English dropdown-ico

Manual Wayne-Dalton 44

18 pages 6.35 mb
Download

Go to site of 18

Summary
  • Wayne-Dalton 44 - page 1

    GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...

  • Wayne-Dalton 44 - page 2

    2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. TRACK ROLLERS (AS REQUIRED): A1. Short Stem T rack Rollers A2. Long Stem T rack Rollers A3. Sh ...

  • Wayne-Dalton 44 - page 3

    I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...

  • Wayne-Dalton 44 - page 4

    Weather seals & nails (If included) Strut clips (as required) Pull down rope (if included) Counterbalance lift cables (2) 5/16”-18 x 3-3/4” Eye bolts Lift handles (as required) Snubber cables Bottom corner brackets (as required) (2) Front cable lift sheaves (2) Sheave forks (as required) S-hooks (as required) 3 Hole clips (as required) (2) ...

  • Wayne-Dalton 44 - page 5

    3 Section High Strutting Schedule Section T ype T ype Of Strut Location On Section T op (1) Short T op Of Section N/A Bottom Of section Intermediate I (1) Long T op Of Section N/A Bottom Of section Bottom N/A T op Of Section (1) Short Bottom Of section 4 Section High Strutting Schedule Section T ype T ype Of Strut Location On Section 2” Strut 3? ...

  • Wayne-Dalton 44 - page 6

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . IMPORT ANT : WOOD DOORS MUST BE COMPLETEL Y FINISHED (3 TOT AL COATS, INCLUDING PRIMER COA T) PRIOR TO INST ALLA TION, ...

  • Wayne-Dalton 44 - page 7

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T ypical left hand bottom corner bracket Bottom section (1) 1/4” - 14 x 1” T amper resistant la ...

  • Wayne-Dalton 44 - page 8

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (2) 1/4” - 20 x 2 1/2” Carriage bolts and (2) 1/4” - 20 Flange hex nuts Long strut (if applic ...

  • Wayne-Dalton 44 - page 9

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com surface. Drill pilot holes, 1” deep into the top section using a 1/8” drill bit. IMPORT ANT : B ...

  • Wayne-Dalton 44 - page 10

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Center hinge(s) Left single graduated end hinge with typical short stem track roller Right single g ...

  • Wayne-Dalton 44 - page 11

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T op fixture slide(s) 5/16”-18 Hex nut(s) Horizontal track T rack roller T op section Rear Back ...

  • Wayne-Dalton 44 - page 12

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com TRACK: Bolt the front cable lift sheave to the first 13/32” hole in the horizontal track angle, ...

  • Wayne-Dalton 44 - page 13

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Front cable lift sheave Counterbalance lift cable 3 Hole clip Special knot Horizontal track angle C ...

  • Wayne-Dalton 44 - page 14

    Door Arm Hookup T ools: Needle nose pliers At the center of the top section, measure horizontally from the top of center hinge to the bottom of strut. Using that dimension, measure and cut (2) pieces of perforated angles. Assemble the (2) pieces together using (2) 3/8” bolts and nuts (supplied by others). Now, secure to the top section using carr ...

  • Wayne-Dalton 44 - page 15

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! An annual inspection of all the surfaces of your garage door(s) will reveal the extent of weather - ing and the possible need for refinishing. When the finish becomes eroded or thin, clean and prime any areas showing deterioration. Then completely refinish ...

  • Wayne-Dalton 44 - page 16

    3. Lubrication: The door should open and close smoothly. Ensure the door track rollers are rotating freely when opening and closing the door . If track rollers do not rotate freely, clean the door tracks, removing dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) graduated end hinges, steel track rollers, spri ...

  • Wayne-Dalton 44 - page 17

    Limited warranty Double Flush, Model 44 Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , against defects in material and workmanship, for a period of ONE (1) YEAR from the time of delivery provided: i) (i) The interior and exterior surfaces, as well as all ...

  • Wayne-Dalton 44 - page 18

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...

Manufacturer Wayne-Dalton Category Garage Door Opener

Documents that we receive from a manufacturer of a Wayne-Dalton 44 can be divided into several groups. They are, among others:
- Wayne-Dalton technical drawings
- 44 manuals
- Wayne-Dalton product data sheets
- information booklets
- or energy labels Wayne-Dalton 44
All of them are important, but the most important information from the point of view of use of the device are in the user manual Wayne-Dalton 44.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Wayne-Dalton 44, service manual, brief instructions and user manuals Wayne-Dalton 44. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Wayne-Dalton 44.

Similar manuals

A complete manual for the device Wayne-Dalton 44, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Wayne-Dalton 44 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Wayne-Dalton 44.

A complete Wayne-Dalton manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Wayne-Dalton 44 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Wayne-Dalton 44, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Wayne-Dalton 44, that we can find in the current document
3. Tips how to use the basic functions of the device Wayne-Dalton 44 - which should help us in our first steps of using Wayne-Dalton 44
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Wayne-Dalton 44
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Wayne-Dalton 44 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Wayne-Dalton 44?

Use the form below

If you did not solve your problem by using a manual Wayne-Dalton 44, ask a question using the form below. If a user had a similar problem with Wayne-Dalton 44 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)