-
Wayne-Dalton 44 - page 1
GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...
-
Wayne-Dalton 44 - page 2
2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. TRACK ROLLERS (AS REQUIRED): A1. Short Stem T rack Rollers A2. Long Stem T rack Rollers A3. Sh ...
-
Wayne-Dalton 44 - page 3
I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...
-
Wayne-Dalton 44 - page 4
Weather seals & nails (If included) Strut clips (as required) Pull down rope (if included) Counterbalance lift cables (2) 5/16”-18 x 3-3/4” Eye bolts Lift handles (as required) Snubber cables Bottom corner brackets (as required) (2) Front cable lift sheaves (2) Sheave forks (as required) S-hooks (as required) 3 Hole clips (as required) (2) ...
-
Wayne-Dalton 44 - page 5
3 Section High Strutting Schedule Section T ype T ype Of Strut Location On Section T op (1) Short T op Of Section N/A Bottom Of section Intermediate I (1) Long T op Of Section N/A Bottom Of section Bottom N/A T op Of Section (1) Short Bottom Of section 4 Section High Strutting Schedule Section T ype T ype Of Strut Location On Section 2” Strut 3? ...
-
Wayne-Dalton 44 - page 6
INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . IMPORT ANT : WOOD DOORS MUST BE COMPLETEL Y FINISHED (3 TOT AL COATS, INCLUDING PRIMER COA T) PRIOR TO INST ALLA TION, ...
-
Wayne-Dalton 44 - page 7
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T ypical left hand bottom corner bracket Bottom section (1) 1/4” - 14 x 1” T amper resistant la ...
-
Wayne-Dalton 44 - page 8
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (2) 1/4” - 20 x 2 1/2” Carriage bolts and (2) 1/4” - 20 Flange hex nuts Long strut (if applic ...
-
Wayne-Dalton 44 - page 9
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com surface. Drill pilot holes, 1” deep into the top section using a 1/8” drill bit. IMPORT ANT : B ...
-
Wayne-Dalton 44 - page 10
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Center hinge(s) Left single graduated end hinge with typical short stem track roller Right single g ...
-
Wayne-Dalton 44 - page 11
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T op fixture slide(s) 5/16”-18 Hex nut(s) Horizontal track T rack roller T op section Rear Back ...
-
Wayne-Dalton 44 - page 12
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com TRACK: Bolt the front cable lift sheave to the first 13/32” hole in the horizontal track angle, ...
-
Wayne-Dalton 44 - page 13
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Front cable lift sheave Counterbalance lift cable 3 Hole clip Special knot Horizontal track angle C ...
-
Wayne-Dalton 44 - page 14
Door Arm Hookup T ools: Needle nose pliers At the center of the top section, measure horizontally from the top of center hinge to the bottom of strut. Using that dimension, measure and cut (2) pieces of perforated angles. Assemble the (2) pieces together using (2) 3/8” bolts and nuts (supplied by others). Now, secure to the top section using carr ...
-
Wayne-Dalton 44 - page 15
Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! An annual inspection of all the surfaces of your garage door(s) will reveal the extent of weather - ing and the possible need for refinishing. When the finish becomes eroded or thin, clean and prime any areas showing deterioration. Then completely refinish ...
-
Wayne-Dalton 44 - page 16
3. Lubrication: The door should open and close smoothly. Ensure the door track rollers are rotating freely when opening and closing the door . If track rollers do not rotate freely, clean the door tracks, removing dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) graduated end hinges, steel track rollers, spri ...
-
Wayne-Dalton 44 - page 17
Limited warranty Double Flush, Model 44 Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , against defects in material and workmanship, for a period of ONE (1) YEAR from the time of delivery provided: i) (i) The interior and exterior surfaces, as well as all ...
-
Wayne-Dalton 44 - page 18
AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...
¿Tienes una pregunta acerca de Wayne-Dalton 44?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Wayne-Dalton 44, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Wayne-Dalton 44 probablemente compartirá una forma de solucionarlo.