Manuel d’utilisation Dimplex WB15

13 pages 0.08 mb
Télécharger

Aller à la page of 13

Summary
  • Dimplex WB15 - page 1

    AUTO-FILL WATER BOILERS INSTRUCTION MANUAL MODELS COVERED WB3 WB7 WB15 WB5E 1 ...

  • Dimplex WB15 - page 2

    2 IMPORTANT HEALTH AND SAFETY INFORMATION PLEASE READ BEFORE USING YOUR NEW WATER BOILER Your new water boiler is designed to pr ovide a constant source of near boiling water for the preparation of hot drinks. THIS IS VERY HOT All personnel must be provided with suffi cient and appropriate training in the safe use of this appliance. An instruction ...

  • Dimplex WB15 - page 3

    3 INTRODUCTION Your new water boiler is designed to give years of trouble free service provided that the instructions contained in this manual are followed carefully. Your new boiler is energy efficient, si mple to operate and easy to service. It is recommended that the installation is ca rried out by a properly qualified fitter. CHECK LIST Before ...

  • Dimplex WB15 - page 4

    4 WARNING: THIS APPLIANCE MUST BE EARTHED REAR ENTRY OF CABLE Fixed or flexible ca ble to be connected direct to t he terminal block, cable gland not utilised. BOTTOM ENTRY OF CABLE Use the cable gland. Loos en cable-gripping nut. Pass cable through gland, leaving enough free cable to connect into the terminal block. Tighten cable gland grip nut. D ...

  • Dimplex WB15 - page 5

    5 BOTTOM ENTRY Connect to a suitable cold drinking water supply using 15mm copper pipe and push on the ‘T’ piece supplied. The ‘T’ has been blanked off using a brass plug. Leave this plug in place. Push the ‘T’ piece firmly onto the water inlet solenoid pipe with the brass plug facing forward. Then push the 15mm cold water supply firmly ...

  • Dimplex WB15 - page 6

    6 OVERFLOW PIPE REAR ENTRY In your fitting kit you will find a straight push on connector wit h a small length of 15mm copper tube pushed into it. If rear entry has been chosen this connec tor must be replaced by a push on elbow (available from plum ber’s merchants). Push the elbow onto the overflow pipe on the bracket (alongside the solenoid). T ...

  • Dimplex WB15 - page 7

    7 OPERATION (All models except WB5E) After the electrical and water connecti ons have been made, switch the power and water supply on. The power and ready lights will flash once. The power light will then be constantly illuminated to indicate mains supply. Providing the water supply is present, the ma chine will start to fill. If the machine does n ...

  • Dimplex WB15 - page 8

    8 OPERATION (WB5Eonly) After the electrical and water connecti ons have been made, switch the power and water supply on. When the power supply is switched on, t he small indicator lamp on the front panel will glow orange. This means that t he water is filling to the bottom probe. When the bottom probe has been reached, the indicator lamp will chang ...

  • Dimplex WB15 - page 9

    9 TECHNICAL SPECIFICATION ALL MODELS Tank constructed in stainless steel. Tank insulated from outer casi ng with high temper ature polystyrene. All boilers have electronic control of t he main functions. This means that the temperature is controlled precisely within given parameters. The circuit constantly monitors the operation of the machine and ...

  • Dimplex WB15 - page 10

    10 DE-SCALING All m odels except WB5E To de-scale your machine, first disconnec t the machine from the power supply. Remove the case by removing the top and bottom screws hol ding the case to the wall bracket. Drain the remaining water through the drain plug in the bottom of the tank. Remove the boiler lid by unscrewing t he fixing screws. The tank ...

  • Dimplex WB15 - page 11

    11 Clean the level sensing probes and their white holders completely using a clean non-metallic scourer. Ensure all traces of de-scaler are removed before using the boiler again. Rather than frequently de-scalin g the machine, it may be preferable to install an effective scale reducer or WRC appr oved food quality water softener. This will reduce t ...

  • Dimplex WB15 - page 12

    12 SERVICE WARNING LIGHT (All Models except WB5E) All models except WB5E have this facility. This light is designed to help you discover the cause of any malfunction. If the circuit senses a problem, the service light will flash a number of times and then pause and repeat this sequence. Count the number of flashes between pauses and refer to the ta ...

  • Dimplex WB15 - page 13

    13 fallen to a point at which the heating element(s) could be damaged. If in order call service department on 01704 502911 Quoting the Serial Number 12 The machine has over-boiled and the level has fallen to a point at which the element(s) could be damaged. Or safety cut out has come into operation see paragraphs re Temperature Control Call service ...

Fabricant Dimplex Catégorie Water Heater

Les documents que nous recevons du fabricant de l'appareilDimplex WB15 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Dimplex
- manuels d’utilisations WB15
- fiches produit Dimplex
- dépliants
- ou étiquettes-énergie Dimplex WB15
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Dimplex WB15.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Dimplex WB15, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Dimplex WB15. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Dimplex WB15.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Dimplex WB15, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Dimplex WB15 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Dimplex WB15.

Le manuel d’utilisation complet Dimplex, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Dimplex WB15 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Dimplex WB15, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lDimplex WB15 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Dimplex WB15 - qui devraient nous aider dans les premières étapes lors de l'utilisation Dimplex WB15
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Dimplex WB15
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Dimplex WB15 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Dimplex WB15?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Dimplex WB15, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Dimplex WB15 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)