-
Bunn A10 - page 1
A10 & A10-A INST ALLA TION & OPERA TING GUIDE Designs, materials, weights, specifications, and dimensions for equipment or replacement parts are subject to change without notice. BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 43422.0001B 07/12 ©2011 Bunn-O-Matic ...
-
Bunn A10 - page 2
2 43422.1 030912 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh ser vers (mechanical and digital)- 1 year parts and 1 year labor . 2) All ot ...
-
Bunn A10 - page 3
3 SPECIFICA TIONS E lectrical - UL Listed. Refer to Data Plate on the Brewer , and local/national elec- trical codes to determine circuit requirements. Dimensions - 14 1/4 inches high; 6 3/4 inches wide; 13 1/2 inches deep. Capacity - T wo to eight 6-ounce cups (12-48 ounces) per batch. T ank Size - 75 ounces. Weight - 15 pounds; Includes decanter ...
-
Bunn A10 - page 4
4 IMPOR T ANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Readallinstructions. • Do not touch hot surfaces. Use handles or knobs. • Do not place cord, plugs, or brewer in water or ...
-
Bunn A10 - page 5
5 GENERAL INFORMA TION NOTE - THE BREWER IS NOT READY TO PLUG IN Improper installation will result in permanent damage and void the war - ranty . Read & follow the instructions on the next page. • Be certain the tank is full of water before plugging in the brewer . (Requires at least three quart ...
-
Bunn A10 - page 6
6 HOT WA TER T ANK (LOCA TED INSIDE) V ACA TION SWITCH LID ST ART SWITCH WARMER SWITCH FULL/HALF BA TCH SWITCH MODEL A-10/A-10 AUTOMA TIC COFFEE BREWER Hazardous Voltage! Can Cause Fire Or Electrical Shock! Do Not Disassemble The Brewer! There Are No User Serviceable Parts Inside! Repair Should Be Done By Authorized Service Personnel! (Refer to Pag ...
-
Bunn A10 - page 7
7 CAUTION - Do not plug-in the brewer until specified in Initial Set-Up. The A10/A10 Automatic Brewer has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 10 amp, single phase, 60 Hz. The A10A/A10A Automatic Brewer has an IEC 320 connector and matching cordset and requires 2-wire grounded service rated 230 volts ac, 10 ...
-
Bunn A10 - page 8
8 PREP ARING THE BREWER FOR USE NOTE: THE BREWER IS NOT READY TO PLUG IN Raisethehingediplid. Place the decanter on the warmer . Pour two pitchers of water (filled to the top line) into the screened area on top of the brewer . Wait two minutes between pitchers to allow the water to fill the tank. When the tankis full ...
-
Bunn A10 - page 9
9 BREWING DELICIOUS COFFEE Insert a Bunn ® coffee filter into the brew funnel. (Be sure to use Bunn ® coffee filters for proper brewing. There is a difference.) Measure coffee into the filter and gently shake to level the bed of grounds. Make sure that the sprayhead is tight. Slide the brew funnel into the brewer under the warmer switch. Snap ...
-
Bunn A10 - page 10
10 TIMER SETTING - AUTOMA TICS ONL Y CAUTION – Disconnect the power source from the brewer prior to the removal of any panel for the replacement or adjustment of any component. NOTE: Check that the brewer is connected to water supply , the tank is properly filled, and a funnel and server are in place, prior to setting or modifying batch sizes. 1 ...
-
Bunn A10 - page 11
11 HOT WA TER The same basic steps can be used to obtain hot water by omitting the filter and coffee and using the enclosed hot water funnel. The hot water from your Bunn ® coffee brewer is approximately 200˚F . This ishotter thanthe hotwater from your faucet and must be handled with care. COFFEE FUND ...
-
Bunn A10 - page 12
12 ROUTINE CLEANING Rinsing the brew funnel and decanter after each use is the only routine cleaning required. Occasionally , wipe the outside of the brewer including the area above the funnel with a damp cloth. (The brew funnel, hot water funnel and decanter are top rack dishwasher safe.) HANDLE MAINTENANCE Using a phillips screw driver , periodic ...
-
Bunn A10 - page 13
13 DRAINING THE BREWER The water in your Bunn ® Coffee Brewer should be emptied whenever it is taken on a trip, shipped, or stored in an unheated location with a chance of freezing. P2084 P2082 1) Unplug the brewer and cool the hot water in the tank. Place the empty decanter on the warmer . Simply pour a full water pitcher of cold water into the t ...
-
Bunn A10 - page 14
14 BUNN ® COMP ANION PRODUCTS COFFEE & TEA FIL TERS Constant quality testing assures consistency from pot to pot. The best flavor without any grounds in the cup. BUNN ® paper filters are packaged to maintain their fluted shape for use in most basket type drip coffee makers and the Bunn ® Easy T ea TM Pitcher . AUXILIARY W ARMERS Durable, ...
-
Bunn A10 - page 15
15 10627.0000A 5/92 © 1992 BUNN-O-MATIC CORPORATION L2 L1 BLK WHI GRN/YEL SCHEMATIC WIRING DIAGRAM A10 A "KEEP WARM" HEATER WHI LOWER WARMER 80W RED RED BLK RED 230 VOLTS AC 2 WIRE SINGLE PHASE LIMIT THERMOSTAT RED SW. & THERMOSTAT SW1 LIMIT THERMOSTAT BLK BLU TANK HEATER 1000W SW2 40W 10627.0001A 5/92 ©1 99 2B UNN-O-MATIC CORPORATI ...
¿Tienes una pregunta acerca de Bunn A10?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Bunn A10, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Bunn A10 probablemente compartirá una forma de solucionarlo.