Manuale per l’uso Lennox International Inc. C260

26 pagine 2.43 mb
Scarica

Vai alla pagina of 26

Summary
  • Lennox International Inc. C260 - page 1

    INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference A F ren c ...

  • Lennox International Inc. C260 - page 2

    2 CO N GR A TU L A TI ON S ! When you purchased your new wood-burning fireplace insert, you joined the ranks of thousands of individuals whose answer to their home heating needs reflects their concern for aesthet- ics, efficiency and our environment. We extend our continued support to help you achieve the maximum benefit and enjoyment available ...

  • Lennox International Inc. C260 - page 3

    3 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves during installation to avoid injury from sharp edges on the insert and ...

  • Lennox International Inc. C260 - page 4

    4 Y our wood fireplace insert is dependent upon a properly functioning chimney for optimum performance. It is a high efficiency appliance that loses much less heat up the chimney than older appliances and fireplaces. For this reason it is important to match the fireplace insert to the chimney . The chimney has two functions: 1. It draws combust ...

  • Lennox International Inc. C260 - page 5

    5 This appliance is designed and engineered to burn, dry , well-seasoned wood only . Dry , seasoned wood is that which has been cut, split and allowed to dry under a covered area where air is free to flow and circulate under and around the wood (not under a tarp or plastic). Make sure wood is not stacked directly on the ground, it may absorb moist ...

  • Lennox International Inc. C260 - page 6

    6 Brick Installation CAUTION: Wear gloves during brick installation in case of sharp edges inside the fireplace insert. Note: Installation of the baffle boards and baffle blanket is easier when you can still access the flue outlet, (before connecting the flue vent). Be s ure the baffle blanket is placed flat on the baffle boards so as not t ...

  • Lennox International Inc. C260 - page 7

    7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Model F (1) G H J M C260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-1/4” 13 3m m 5 0 - 1 / 2 ” 12 83 m m E260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-3/4” 13 3m m 45” 11 43 m m C260 with mantel and/or side shields u 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 5 ...

  • Lennox International Inc. C260 - page 8

    8 The hearth and/or floor protection must be a thermally rated non- combustible hearth/floor protector meeting or exceeding a thermal rating of k=.84 or equivalent with a listed thickness of listed thickness of 3/4" (19 mm) minimum in the USA and Canada. The covering must extend USA-16”/Canada-18” (C260) and 22” (E260) in front of the ...

  • Lennox International Inc. C260 - page 9

    9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. This appliance is approved for use in a masonry fireplace built to UBC Chapter 37 or equivalent with a minimum 30-1/2” (775mm) opening width at the front of the fireplace. This appliance may be installed using 6” chimney in vertical installations utilizing a 8” to 6” reducer (cat. # ...

  • Lennox International Inc. C260 - page 10

    10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Posi tiv e F lue Conn ect or Ring (sol d s epa rate ly) Rigi d P ipe , Of fse t Bo x o r Flex Pi pe Adap tor T op of I nse rt In B ack Figure 7 - Connector Ring Kit A positive flue connection is providing a seal between the vent pipe or liner and the existing fireplace chimney for the purpo ...

  • Lennox International Inc. C260 - page 11

    11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. CLEARANCE TO COMBUSTIBLES See “Required Clearances” on Page 7 . INSERT PRE-INST ALLA TION PREP ARA TION Install the two 3” (76 mm) long bolts (with the head up) through the nuts attached to the insert on the lower rear corner of each side. This will allow you to level the insert when pl ...

  • Lennox International Inc. C260 - page 12

    12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 1. Burn only dr y , well-seasoned wood for maximum heat output. In some states it is illegal to burn wet wood or anything other than clean, dr y wood products. 2. Y our fireplace insert is designed to operate with the door closed! Operate only with the door shut tightly at all times except w ...

  • Lennox International Inc. C260 - page 13

    13 W ARNINGS The blower must be plugged directly into a properly grou nded three -pro ng rec eptac le, 120 V AC, 60 Hz, single phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance. Installation must be in accordance with National Elec- trical Code, ANSI/NFP A 70 - latest edition. In ...

  • Lennox International Inc. C260 - page 14

    14 It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebox for thorough combustion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox. When you first light your fireplace insert, the bricks will t ...

