Bedienungsanleitung Nilfisk-ALTO ADP152

14 Seiten 0.29 mb
Download

Zur Seite of 14

Summary
  • Nilfisk-ALTO ADP152 - page 1

    LT O LT O TM ADP102 ADP152 User's Manual Version 1.0 ---English--- ...

  • Nilfisk-ALTO ADP152 - page 2

    LTO LTO TM Care & Safety Instructions 1 All the safety and operating instructions should be read before this product is installed and operated. We recommend that installation be carried out by an authorized mobile electronics installation company . Please contact your local A LTO Mobile distributor for a list of authorized installers in your ar ...

  • Nilfisk-ALTO ADP152 - page 3

    LTO LTO TM Introduction 2 Dear Customer, Thank you for choosing this ALT O Mobile ADP Series Full-Range Class-D Power Am plifier. W e hope you will enjoy using this product as much as we enjoyed developing it. The ADP Series is the result of considerable research and development in our R&D centers in Europe and the Far East. It is a very close ...

  • Nilfisk-ALTO ADP152 - page 4

    LTO LTO TM Drawings Showing the Front and Rear Panels 3 1 1 2 2 3 3 4 4 5 5 6 6 FREQ. HP/FLA T/LP GAIN CH 1. 2 CH 1. 2 FUSE GND 12V REM CH2 CH1 CH2 CH1 INPUT OUTPUT POWER INPUT ...

  • Nilfisk-ALTO ADP152 - page 5

    Mounting the Unit 3 3 Power, Ground and Remote Switch-On T erminals LTO LTO TM Installation & Setup Instructions 4 You r ADP Serie s Power Amplifier has two fixing 'ears' at each side, allowing it to be firmly screwed to a suitable surface. It may be mounted vertically or horizontally , but avoid mounting the unit upside down (suspend ...

  • Nilfisk-ALTO ADP152 - page 6

    +12V The terminal marked +12V should be connected to a permanent (i.e. not ignition switched) positive 12 Volt supply from the vehicle battery. GND The terminal marked GND (Ground) should be connected to a cable which is terminated to the vehicle chassis. Ensure that the point where this cable attaches to the vehicle chassis provides good electrica ...

  • Nilfisk-ALTO ADP152 - page 7

    4 4 Fuse 5 5 Input Gain Control Use this control to match the pre-amp output level of your car audio source unit (tape or CD player) to the input stage of the ADP amplifier . The amplifier's input gain is variable from 400mV (MAX Gain) to over 15V (MIN Gain). Here are two different ways of setting up the input gain: The easy (but less accurate ...

  • Nilfisk-ALTO ADP152 - page 8

    See how far you can take the volume control before the signal begins to clip (you may need to reduce the amp gain if it gets too loud). If you see it clip on the scope, back off the volume control a little. Now increase the gain on the amp until you find the highest level before distortion or visible clipping. Bear in mind that the maximum level ma ...

  • Nilfisk-ALTO ADP152 - page 9

    8 LTO LTO TM Although commonly referred to as a "digital" amplifier, C lass-D is more accurately described as a Pulse Width Modulated (PWM) amplifier. A PWM amplifier converts the music (which is a complex arrangement of sine waves) into a series of pulses. The major benefit of this design is its great efficien cy , which is the relations ...

  • Nilfisk-ALTO ADP152 - page 10

    9 LTO LTO TM Further Information For additional information, please visit our website at www.alto mobile.com , which includes a technical discussion forum where users can exchange ideas. Troubleshooting Power LED not lit : Is the Remote switch cable from the source unit (Cassette or CD Player) attached to the REM terminal of the ADP amplifier, and ...

  • Nilfisk-ALTO ADP152 - page 11

    10 T o be protected by this warranty , the buyer must be able to produce a numbered, machine printed sales receipt from his supplying dealer that clearly shows the dealer's name and address, the buyer's name and address, purchase date, model and serial number of the product. AL TO warrants the mechanical and electronic components of this ...

  • Nilfisk-ALTO ADP152 - page 12

    11 LTO LTO TM ADP102 Power Output (RMS, 4 ohms): THD: Residual Noise: Xover: Input Gain Range (MAX - MIN): Operating Voltage: Output Efficiency at Full Power: Protection Circuitry: Idle Current (no signal): Standby Current, REM input low: Size: 50W X 2 <0.05% @10Vrms 120uVrms (A-wtd) HP/ LP/ FLAT switchable. 50Hz - 500Hz, 12dB/oct. 400mV to > ...

  • Nilfisk-ALTO ADP152 - page 13

    12 ADP152 Power Output (RMS, 4 ohms): THD: Residual Noise: Xover: Input Gain Range (MAX - MIN): Operating Voltage: Output Efficiency at Full Power: Protection Circuitry: Idle Current (no signal): Standby Current, REM input low: Size: 75W X 2 <0.05% @10Vrms 120uVrms (A-wtd) HP/ LP/ FLAT switchable. 50Hz - 500Hz, 12dB/oct. 400mV to >15V 11 - 16 ...

  • Nilfisk-ALTO ADP152 - page 14

    NF01173-1.0 No. 1, Lane 17, Sec. 2, Han Shi W. Road, T aichung, 401 Taiwan http://www.altomobile.com T el: 886-4-22313737 email: info@altomobile.com Fax: 886-4-22346757 All rights reserved to AL TO Mobile. Due to continued development in response to customer feedback, product features, specifications and/or internal/external design may be changed w ...

Produzent Nilfisk-ALTO Kategorie Stereo Amplifier

Dokumente, die wir vom Produzenten des Geräts Nilfisk-ALTO ADP152 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Nilfisk-ALTO
- Bedienungsanleitungen ADP152
- Produktkarten Nilfisk-ALTO
- Informationsbroschüren
- oder Energieetiketten Nilfisk-ALTO ADP152
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Nilfisk-ALTO ADP152.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Nilfisk-ALTO ADP152, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Nilfisk-ALTO ADP152. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Nilfisk-ALTO ADP152 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Nilfisk-ALTO ADP152, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Nilfisk-ALTO ADP152 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Nilfisk-ALTO ADP152 verständlich ist.

Eine gänzliche Bedienungsanleitung von Nilfisk-ALTO sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Nilfisk-ALTO ADP152 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Nilfisk-ALTO ADP152 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Nilfisk-ALTO ADP152, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Nilfisk-ALTO ADP152 - die uns die ersten Schritte während der Nutzung von Nilfisk-ALTO ADP152 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Nilfisk-ALTO ADP152 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Nilfisk-ALTO ADP152 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Nilfisk-ALTO ADP152?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Nilfisk-ALTO ADP152 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Nilfisk-ALTO ADP152 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)