Manuel d’utilisation Honeywell CO48PM

22 pages Non applicable
Télécharger

Aller à la page of 22

Summary
  • Honeywell CO48PM - page 1

    Portable Evaporative Air Cooler for Outdoor, Indoor & Commercial Use OWNER’S MANUAL Read and save these instructions before use Model: CO48PM Power rating: 140 Watts Voltage rating: 120 Volt AC, 60Hz For product inquiries or support, visit www.honeywellaircoolers.com Made in P.R.C. Customer Support : 1-800-474-2147 OFF COOL ON OFF ON 0 3 2 1 ...

  • Honeywell CO48PM - page 2

    QUICK START GUIDE Fill with water and plug into a standard power outlet. Place near an open door or window. Note : Evaporative air cooler requires cross ventilation. Turn ON and enjoy the cooling breeze. Note: Start with LOW speed and gradually increase to higher speed for optimum cooling performance. Note: Please make sure the household power volt ...

  • Honeywell CO48PM - page 3

    SECTION PAGE 1. THANK YOU ......................................................................................................... 2. USER TIPS ........................................................................................................... 3. SAFETY ....................................................................................... ...

  • Honeywell CO48PM - page 4

    2 THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location (Important - Please Read!) Place the cooler in front of an open door or window. Ensure ...

  • Honeywell CO48PM - page 5

    3 USER TIPS Energy Efficient, No Compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler and enters the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media. As the warm air passes through the media, the water absorbs the heat, naturally ...

  • Honeywell CO48PM - page 6

    4 USER TIPS Indoor Use The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low. The evaporative air cooler should not be used in enclosed spaces. It must be kept level and ther ...

  • Honeywell CO48PM - page 7

    5 SAFETY Read And Save These Instructions: When using electrical appliances, basic safety precautions should always be followed: OFF C OOL ON OFF ON 0 3 2 1 SPEED S WING MAX MIN 120V - 60 Hz Shock Hazard Water Level Indicator Your cooler runs on 120 Volt AC, 60 Hz current. Check the household voltage to ensure it matches the appliance's rate s ...

  • Honeywell CO48PM - page 8

    6 SAFETY DO NOT attempt to repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage. DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the product and could cause an electrical ...

  • Honeywell CO48PM - page 9

    7 SAFETY Don't use indoor extension cords outside. Look for extension cords specifically marked for outdoor use. Look for extension cords that have a GFCI (Ground Fault Circuit Interrupter) built in. Make sure the amperage rating for the extension cord is higher than the amperage rating for the appliance. Check labels and owner's manuals ...

  • Honeywell CO48PM - page 10

    8 PARTS DESCRIPTION OFF COOL ON OF F ON 0 3 2 1 SPEED SWING MAX MIN 10 1 Water Inlet and Ice Loading Compartment 2 Handle 3 Left Honeycomb Panel 4 Lever for Horizontal Louvers 5 Water Tank 6 Casters 7 Horizontal Louvers 8 Water Level Indicator 9 Control Panel 10 Right Honeycomb Panel 11 Continuous Water Supply Connection 12 Drain Plug 13 Backside H ...

  • Honeywell CO48PM - page 11

    9 USE & OPERATION Control Panel COOL SPEED SWING OFF ON OFF ON 0 3 2 1 NOTE: Speed control may be marked as High / Med / Low in certain units. ...

  • Honeywell CO48PM - page 12

    Speed / On - Off Connect to the power supply and turn the Speed knob. The fan will start. Change the speed from 1 for Low to 2 for Medium to 3 High. To switch OFF the unit turn the Speed know to "0". Cool To begin cooling the desired area turn the "COOL" switch ON. The water pump will operate. You can feel the cooler air after t ...

