Bedienungsanleitung Honeywell CO48PM

22 Seiten Betrifft nicht
Download

Zur Seite of 22

Summary
  • Honeywell CO48PM - page 1

    Portable Evaporative Air Cooler for Outdoor, Indoor & Commercial Use OWNER’S MANUAL Read and save these instructions before use Model: CO48PM Power rating: 140 Watts Voltage rating: 120 Volt AC, 60Hz For product inquiries or support, visit www.honeywellaircoolers.com Made in P.R.C. Customer Support : 1-800-474-2147 OFF COOL ON OFF ON 0 3 2 1 ...

  • Honeywell CO48PM - page 2

    QUICK START GUIDE Fill with water and plug into a standard power outlet. Place near an open door or window. Note : Evaporative air cooler requires cross ventilation. Turn ON and enjoy the cooling breeze. Note: Start with LOW speed and gradually increase to higher speed for optimum cooling performance. Note: Please make sure the household power volt ...

  • Honeywell CO48PM - page 3

    SECTION PAGE 1. THANK YOU ......................................................................................................... 2. USER TIPS ........................................................................................................... 3. SAFETY ....................................................................................... ...

  • Honeywell CO48PM - page 4

    2 THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location (Important - Please Read!) Place the cooler in front of an open door or window. Ensure ...

  • Honeywell CO48PM - page 5

    3 USER TIPS Energy Efficient, No Compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler and enters the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media. As the warm air passes through the media, the water absorbs the heat, naturally ...

  • Honeywell CO48PM - page 6

    4 USER TIPS Indoor Use The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low. The evaporative air cooler should not be used in enclosed spaces. It must be kept level and ther ...

  • Honeywell CO48PM - page 7

    5 SAFETY Read And Save These Instructions: When using electrical appliances, basic safety precautions should always be followed: OFF C OOL ON OFF ON 0 3 2 1 SPEED S WING MAX MIN 120V - 60 Hz Shock Hazard Water Level Indicator Your cooler runs on 120 Volt AC, 60 Hz current. Check the household voltage to ensure it matches the appliance's rate s ...

  • Honeywell CO48PM - page 8

    6 SAFETY DO NOT attempt to repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage. DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the product and could cause an electrical ...

  • Honeywell CO48PM - page 9

    7 SAFETY Don't use indoor extension cords outside. Look for extension cords specifically marked for outdoor use. Look for extension cords that have a GFCI (Ground Fault Circuit Interrupter) built in. Make sure the amperage rating for the extension cord is higher than the amperage rating for the appliance. Check labels and owner's manuals ...

  • Honeywell CO48PM - page 10

    8 PARTS DESCRIPTION OFF COOL ON OF F ON 0 3 2 1 SPEED SWING MAX MIN 10 1 Water Inlet and Ice Loading Compartment 2 Handle 3 Left Honeycomb Panel 4 Lever for Horizontal Louvers 5 Water Tank 6 Casters 7 Horizontal Louvers 8 Water Level Indicator 9 Control Panel 10 Right Honeycomb Panel 11 Continuous Water Supply Connection 12 Drain Plug 13 Backside H ...

  • Honeywell CO48PM - page 11

    9 USE & OPERATION Control Panel COOL SPEED SWING OFF ON OFF ON 0 3 2 1 NOTE: Speed control may be marked as High / Med / Low in certain units. ...

  • Honeywell CO48PM - page 12

    Speed / On - Off Connect to the power supply and turn the Speed knob. The fan will start. Change the speed from 1 for Low to 2 for Medium to 3 High. To switch OFF the unit turn the Speed know to "0". Cool To begin cooling the desired area turn the "COOL" switch ON. The water pump will operate. You can feel the cooler air after t ...

  • Honeywell CO48PM - page 13

    To refill the water tank, pull out the Water Fill Door located on the top of the unit (#16 on Page 8) and fill water to the Max, as indicated on the Water Level Indicator (#8 on Page 8). Do not fill water above the Max water level mark. For maximum cooling performance, put ice cubes inside the Ice Loading Compartment located on the top of the Air C ...

