-
Heat Controller 13 SEER - page 1
SPLIT SYSTEM AIR CONDITIONER USER’S MANU AL / INST ALLA TION INSTR UCTIONS R-22, 13 SEER USER INFORMA TION IMPORT ANT SAFETY INFORMA TION ................. 2 OPERA TING INSTRUCTIONS ............................... 2 Cooling Operation ................................................. 2 Heating Operation ............................................ ...
-
Heat Controller 13 SEER - page 2
2 IMPORT ANT SAFETY INFORMA TION Saf ety markings are used frequently throughout this manual to designate a degree or lev el of seriousness and should not be ignored. W ARNING indicates a potentially hazardous situation that if not av oided, could result in personal injur y or death. CA UTION indicates a potentially hazardous situation that if not ...
-
Heat Controller 13 SEER - page 3
3 INST ALLER INFORMA TION IMPORT ANT SAFETY INFORMA TION INST ALLER: Please read all instructions before servicing this equipment. Pay attention to all safety warnings and any other special notes highlighted in the manual. Saf ety markings are used frequently throughout this manual to designate a degree or le v el of seriousness and should not be i ...
-
Heat Controller 13 SEER - page 4
4 AIR CONDITIONER INST ALLA TION General Information Split system air conditioners are designed only f or outdoor rooftop or ground le v el installations. This unit has been tested f or capacity and efficiency in accordance with AHRI Standards and will provide man y years of saf e and dependable comf ort, providing it is properly installed and mai ...
-
Heat Controller 13 SEER - page 5
5 Connecting Refrigerant T ubing Between the Indoor & Outdoor Unit CA UTION: This system uses R-22 refrigerant which may contain POE oil. When servicing, co ver or seal openings to minimize the exposure of the refrigerant system to air to prevent accum ulation of moisture and other contaminants. See page 8 for ad ditional info. After outdoor an ...
-
Heat Controller 13 SEER - page 6
6 • The outdoor unit requires both power and control circuit electrical connections. Refer to the wiring diagram / schematic f or identification and location of outdoor unit field wiring interfaces (Figure 11, page 17). Make all electrical connections in accordance with all applicable codes and ordinances. • O ...
-
Heat Controller 13 SEER - page 7
7 System Cooling 1. Set the ther mostat’ s system mode to COOL and the f an mode to A UT O. Gradually low er the ther mostat temperature setpoint belo w room temperature and v erify the outdoor unit and indoor blower energiz e. 2. V erify blow er wheel is spinning in direction indicated by arrow . Feel the air being circu lated by the indo or blo ...
-
Heat Controller 13 SEER - page 8
8 CA UTION: The unit should never be operated without a filter in the return air system. Replace disposable filters with the same type and size. • Do not attempt to add additional oil to motors unequipped with oil tubes. The compressor is her metically sealed at the f actor y and does not require lubrication. REPLA ...
-
Heat Controller 13 SEER - page 9
9 TXV COOLING CHARGING CHARTS 140 160 180 200 220 240 260 280 300 320 340 360 380 400 75 80 85 90 95 100 105 110 115 120 125 130 135 Liquid Te mperature (F ) Liquid Pressure (psig) Add re fr igerant w hen below curve Re mo ve re fr igerant w hen above curv e Figure 4. Char ging Char t f or 1.5 T on Units Figure 3. Unit Dimensions Unit Size (T on) H ...
-
Heat Controller 13 SEER - page 10
10 Figure 5. Char ging Char t f or 2 T on Units (with Microchannel Coil) 140 160 180 200 220 240 260 280 300 320 340 360 380 400 75 80 85 90 95 100 105 110 115 120 125 130 135 Liquid Te mperature (F ) Liquid Pressure (psig) Add re fr igerant w hen below curve Re mo ve re fr igerant w hen above curv e Figure 6. Char ging Char t f or 2.5 T on Units ( ...
-
Heat Controller 13 SEER - page 11
11 Figure 7. Char ging Char t f or 3 T on Units (with Microchannel Coil) 140 160 180 200 220 240 260 280 300 320 340 360 380 400 75 80 85 90 95 100 105 110 115 120 125 130 135 Liquid Te mperature (F ) Liquid Pressure (psig) Add re fr igerant w hen below curve Re mo ve re fr igerant w hen above curv e Figure 8. Char ging Char t f or 3.5 T on Units 1 ...
-
Heat Controller 13 SEER - page 12
12 Figure 9. Char ging Char t f or 4 T on Units 140 160 180 200 220 240 260 280 300 320 340 360 380 400 75 80 85 90 95 100 105 110 115 120 125 130 135 Liquid Te mperature (F ) Liquid Pressure (psig) Add re fr igerant when below curve Re mo ve re fr igerant w hen above curv e Figure 10. Char ging Char t f or 5 T on Units 140 160 180 200 220 240 260 ...
-
Heat Controller 13 SEER - page 13
13 FIGURES & T ABLES Shaded bo x es indicate flooded conditions. Rated design v alues. The suction pressure will v ar y from design v alue if indoor air flo w , entering dry bulb , or entering wet bulb temperatures are lo wer than design. 1. All pressures are listed in psig and all temperatures in ° F 2. Discharge temperatures greater than c ...
-
Heat Controller 13 SEER - page 14
14 Shaded bo x es indicate flooded conditions. Rated design values . The suction pressure will v ar y from design v alue if indoor air flo w , entering dry bulb , or entering wet bulb temperatures are lo wer than design. 1. All pressures are listed in psig and all temperatures in ° F 2. Discharge temperatures greater than char ted v alues indica ...
-
Heat Controller 13 SEER - page 15
15 Shaded bo x es indicate flooded conditions. Rated design values . The suction pressure will v ar y from design v alue if indoor air flo w , entering dry bulb , or entering wet bulb temperatures are lo wer than design. 1. All pressures are listed in psig and all temperatures in ° F 2. Discharge temperatures greater than char ted v alues indica ...
-
Heat Controller 13 SEER - page 16
16 T able 10. Char ging T able for 5 T on Units Suct. Press. OUTDOOR TEMPERA TURE (° F) 70 75 80 85 90 95 100 105 Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. Liq. Press. Dis. T emp. 68 149 141 70 151 146 166 146 72 154 151 16 ...
-
Heat Controller 13 SEER - page 17
17 Figure 11. Wiring Diagram Single Phase 1. Couper le courant av ant de f aire letretien. 2. Emplo yez uniquement des conducteurs en cuivr e. 3. Ne con vient pas aux installations de plus de 150 volt a la terre . 710570B (Replaces 710570A) 0109 WIRING DIA GRAM Split System Air Conditioner (Outdoor Section) NO TES: 1. Disconnect all power bef ore s ...
-
Heat Controller 13 SEER - page 18
18 ...
-
Heat Controller 13 SEER - page 19
19 ...
-
Heat Controller 13 SEER - page 20
W ARRANTY INFORMA TION A warr anty cer tificate with full details is included with the air conditioner . Carefully re view these responsibilities with your dealer or service company . The manuf acturer will not be responsible f or an y costs f ound necessar y to correct problems due to improper setup , improper installation, adjustments, improper ...
¿Tienes una pregunta acerca de Heat Controller 13 SEER?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Heat Controller 13 SEER, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Heat Controller 13 SEER probablemente compartirá una forma de solucionarlo.