-
Zephyr EOT-E42ASX - page 1
www .zephyronline.com Guide dutilisation, dentretien et dinst allation Use, Care, and Inst allation Guide Model number: Numéro de modèle: ____________________________________ Número de modelo: Serial number: Num éro de sér ie: _____________________________________ Número de serie: Date of Purchase: Date dac hat: __________________ ...
-
Zephyr EOT-E42ASX - page 2
2 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING . INST ALL A TION MUST COMPL Y WITH A LL LOCAL CODES. IMP ORT AN T : Save these Instructions for the Local Electrical Inspector s use. INS T ALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Safety W arning: T urn ...
-
Zephyr EOT-E42ASX - page 3
3 www .zephyronline.com T able of Content s Important safet y Notic e ..................................................................... 4 Electrical & Installa tion requi rements .............................................. 5 Electrical req uirements .......................... .................................... 5 Before installing the h ...
-
Zephyr EOT-E42ASX - page 4
4 Import ant safety Notice CAUTION: FOR GENERAL VENTILA TING USE ONL Y . DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MA TERIALS OR V APORS. W ARNING T O REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, O R INJURY T O PERSONS, OBSER VE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer . If you have questions, contact the manuf ...
-
Zephyr EOT-E42ASX - page 5
5 www .zephyronline.com Electrical & Installation requirement s ELECTRICAL REQUIREMENTS Important: Observe all governing codes and ordinances. It is the customer s responsibility: T o co ntact a qualified electrical inst al le r . T o assure t hat the electrical inst allation is adequate and in conformance with National Electrical C ...
-
Zephyr EOT-E42ASX - page 6
6 List of Materials PARTS SUPPLIED: Blower unit housing Hood canopy Met al filter x 1 Halogen light bulb x 4 Upper and lower Duct covers x 4 Chimney structure Hardware Packet: Allen spanner x 1 Te m p l a t e Use, Care and Installation guide Nu ts x 12 7x45 screws x 6 4 x 6 screws x 12 (to assemble duct covers) 3,5x6,5 s ...
-
Zephyr EOT-E42ASX - page 7
7 www .zephyronline.com Dimensions and clearances ...
-
Zephyr EOT-E42ASX - page 8
8 Inst allation Instructions Closely follow the instructions set out in this manual. All responsibility , for any ev entual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. VENTING METHODS The hood is equipped with a transition B for discharge of fumes to the outside ( Ducting version ). Sh ...
-
Zephyr EOT-E42ASX - page 9
9 www .zephyronline.com Inst allation - Ductwork Calculation Sheet 3 1/4 x 10 Rect., straight 6 Round,, straight 7", 8 Round,, straight 3 1/4 x 10 Rect.90° elbow 3 1/4 x 10 Rect.45° elbow 3 1/4 x 10 Rect.90° flat elbow 3 1/4 x 10 Rect. wall cap with damper 3 1/4 x 10 Rect.to 6 round trans ...
-
Zephyr EOT-E42ASX - page 10
10 1. Pre-installation calculations 1" 3/8 K C (36" std) P S H a) Select a hood preference height P that is comfort able for the user . (from 24 to 32). b) Calculate Hood height your installation H = K-C-P . c) Conf irm t hat H i s with in th e rang e of mi n to m ax H found for your model (see Dimensions and clearances p arag ...
-
Zephyr EOT-E42ASX - page 11
11 www .zephyronline.com c. Install a 8 exhaust duct and extend length = S - 16 5/8 from ceiling. Duct shall be securely fastened to joist s. Do not use duct smaller than specified. Attention: Duct inst allation is not required for non- vented (recirculating) inst allations d. Install 1/2" electrical conduit in location marked on templat ...
-
Zephyr EOT-E42ASX - page 12
12 8. Electrical connection W ARNING Electrical Shock Hazard W arning: T urn off power circuit at the service panel before wiring this unit. 120 V AC, 15 or 20 Amp circuit required. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO ...
-
Zephyr EOT-E42ASX - page 13
13 www .zephyronline.com d. Fasten the canopy with 1 1 screws from the bottom. Bottom Vie w FRONT FRONT FRONT 12. Fix 6 nuts on the internal side of top duct covers sections (squere slots) and fix each other with 6 screws (3 per side). Rectangular slots Plan diagram top sections Nut top sections Chimney Structure 13. Install top duct covers assembl ...
-
Zephyr EOT-E42ASX - page 14
14 14. Fix 6 nuts on the internal side of rear bottom duct covers section (square slot s - see drawings afte r step 1 1) and place it on the rear side of the hood on top the canopy , cheack that it snaps with top duct covers assembly . rear bottom duct covers section Plan diagram top view rear bottom duct covers section (snap into place) 15. Fit th ...
-
Zephyr EOT-E42ASX - page 15
15 www .zephyronline.com 17. Assemble the lower (narrow) trim strips to the lower vent cover assembly . Cut the upper (wide) trim strips to length to fit the upper duct cover assembly . Assemble the upper trim strips to the upper duct cover assembly . Upper tab Lower tab Lower tab X X Upper tab 18. Check all light bulbs to mak e sure they are secur ...
-
Zephyr EOT-E42ASX - page 16
16 Description of t he hood & Controls 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp (position and nr . of lamps m ay v ar y) 5 Hood canopy 6 Duct cover 7 Air outlet (used for Ductless version only) CONTROLS Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hoo ...
-
Zephyr EOT-E42ASX - page 17
17 www .zephyronline.com Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply . CLEANING The cooker hood should be cleaned regularly internally and externally . For cleaning use a cloth moistened with a neutral liquid detergents. Avoid abrasive detergent s. Warning: Failure to carry out th ...
-
Zephyr EOT-E42ASX - page 18
18 T rouble Shooting Af ter inst allation, the unit doesnt work? Light works, but motor is not turning. The unit is vibrating. The motor is working, but the lights are not. The hood is not venting out properly . Met al filter is vibrating. 1. The power source is not turned ON. 2. The power line and the cable locking connector is not connecting p ...
-
Zephyr EOT-E42ASX - page 19
19 www .zephyronline.com W arranty T O OBT AIN SERVICE UNDER WARRANTY : or any Service Related Questions, please call: 1-888-880-8368 S taple your receipt here. Proof of the original purchase date is needed to obt ain ser vic e under the warranty . T O OB T AIN SERVICE UNDER W ARRANTY : Y ou must present proof of original purchase date. Please keep ...
-
Zephyr EOT-E42ASX - page 20
20 List of Part s and Accessories Part Description Part# halogen bulb, 12V 20 W metal filter Part Description Part# Ductless recirculating kit charcoal replacement filter duct cover extension kit internal blower - 600 cfm in-line blower - 1 100 cfm ZRC-00AL EBI-600A EB N-1 100A Z0B-0013 Z0F-C060 Z1C-00AL ...
-
Zephyr EOT-E42ASX - page 21
21 www .zephyronline.com ...
-
Zephyr EOT-E42ASX - page 22
22 ...
¿Tienes una pregunta acerca de Zephyr EOT-E42ASX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Zephyr EOT-E42ASX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Zephyr EOT-E42ASX probablemente compartirá una forma de solucionarlo.