO R ...
-
DCS -IVH-48 - page 5
Island Vent Hoods DCS-IVH-48 & DCS-IVH-36 Features 3 The Dynamic Cooking Systems Island Vent Hood Models; DCS IVH 48 , DCS IVH 36, have been designed with the ultimate in household conve- nience in mind. Features include a high capacity, variable speed blower with speed controller, commercial style dishwasher-safe filters, easy to clean inside ...
-
DCS -IVH-48 - page 6
We recommend that a backdraft damper be used in all Vent Hood installations. Cold weather installations necessitate the use of a backdraft damper to minimize the flow of cold air into the room. A non-metallic thermal break should also be installed to mini- mize conduction of outside temperatures through the ductwork. Locate the thermal break as clo ...
-
DCS -IVH-48 - page 7
Product and Venting Specifications Specifications 5 843fi21 16" 52 5/8" 30" 16" FR ONT VIEW SIDE VIEW 34 5/8" 12" 12" 34 5/8" DCS-IVH-48 DCS-IVH-48 DCS-IVH-36 DCS-IVH-36 VENT HOOD DIMENSIONS nt ro l 30" 12" T OP VIEW o f DCS-IVH 18" 12" T OP VIEW o f DCS-IVH v enting specs 7" Ø v ent ...
-
DCS -IVH-48 - page 8
Site Preparation Site Preparation and Installation Guidelines 6 You will need to create a secure soffit structure to mount the Island Vent Hood to the ceiling. We suggest using 1 1/2 “ by 3 1/2 “ wood cut to fit the installation as shown in the following pages. The soffit mounting to the top of the Island Vent Hood will be 10 7/8 “ in length ...
-
DCS -IVH-48 - page 9
Create your Soffit Struct first and attach Soffit B to each side with screws pr 36" ISLAND VENT HOOD SOFFIT MOUN 6 Mounting Scr ew s SOFFIT BRACKETS SCREWED TO BOTH SIDES OF SOFFIT STRUCTURE SCREW SUPPORT BARS ON BOTH SIDES AS SHOWN CREATE YOUR SOFFIT STRUCTURE ACCORDING TO THE CEILING HEIGHT THEN ATTACH IT TO THE CEILING JOIST. 843 fig 1 s ke ...
-
DCS -IVH-48 - page 10
DCS-IVH-48 Island Vent Hood Soffit Installation 8 A TT A CH SOFFIT BRA CKETS ON 4 CORNER S OF THE SOFFIT STR UCTURE 2 SUPPOR T BA RS SOFFIT ASSEMBLY FOR DCS-IVH-48 10 7 / 8 " HEIGHT WILL VARY ACCORDING TO CEILING HEIGHT 28 7 / 8 " 4 SOFFIT BRA CKETS The dimensions giv en are f or a 1 THE DIMENSIONS GIVEN ARE FOR A 1/2 INCH DRYWALL DUCT CO ...
-
DCS -IVH-48 - page 11
Soffit for DCS-IVH-48 Island Vent Hood Soffit Installation 28 7/8 " 10 7/8 " T OP VIEW o f DCS-IVH 48 SIDE VIEW f or DCS-IVH 48 S OFFIT STR UCTU 1 1/2 " x 3 1/2 " So f fit 3 1/2 "c ent erline t o cen t erline measuremen t f rom scr e w t o scr ew W ood S tructure 1 1/2 " x 3 1/2 " So f (4) so ffit br ack e ts The ...
-
DCS -IVH-48 - page 12
Diagrams for DCS-IVH-48 Island Vent Hood Soffit Installation 10 counter top level 843 fig 4 FR ONT VIEW o f DCS-IVH 48 30" Min. t o cooking surf a ce Support Bars Ceiling Floor Typical 96" Ceiling Sho wn Duct Co v er NO TE: Duct Co v er height will v ary acco r ding t o ceiling heigh t these mus t be cust om built. 6 Moun ting Scre ws Sol ...
-
DCS -IVH-48 - page 13
Duct Accessories General Ducting Information DCS-IVH-48 Requirements DCS-IVH-36 Requirements When planning the path for ducting to the outside, keep in mind the following guide- lines: - Minimize use of elbows and transitions in ductwork as to maximize air flow to out- side of building. An efficient airflow path contributes to the overall efficienc ...
-
DCS -IVH-48 - page 14
Controls Care And Use 12 Hood Lighting Blower We recommend you turn your hood on before you begin cooking to establish fresh airflow. After you have finished cooking, let the blower run for a few minutes to clear the air and help keep the kitchen fresh and clean. The Blower is operated with 2 controls. The switch adjacent to the speed control turns ...
-
DCS -IVH-48 - page 15
Care And Use 13 When cool the appliance can be cleaned with hot soapy water, rinsed, dried and buffed to a shine with a soft, heavy pile cloth. Always try this first, as it is the mildest form of cleaning. 1. Some brands of cleaners are harsher than others. Read their instructions. Try on a small inconspicuous area first. 2. To avoid marring the su ...
-
DCS -IVH-48 - page 16
Cleaning the Grease Tray Care And Use 14 Location of grease tray DCS-IVH-36 DCS-IVH-48 Remove filter(s) by gently pulling up and out. The grease trays can easily be reached once the filters are removed. Grease collection trays are easily accessible at the center beneath the filter. See illustration below for location. ...
-
DCS -IVH-48 - page 17
DCS-IVH-48 & DCS-IVH-36 Island Vent Hood Wiring Diagram 15 ...
-
DCS -IVH-48 - page 18
16 W arranty Information Length of Warranty One (1) Year Full parts and Labor Covers the entire product Five (5) Years Limited Switches and motor All repair labor and parts found to be defective due to materials or workmanship for one full year from date of purchase. Service must be provided by an Authorized Factory Service Agent during normal work ...
-
DCS -IVH-48 - page 19
How To Obtain Service: Ser vice 17 For warranty service, contact your local DCS authorized service agency. Be prepared to provide the Model Number, Serial Number, and date of installa- tion, and a brief description of the problem. If you need assistance in locating the authorized service agency in your area please contact the DCS Consumer Service D ...
-
DCS -IVH-48 - page 20
Litho in USA 8-99 Part No. 10843 rev.2 As product improvement is an ongoing process at DCS, we reserve the right to change specifications or design without notice. Dynamic Cook ing Sy s tems , Inc. 5800 Skylab Road, Huntington Beach, CA. 92647 Tel: (714) 372-7000 Fax: (714) 372-7001 Parts/Customer Service (888) 281-5698 ...
Haben Sie eine Frage bezüglich DCS -IVH-48?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit DCS -IVH-48 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit DCS -IVH-48 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.