-
Lennox International Inc. C260 - page 1
INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference A F ren c ...
-
Lennox International Inc. C260 - page 2
2 CO N GR A TU L A TI ON S ! When you purchased your new wood-burning fireplace insert, you joined the ranks of thousands of individuals whose answer to their home heating needs reflects their concern for aesthet- ics, efficiency and our environment. We extend our continued support to help you achieve the maximum benefit and enjoyment available ...
-
Lennox International Inc. C260 - page 3
3 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves during installation to avoid injury from sharp edges on the insert and ...
-
Lennox International Inc. C260 - page 4
4 Y our wood fireplace insert is dependent upon a properly functioning chimney for optimum performance. It is a high efficiency appliance that loses much less heat up the chimney than older appliances and fireplaces. For this reason it is important to match the fireplace insert to the chimney . The chimney has two functions: 1. It draws combust ...
-
Lennox International Inc. C260 - page 5
5 This appliance is designed and engineered to burn, dry , well-seasoned wood only . Dry , seasoned wood is that which has been cut, split and allowed to dry under a covered area where air is free to flow and circulate under and around the wood (not under a tarp or plastic). Make sure wood is not stacked directly on the ground, it may absorb moist ...
-
Lennox International Inc. C260 - page 6
6 Brick Installation CAUTION: Wear gloves during brick installation in case of sharp edges inside the fireplace insert. Note: Installation of the baffle boards and baffle blanket is easier when you can still access the flue outlet, (before connecting the flue vent). Be s ure the baffle blanket is placed flat on the baffle boards so as not t ...
-
Lennox International Inc. C260 - page 7
7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Model F (1) G H J M C260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-1/4” 13 3m m 5 0 - 1 / 2 ” 12 83 m m E260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-3/4” 13 3m m 45” 11 43 m m C260 with mantel and/or side shields u 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 5 ...
-
Lennox International Inc. C260 - page 8
8 The hearth and/or floor protection must be a thermally rated non- combustible hearth/floor protector meeting or exceeding a thermal rating of k=.84 or equivalent with a listed thickness of listed thickness of 3/4" (19 mm) minimum in the USA and Canada. The covering must extend USA-16”/Canada-18” (C260) and 22” (E260) in front of the ...
-
Lennox International Inc. C260 - page 9
9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. This appliance is approved for use in a masonry fireplace built to UBC Chapter 37 or equivalent with a minimum 30-1/2” (775mm) opening width at the front of the fireplace. This appliance may be installed using 6” chimney in vertical installations utilizing a 8” to 6” reducer (cat. # ...
-
Lennox International Inc. C260 - page 10
10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Posi tiv e F lue Conn ect or Ring (sol d s epa rate ly) Rigi d P ipe , Of fse t Bo x o r Flex Pi pe Adap tor T op of I nse rt In B ack Figure 7 - Connector Ring Kit A positive flue connection is providing a seal between the vent pipe or liner and the existing fireplace chimney for the purpo ...
-
Lennox International Inc. C260 - page 11
11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. CLEARANCE TO COMBUSTIBLES See “Required Clearances” on Page 7 . INSERT PRE-INST ALLA TION PREP ARA TION Install the two 3” (76 mm) long bolts (with the head up) through the nuts attached to the insert on the lower rear corner of each side. This will allow you to level the insert when pl ...
-
Lennox International Inc. C260 - page 12
12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 1. Burn only dr y , well-seasoned wood for maximum heat output. In some states it is illegal to burn wet wood or anything other than clean, dr y wood products. 2. Y our fireplace insert is designed to operate with the door closed! Operate only with the door shut tightly at all times except w ...
-
Lennox International Inc. C260 - page 13
13 W ARNINGS The blower must be plugged directly into a properly grou nded three -pro ng rec eptac le, 120 V AC, 60 Hz, single phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance. Installation must be in accordance with National Elec- trical Code, ANSI/NFP A 70 - latest edition. In ...
-
Lennox International Inc. C260 - page 14
14 It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebox for thorough combustion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox. When you first light your fireplace insert, the bricks will t ...
-
Lennox International Inc. C260 - page 15
15 DOOR HINGES: If door hinges need lubricating, use an anti-seize com- pound (never use oil) available from your Lennox Hearth Products dealer . DOOR LA TCH: If your door latch fails to latch tightly and the gasket is in good condition, place a length of pipe (cheater bar) over the inside portion of the door handle and bend slightly toward the doo ...
-
Lennox International Inc. C260 - page 16
16 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the fireplace inserts’ draft depend solely on the natural draft of the chimney (See Draft Requirements o n Page 4 ) . If your fireplace insert is not drafting properly , your ...
-
Lennox International Inc. C260 - page 17
17 DO NOT : Install or operate this fireplace insert before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the fireplace insert door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and ...
-
Lennox International Inc. C260 - page 18
18 Contact an Lennox Hearth Products dealer to obtain any of these parts . Never use subst itut e materia ls. Use of non-ap prov ed parts can result in poor performance and safety hazards. REPLACEMENT P AR TS - MODEL C260 AND E260 C260 AND E260 FRONT DOOR P ARTS LIST 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upp ...
-
Lennox International Inc. C260 - page 19
19 REPLACEMENT P AR TS - MODEL C260 ...
-
Lennox International Inc. C260 - page 20
20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODEL E260 ...
-
Lennox International Inc. C260 - page 21
21 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 7 11 10 6 9 5 4 4 1 8 2 3 REPLACEMENT P AR TS - MODEL C260 AND E260 16 29 17 15 32 18 19 Door Parts Blower Parts ...
-
Lennox International Inc. C260 - page 22
22 TO P S U RR OUN D P ANE L ( R EQ UIR ED) Ca t. N o. Mo del De scr i pt ion 71 015 WT F07 4 8- B 7- 1/2 ” H x 4 8 ”W Bl ack (T ota l d ime nsi o n whe n i nst all e d equ a ls 29 ”x4 8 ”) 71 016 WT F10 4 8- B 10 -1/ 2 ”H x 4 8” W B lac k O ver s iz ed (T ota l d ime nsi o n whe n i nst all e d equ a ls 32 ”x4 8 ”) TR ADI T IO NAL ...
-
Lennox International Inc. C260 - page 23
23 SU RRO U ND P ANE LS / T O P AND SI DES (R E QU IRE D ) Ca t. N o. Mo del De scr i pt ion 29 ” x 40 ”: 71 038 WF PT0 7 40 -L T op S urr o un d 7 - 1/ 2” x 4 0 ” 71 031 WF PS 0 62 1 S id e S u rr oun d s 6” x 2 1 -5 /8” 29 ” x 48 ”: 71 039 WF PT0 7 48 -L T op S urr o un d 7 - 1/ 2” x 4 8 ” 71 032 WF PS 1 02 1 S id e S u rr oun ...
-
Lennox International Inc. C260 - page 24
24 SAFETY / LISTING LABEL 2011 2012 2013 ...
-
Lennox International Inc. C260 - page 25
25 NOTES ...
-
Lennox International Inc. C260 - page 26
Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775210M REV . D 12/2011 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. WARRANTY Y our wood ...
¿Tienes una pregunta acerca de Lennox International Inc. C260?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Lennox International Inc. C260, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Lennox International Inc. C260 probablemente compartirá una forma de solucionarlo.