Bedienungsanleitung Dimplex WB15

13 Seiten 0.08 mb
Download

Zur Seite of 13

Summary
  • Dimplex WB15 - page 1

    AUTO-FILL WATER BOILERS INSTRUCTION MANUAL MODELS COVERED WB3 WB7 WB15 WB5E 1 ...

  • Dimplex WB15 - page 2

    2 IMPORTANT HEALTH AND SAFETY INFORMATION PLEASE READ BEFORE USING YOUR NEW WATER BOILER Your new water boiler is designed to pr ovide a constant source of near boiling water for the preparation of hot drinks. THIS IS VERY HOT All personnel must be provided with suffi cient and appropriate training in the safe use of this appliance. An instruction ...

  • Dimplex WB15 - page 3

    3 INTRODUCTION Your new water boiler is designed to give years of trouble free service provided that the instructions contained in this manual are followed carefully. Your new boiler is energy efficient, si mple to operate and easy to service. It is recommended that the installation is ca rried out by a properly qualified fitter. CHECK LIST Before ...

  • Dimplex WB15 - page 4

    4 WARNING: THIS APPLIANCE MUST BE EARTHED REAR ENTRY OF CABLE Fixed or flexible ca ble to be connected direct to t he terminal block, cable gland not utilised. BOTTOM ENTRY OF CABLE Use the cable gland. Loos en cable-gripping nut. Pass cable through gland, leaving enough free cable to connect into the terminal block. Tighten cable gland grip nut. D ...

  • Dimplex WB15 - page 5

    5 BOTTOM ENTRY Connect to a suitable cold drinking water supply using 15mm copper pipe and push on the ‘T’ piece supplied. The ‘T’ has been blanked off using a brass plug. Leave this plug in place. Push the ‘T’ piece firmly onto the water inlet solenoid pipe with the brass plug facing forward. Then push the 15mm cold water supply firmly ...

  • Dimplex WB15 - page 6

    6 OVERFLOW PIPE REAR ENTRY In your fitting kit you will find a straight push on connector wit h a small length of 15mm copper tube pushed into it. If rear entry has been chosen this connec tor must be replaced by a push on elbow (available from plum ber’s merchants). Push the elbow onto the overflow pipe on the bracket (alongside the solenoid). T ...

  • Dimplex WB15 - page 7

    7 OPERATION (All models except WB5E) After the electrical and water connecti ons have been made, switch the power and water supply on. The power and ready lights will flash once. The power light will then be constantly illuminated to indicate mains supply. Providing the water supply is present, the ma chine will start to fill. If the machine does n ...

  • Dimplex WB15 - page 8

    8 OPERATION (WB5Eonly) After the electrical and water connecti ons have been made, switch the power and water supply on. When the power supply is switched on, t he small indicator lamp on the front panel will glow orange. This means that t he water is filling to the bottom probe. When the bottom probe has been reached, the indicator lamp will chang ...

  • Dimplex WB15 - page 9

    9 TECHNICAL SPECIFICATION ALL MODELS Tank constructed in stainless steel. Tank insulated from outer casi ng with high temper ature polystyrene. All boilers have electronic control of t he main functions. This means that the temperature is controlled precisely within given parameters. The circuit constantly monitors the operation of the machine and ...

  • Dimplex WB15 - page 10

    10 DE-SCALING All m odels except WB5E To de-scale your machine, first disconnec t the machine from the power supply. Remove the case by removing the top and bottom screws hol ding the case to the wall bracket. Drain the remaining water through the drain plug in the bottom of the tank. Remove the boiler lid by unscrewing t he fixing screws. The tank ...

  • Dimplex WB15 - page 11

    11 Clean the level sensing probes and their white holders completely using a clean non-metallic scourer. Ensure all traces of de-scaler are removed before using the boiler again. Rather than frequently de-scalin g the machine, it may be preferable to install an effective scale reducer or WRC appr oved food quality water softener. This will reduce t ...

  • Dimplex WB15 - page 12

    12 SERVICE WARNING LIGHT (All Models except WB5E) All models except WB5E have this facility. This light is designed to help you discover the cause of any malfunction. If the circuit senses a problem, the service light will flash a number of times and then pause and repeat this sequence. Count the number of flashes between pauses and refer to the ta ...

  • Dimplex WB15 - page 13

    13 fallen to a point at which the heating element(s) could be damaged. If in order call service department on 01704 502911 Quoting the Serial Number 12 The machine has over-boiled and the level has fallen to a point at which the element(s) could be damaged. Or safety cut out has come into operation see paragraphs re Temperature Control Call service ...

Produzent Dimplex Kategorie Water Heater

Dokumente, die wir vom Produzenten des Geräts Dimplex WB15 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Dimplex
- Bedienungsanleitungen WB15
- Produktkarten Dimplex
- Informationsbroschüren
- oder Energieetiketten Dimplex WB15
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Dimplex WB15.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Dimplex WB15, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Dimplex WB15. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Dimplex WB15 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Dimplex WB15, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Dimplex WB15 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Dimplex WB15 verständlich ist.

Eine gänzliche Bedienungsanleitung von Dimplex sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Dimplex WB15 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Dimplex WB15 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Dimplex WB15, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Dimplex WB15 - die uns die ersten Schritte während der Nutzung von Dimplex WB15 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Dimplex WB15 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Dimplex WB15 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Dimplex WB15?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Dimplex WB15 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Dimplex WB15 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)