  • Honeywell CO48PM - page 14

    • • • • • Securely connect the continuous water supply connector (located on the lower left side panel #11 on Page 8) to the water supply. Turn on the water. The water tank will refill automatically. The water float valve will detect the water level and will automatically start or stop the water flow. Plug the unit into the power supply a ...

  • Honeywell CO48PM - page 15

    • • • • The cooler is supplied with Honeycomb Cooling Media. The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow. Draining the water reservoir and refilling with fresh ...

  • Honeywell CO48PM - page 16

    • • • • • • • Turn the power “off” and disconnect the air cooler from the power supply. Move the unit to a location where it can be drained. Remove the drain plug and allow the tank to empty(#12 on Page 8). Refill the water tank up to the maximum level with clean water and drain it completely. Fill water tank and rinse at least 2- ...

  • Honeywell CO48PM - page 17

    15 TROUBLESHOOTING GUIDE Customer Support: 1-800-474-2147 No discharge of air Cord is not plugged in. Power is not on. Not Cooling / Unit is making noise Pump is not turned ON. Refill water tank. Odors When the Cooler is new. If the Cooler has been used. Contact service center. PROBLEM POSSIBLE CAUSE SOLUTION Make sure power cord is plugged in and ...

  • Honeywell CO48PM - page 18

    16 TECHNICAL SPECIFICATIONS MODEL NO. CO48PM 120 V 60 Hz 140 Watts 12.6 Gallon Honeycomb 24.40(L) X 14.76(W) X 34.17(H) 29.3 lbs Voltage Frequency Wattage Water Tank Capacity 1.83A Ampere Cooling Media Product Dimension (inches) Net Weight ...

  • Honeywell CO48PM - page 19

    17 ELECTRICAL WIRING DIAGRAM ...

  • Honeywell CO48PM - page 20

    1-YEAR LIMITED WARRANTY Read all the instructions before attempting to use this product. This 1 year limited warranty applies to repair or replacement product found to be defective in material or workmanship This warranty does not apply to any damage resulting from commercial, abusive, unreasonable use or supplemental damage. Defects that are the r ...

  • Honeywell CO48PM - page 21

    19 SERVICE AND WARRANTY Please read the Instruction Manual carefully before setting up or using this product. If you believe this product to be suffering from a manufacturing fault, or if you have inquiries about this product, please contact our Customer Support: CUSTOMER SUPPORT JMA North America LLC Ramsey, New Jersey, 07446. Phone : 800-474-2147 ...

  • Honeywell CO48PM - page 22

    © 2012 AirTek International Corporation Limited The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representation or warranties with respect to this product. Manufactured by AirTek International Corporation Limited. CO48PM_IM_Eng_Spa_USA(lowes)_7 November 2012 Distributor: JMA Nort ...

Produzent Honeywell Kategorie Air-conditioning

Dokumente, die wir vom Produzenten des Geräts Honeywell CO48PM erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Honeywell
- Bedienungsanleitungen CO48PM
- Produktkarten Honeywell
- Informationsbroschüren
- oder Energieetiketten Honeywell CO48PM
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Honeywell CO48PM.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Honeywell CO48PM, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Honeywell CO48PM. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Honeywell CO48PM ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Honeywell CO48PM, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Honeywell CO48PM hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Honeywell CO48PM verständlich ist.

Eine gänzliche Bedienungsanleitung von Honeywell sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Honeywell CO48PM bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Honeywell CO48PM befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Honeywell CO48PM, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Honeywell CO48PM - die uns die ersten Schritte während der Nutzung von Honeywell CO48PM erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Honeywell CO48PM hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Honeywell CO48PM im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Honeywell CO48PM?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Honeywell CO48PM nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Honeywell CO48PM hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)