  • Honeywell CO48PM - page 13

    To refill the water tank, pull out the Water Fill Door located on the top of the unit (#16 on Page 8) and fill water to the Max, as indicated on the Water Level Indicator (#8 on Page 8). Do not fill water above the Max water level mark. For maximum cooling performance, put ice cubes inside the Ice Loading Compartment located on the top of the Air C ...

  • Honeywell CO48PM - page 14

    • • • • • Securely connect the continuous water supply connector (located on the lower left side panel #11 on Page 8) to the water supply. Turn on the water. The water tank will refill automatically. The water float valve will detect the water level and will automatically start or stop the water flow. Plug the unit into the power supply a ...

  • Honeywell CO48PM - page 15

    • • • • The cooler is supplied with Honeycomb Cooling Media. The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow. Draining the water reservoir and refilling with fresh ...

  • Honeywell CO48PM - page 16

    • • • • • • • Turn the power “off” and disconnect the air cooler from the power supply. Move the unit to a location where it can be drained. Remove the drain plug and allow the tank to empty(#12 on Page 8). Refill the water tank up to the maximum level with clean water and drain it completely. Fill water tank and rinse at least 2- ...

  • Honeywell CO48PM - page 17

    15 TROUBLESHOOTING GUIDE Customer Support: 1-800-474-2147 No discharge of air Cord is not plugged in. Power is not on. Not Cooling / Unit is making noise Pump is not turned ON. Refill water tank. Odors When the Cooler is new. If the Cooler has been used. Contact service center. PROBLEM POSSIBLE CAUSE SOLUTION Make sure power cord is plugged in and ...

  • Honeywell CO48PM - page 18

    16 TECHNICAL SPECIFICATIONS MODEL NO. CO48PM 120 V 60 Hz 140 Watts 12.6 Gallon Honeycomb 24.40(L) X 14.76(W) X 34.17(H) 29.3 lbs Voltage Frequency Wattage Water Tank Capacity 1.83A Ampere Cooling Media Product Dimension (inches) Net Weight ...

  • Honeywell CO48PM - page 19

    17 ELECTRICAL WIRING DIAGRAM ...

  • Honeywell CO48PM - page 20

    1-YEAR LIMITED WARRANTY Read all the instructions before attempting to use this product. This 1 year limited warranty applies to repair or replacement product found to be defective in material or workmanship This warranty does not apply to any damage resulting from commercial, abusive, unreasonable use or supplemental damage. Defects that are the r ...

  • Honeywell CO48PM - page 21

    19 SERVICE AND WARRANTY Please read the Instruction Manual carefully before setting up or using this product. If you believe this product to be suffering from a manufacturing fault, or if you have inquiries about this product, please contact our Customer Support: CUSTOMER SUPPORT JMA North America LLC Ramsey, New Jersey, 07446. Phone : 800-474-2147 ...

  • Honeywell CO48PM - page 22

    © 2012 AirTek International Corporation Limited The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representation or warranties with respect to this product. Manufactured by AirTek International Corporation Limited. CO48PM_IM_Eng_Spa_USA(lowes)_7 November 2012 Distributor: JMA Nort ...

Fabricant Honeywell Catégorie Air-conditioning

Les documents que nous recevons du fabricant de l'appareilHoneywell CO48PM peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Honeywell
- manuels d’utilisations CO48PM
- fiches produit Honeywell
- dépliants
- ou étiquettes-énergie Honeywell CO48PM
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Honeywell CO48PM.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Honeywell CO48PM, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Honeywell CO48PM. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Honeywell CO48PM.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Honeywell CO48PM, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Honeywell CO48PM par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Honeywell CO48PM.

Le manuel d’utilisation complet Honeywell, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Honeywell CO48PM - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Honeywell CO48PM, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lHoneywell CO48PM qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Honeywell CO48PM - qui devraient nous aider dans les premières étapes lors de l'utilisation Honeywell CO48PM
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Honeywell CO48PM
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Honeywell CO48PM dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Honeywell CO48PM?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Honeywell CO48PM, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Honeywell CO48PM il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)