-
Philips F-2200 Series - page 1
F-2200 Series V ortex Flow Meter Installation and Operation Guide For software version CF 4.7 and higher 1500 North Belcher Road • Clearwater , FL 33765 • T el (727) 447-6140 • Fax (727) 442-5699 www .onicon.com • sales@onicon.com 12-15-08 ...
-
Philips F-2200 Series - page 2
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 3 SAFETY INFORMA TION This meter was calibrated at the factory before shipment. T o ensure correct use of the meter , please read this manual thoroughly . Regarding This Manual: • This manual should be passed on to the end user . • Before use, read this manual t ...
-
Philips F-2200 Series - page 3
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 4 F-2200 Series V ortex Flow Meter Installation and Operation Guide Addendum December 12, 2008 CAUTION Insulating the entire neck of the ow meter will increase heat transfer to the electronics enclosure and may in some cases cause premature failure of the electr ...
-
Philips F-2200 Series - page 4
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 5 T ABLE OF CONTENTS 1.0 INTRODUCTION ............................................................................................................. .7 1.1 Purpose of This Guide ......................................................................................... ...
-
Philips F-2200 Series - page 5
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 6 ...
-
Philips F-2200 Series - page 6
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 7 SECTION 1.0: INTRODUCTION W e, at ONICON INCORPORA TED, would like to thank you for purchasing our F-2200 Series V ortex Flow Meter . As our valued customer , our commitment to you is to provide fast reliable service and assistance, while continuing to offer you n ...
-
Philips F-2200 Series - page 7
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 8 ACCURACY V olumetric ow ±1% of reading accuracy (±2% for ¾” & smaller sizes) Mass ow ±1.5% of reading accuracy (±2.5% for ¾” & smaller sizes) OPERA TING TEMPERA TURE RANGE Media temperature 25° to 464° F Ambient temperature 0° to 132° ...
-
Philips F-2200 Series - page 8
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 9 1.4 ADDITIONAL REQUIRED MA TERIALS Installer is responsible for providing suitable anges and fasteners to connect the meter to the process piping. In addition, most installations will also require one reducer , one expander , pipe supports and a suf cient l ...
-
Philips F-2200 Series - page 9
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 10 SECTION 2.0: UNP ACKING F-2000 series vortex ow meters are shipped in one package. Additional items, if ordered, will be shipped in separate packaging. All shipments are insured for damage in transit. Carefully inspect each package and notify the freight carr ...
-
Philips F-2200 Series - page 10
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 11 SECTION 3.0: INST ALLA TION INFORMA TION The F-2000 series vortex ow meter must be installed by a technician quali ed to work with pressurized liquid, steam and/or gas ow and must conform to all federal, state and local building codes. ONICON will be h ...
-
Philips F-2200 Series - page 11
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 12 The diagrams shown below illustrate the correct meter orientation for vertical and horizontal pipe. Nominal Meter Size (in.) Meter Body Diameter (in.) Maximum Pipe ID Difference (in.) 1” 1.05 0.016 1 1/2” 1.61 0.016 2” 2.07 0.024 3” 3.07 0.024 4” 4.03 0 ...
-
Philips F-2200 Series - page 12
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 13 3.1.3 Straight, Unimpeded Inlet And Outlet Runs D = Meter Size (Nominal diameter in inches) W ith a ow straightener , the inlet pipe length may be reduced by 50%. For example, with a control valve upstream, the inlet length is 25D instead of 50D. The minimum ...
-
Philips F-2200 Series - page 13
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 14 3.1.5 Locating The Meter In A Pipline That Runs Parallel T o A W all Wherever possible, the distance between the pipe centerline and the wall should be greater than 20”. This will allow for access to the electronics enclosure compartment where wire terminations ...
-
Philips F-2200 Series - page 14
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 15 3.2 MECHANICAL INST ALLA TION 3.2.1 Orient The Display For Convenient V iewing Both the electronics enclosure and the display itself can be rotated to four different orientations to change the viewing angle for the display . If necessary , this should be done bef ...
-
Philips F-2200 Series - page 15
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 16 3.2.1.2 Rotating the display T o rotate the display , rst unscrew the cover using the special tool provided for this purpose. Once the cover is removed, the (4) Philips head screws that secure the display are exposed. T o rotate the display , remove these scr ...
-
Philips F-2200 Series - page 16
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 17 3.3.2 T emperature Measurements ONICON F-2000 series vortex meters are supplied with an internal PT 1000 type RTD temperature sensor located within the shedder bar . This sensor provides an accurate temperature measurement at the point where the ow rate is be ...
-
Philips F-2200 Series - page 17
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 18 SECTION 4.0: ST ART UP AND TROUBLESHOOTING 4.1 ST ART UP When the power is applied to the F-2000 series vortex meter , alphanumeric characters will appear on the display . Initially , the meter will operate in a “TEST” mode where self diagnostic checks are pe ...
-
Philips F-2200 Series - page 18
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 19 4.3 OPERA TING THE DISPLA Y Please read the entire procedure before proceeding. W iring diagrams are located in the Appendix. A worksheet for checking off the following steps and recording measured values is located on the next page. i There are 3 user interface ...
-
Philips F-2200 Series - page 19
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 20 4.4 ERROR HANDLING The meter can detect errors in either the test or the measurement modes. When in the measurement mode, a blinking vertical bar will appear in the top left corner of the display indicating an error has been detected. If the error reporting funct ...
-
Philips F-2200 Series - page 20
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 21 REPORTED PROBLEM POSSIBLE SOLUTIONS A non-zero fl ow indi- cated when no actual fl ow is in the pipe. • Mains interference due to improper Earth ground connection. The protective Earth PE terminal should be properly grounded (see page 17). • Excessive mecha ...
-
Philips F-2200 Series - page 21
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 22 SECTION 5.0: FLOW STRAIGHTENER FOR VORTEX FLOW METERS DESCRIPTION The optional ow straightener accessory for ONICON F-2000 Series V ortex Flow Meters is a wafer -style ow conditioner that is designed to be installed between two recessed anges (provide ...
-
Philips F-2200 Series - page 22
F-2200 Series V ortex Flow Meter Installation and Operation Guide • Revised 12/08 23 OBSTRUCTION SEE TABLE 1 UPSTREAM DIMENSION B 2 DIAMETERS 5 DIAMETERS ONICON F-2000 SERIES STEAM METER, NOTE 1 300# ANSI FLANGE ECCENTRIC REDUCER, NOTE 2 FLOW STRAIGHTENER, NOTE 3 (600# ANSI FLANGE OPTNL) MINIMUM UPSTREAM PIPE RUN MINIMUM DOWNSTREAM PIPE RUN REQUI ...
¿Tienes una pregunta acerca de Philips F-2200 Series?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Philips F-2200 Series, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Philips F-2200 Series probablemente compartirá una forma de solucionarlo.