  • Lennox International Inc. C260 - page 15

    15 DOOR HINGES: If door hinges need lubricating, use an anti-seize com- pound (never use oil) available from your Lennox Hearth Products dealer . DOOR LA TCH: If your door latch fails to latch tightly and the gasket is in good condition, place a length of pipe (cheater bar) over the inside portion of the door handle and bend slightly toward the doo ...

  • Lennox International Inc. C260 - page 16

    16 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the fireplace inserts’ draft depend solely on the natural draft of the chimney (See Draft Requirements o n Page 4 ) . If your fireplace insert is not drafting properly , your ...

  • Lennox International Inc. C260 - page 17

    17 DO NOT : Install or operate this fireplace insert before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the fireplace insert door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and ...

  • Lennox International Inc. C260 - page 18

    18 Contact an Lennox Hearth Products dealer to obtain any of these parts . Never use subst itut e materia ls. Use of non-ap prov ed parts can result in poor performance and safety hazards. REPLACEMENT P AR TS - MODEL C260 AND E260 C260 AND E260 FRONT DOOR P ARTS LIST 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upp ...

  • Lennox International Inc. C260 - page 19

    19 REPLACEMENT P AR TS - MODEL C260 ...

  • Lennox International Inc. C260 - page 20

    20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODEL E260 ...

  • Lennox International Inc. C260 - page 21

    21 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 7 11 10 6 9 5 4 4 1 8 2 3 REPLACEMENT P AR TS - MODEL C260 AND E260 16 29 17 15 32 18 19 Door Parts Blower Parts ...

  • Lennox International Inc. C260 - page 22

    22 TO P S U RR OUN D P ANE L ( R EQ UIR ED) Ca t. N o. Mo del De scr i pt ion 71 015 WT F07 4 8- B 7- 1/2 ” H x 4 8 ”W Bl ack (T ota l d ime nsi o n whe n i nst all e d equ a ls 29 ”x4 8 ”) 71 016 WT F10 4 8- B 10 -1/ 2 ”H x 4 8” W B lac k O ver s iz ed (T ota l d ime nsi o n whe n i nst all e d equ a ls 32 ”x4 8 ”) TR ADI T IO NAL ...

  • Lennox International Inc. C260 - page 23

    23 SU RRO U ND P ANE LS / T O P AND SI DES (R E QU IRE D ) Ca t. N o. Mo del De scr i pt ion 29 ” x 40 ”: 71 038 WF PT0 7 40 -L T op S urr o un d 7 - 1/ 2” x 4 0 ” 71 031 WF PS 0 62 1 S id e S u rr oun d s 6” x 2 1 -5 /8” 29 ” x 48 ”: 71 039 WF PT0 7 48 -L T op S urr o un d 7 - 1/ 2” x 4 8 ” 71 032 WF PS 1 02 1 S id e S u rr oun ...

  • Lennox International Inc. C260 - page 24

    24 SAFETY / LISTING LABEL 2011 2012 2013 ...

  • Lennox International Inc. C260 - page 25

    25 NOTES ...

  • Lennox International Inc. C260 - page 26

    Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775210M REV . D 12/2011 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. WARRANTY Y our wood ...

Fabbricante Lennox International Inc. Categoria Indoor Fireplace

I documenti che otteniamo dal fabbricante del dispositivoLennox International Inc. C260 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Lennox International Inc.
- manuali per l’uso C260
- schede prodotto Lennox International Inc.
- opuscoli
- o etichette energetiche Lennox International Inc. C260
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Lennox International Inc. C260.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Lennox International Inc. C260, manuali di manutenzione, brevi manuali o manuali utente Lennox International Inc. C260. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Lennox International Inc. C260.

Manuale completo del dispositivo Lennox International Inc. C260, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Lennox International Inc. C260 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Lennox International Inc. C260.

Il manuale per l’uso completo Lennox International Inc., dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Lennox International Inc. C260 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Lennox International Inc. C260, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Lennox International Inc. C260 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Lennox International Inc. C260 - che ci dovrebbe aiutare nei primi passi durante l'uso Lennox International Inc. C260
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Lennox International Inc. C260
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Lennox International Inc. C260 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Lennox International Inc. C260?

Utilizza il modulo sottostante

Se non hai risolto il problema con Lennox International Inc. C260 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Lennox International Inc. C260 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)