Manuel d’utilisation Nilfisk-ALTO ADP152

14 pages 0.29 mb
Télécharger

Aller à la page of 14

Summary
  • Nilfisk-ALTO ADP152 - page 1

    LT O LT O TM ADP102 ADP152 User's Manual Version 1.0 ---English--- ...

  • Nilfisk-ALTO ADP152 - page 2

    LTO LTO TM Care & Safety Instructions 1 All the safety and operating instructions should be read before this product is installed and operated. We recommend that installation be carried out by an authorized mobile electronics installation company . Please contact your local A LTO Mobile distributor for a list of authorized installers in your ar ...

  • Nilfisk-ALTO ADP152 - page 3

    LTO LTO TM Introduction 2 Dear Customer, Thank you for choosing this ALT O Mobile ADP Series Full-Range Class-D Power Am plifier. W e hope you will enjoy using this product as much as we enjoyed developing it. The ADP Series is the result of considerable research and development in our R&D centers in Europe and the Far East. It is a very close ...

  • Nilfisk-ALTO ADP152 - page 4

    LTO LTO TM Drawings Showing the Front and Rear Panels 3 1 1 2 2 3 3 4 4 5 5 6 6 FREQ. HP/FLA T/LP GAIN CH 1. 2 CH 1. 2 FUSE GND 12V REM CH2 CH1 CH2 CH1 INPUT OUTPUT POWER INPUT ...

  • Nilfisk-ALTO ADP152 - page 5

    Mounting the Unit 3 3 Power, Ground and Remote Switch-On T erminals LTO LTO TM Installation & Setup Instructions 4 You r ADP Serie s Power Amplifier has two fixing 'ears' at each side, allowing it to be firmly screwed to a suitable surface. It may be mounted vertically or horizontally , but avoid mounting the unit upside down (suspend ...

  • Nilfisk-ALTO ADP152 - page 6

    +12V The terminal marked +12V should be connected to a permanent (i.e. not ignition switched) positive 12 Volt supply from the vehicle battery. GND The terminal marked GND (Ground) should be connected to a cable which is terminated to the vehicle chassis. Ensure that the point where this cable attaches to the vehicle chassis provides good electrica ...

  • Nilfisk-ALTO ADP152 - page 7

    4 4 Fuse 5 5 Input Gain Control Use this control to match the pre-amp output level of your car audio source unit (tape or CD player) to the input stage of the ADP amplifier . The amplifier's input gain is variable from 400mV (MAX Gain) to over 15V (MIN Gain). Here are two different ways of setting up the input gain: The easy (but less accurate ...

  • Nilfisk-ALTO ADP152 - page 8

    See how far you can take the volume control before the signal begins to clip (you may need to reduce the amp gain if it gets too loud). If you see it clip on the scope, back off the volume control a little. Now increase the gain on the amp until you find the highest level before distortion or visible clipping. Bear in mind that the maximum level ma ...

  • Nilfisk-ALTO ADP152 - page 9

    8 LTO LTO TM Although commonly referred to as a "digital" amplifier, C lass-D is more accurately described as a Pulse Width Modulated (PWM) amplifier. A PWM amplifier converts the music (which is a complex arrangement of sine waves) into a series of pulses. The major benefit of this design is its great efficien cy , which is the relations ...

  • Nilfisk-ALTO ADP152 - page 10

    9 LTO LTO TM Further Information For additional information, please visit our website at www.alto mobile.com , which includes a technical discussion forum where users can exchange ideas. Troubleshooting Power LED not lit : Is the Remote switch cable from the source unit (Cassette or CD Player) attached to the REM terminal of the ADP amplifier, and ...

  • Nilfisk-ALTO ADP152 - page 11

    10 T o be protected by this warranty , the buyer must be able to produce a numbered, machine printed sales receipt from his supplying dealer that clearly shows the dealer's name and address, the buyer's name and address, purchase date, model and serial number of the product. AL TO warrants the mechanical and electronic components of this ...

  • Nilfisk-ALTO ADP152 - page 12

    11 LTO LTO TM ADP102 Power Output (RMS, 4 ohms): THD: Residual Noise: Xover: Input Gain Range (MAX - MIN): Operating Voltage: Output Efficiency at Full Power: Protection Circuitry: Idle Current (no signal): Standby Current, REM input low: Size: 50W X 2 <0.05% @10Vrms 120uVrms (A-wtd) HP/ LP/ FLAT switchable. 50Hz - 500Hz, 12dB/oct. 400mV to > ...

  • Nilfisk-ALTO ADP152 - page 13

    12 ADP152 Power Output (RMS, 4 ohms): THD: Residual Noise: Xover: Input Gain Range (MAX - MIN): Operating Voltage: Output Efficiency at Full Power: Protection Circuitry: Idle Current (no signal): Standby Current, REM input low: Size: 75W X 2 <0.05% @10Vrms 120uVrms (A-wtd) HP/ LP/ FLAT switchable. 50Hz - 500Hz, 12dB/oct. 400mV to >15V 11 - 16 ...

  • Nilfisk-ALTO ADP152 - page 14

    NF01173-1.0 No. 1, Lane 17, Sec. 2, Han Shi W. Road, T aichung, 401 Taiwan http://www.altomobile.com T el: 886-4-22313737 email: info@altomobile.com Fax: 886-4-22346757 All rights reserved to AL TO Mobile. Due to continued development in response to customer feedback, product features, specifications and/or internal/external design may be changed w ...

Fabricant Nilfisk-ALTO Catégorie Stereo Amplifier

Les documents que nous recevons du fabricant de l'appareilNilfisk-ALTO ADP152 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Nilfisk-ALTO
- manuels d’utilisations ADP152
- fiches produit Nilfisk-ALTO
- dépliants
- ou étiquettes-énergie Nilfisk-ALTO ADP152
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Nilfisk-ALTO ADP152.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Nilfisk-ALTO ADP152, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Nilfisk-ALTO ADP152. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Nilfisk-ALTO ADP152.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Nilfisk-ALTO ADP152, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Nilfisk-ALTO ADP152 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Nilfisk-ALTO ADP152.

Le manuel d’utilisation complet Nilfisk-ALTO, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Nilfisk-ALTO ADP152 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Nilfisk-ALTO ADP152, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lNilfisk-ALTO ADP152 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Nilfisk-ALTO ADP152 - qui devraient nous aider dans les premières étapes lors de l'utilisation Nilfisk-ALTO ADP152
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Nilfisk-ALTO ADP152
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Nilfisk-ALTO ADP152 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Nilfisk-ALTO ADP152?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Nilfisk-ALTO ADP152, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Nilfisk-ALTO ADP152 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)