Español dropdown-ico

Manual de instrucciones Apollo 1600

17 de páginas 2.01 mb
Descargar

Pasar a la página of 17

Summary
  • Apollo 1600 - page 1

    APOLLO Gate Operators, Inc. Model 1500 / 1600 Swing Gate Operator INS TALLATION MANUAL 051104 ...

  • Apollo 1600 - page 2

    2 CONTENTS Safety Precautions ................................................... 3 Applications ............................... ............................... 4 Pre - Ins tallation Checklist ........................................ 5 Par ts Identification . .................................................. 6 Operator Ins tallation .............. ...

  • Apollo 1600 - page 3

    3 WARNING - To reduce the risk of injury or death: • READ AND FOLLOW ALL INSTRUCTIONS. • Installation should be performed by a professional installer. • Required welding should be performed by a qualified welder. • Should electricity be required, use a certified electrician only. • Any device that requires 120 Volts AC should be U.L. appr ...

  • Apollo 1600 - page 4

    4 APPLIC ATIONS The Apollo Model 1500/1600 Swing Gate Operator is designed to handle swing gates up to 14 feet in length and 400 pounds each. A professional fence or gate dealer is recommended to assure proper installation. Apollo Gate Operators are available only through qualified dealers with an outstanding reputation in the fence and gate indust ...

  • Apollo 1600 - page 5

    5 PRE - INS TALLATION CHECKLIST The following checklist should be used before beginning installation: Verify that the proper operator has been selected for this application. Verify proper installation and operation of the gate. 1. Are the hinges servicable? 2. Does the gate swing free and level? 3. Will the gate require a locking device? 4. Is the ...

  • Apollo 1600 - page 6

    6 PARTS IDENTIFIC ATION CAUTION Signs (2 each) (4 each with 1600) Gate Bracket (2 with 1600) Hardware Kit (2 with 1600) Automatic Battery Charger (optional) 5 Watt Solar Panel & Bracket (optional) (2 required with 1600) Actuator with 8’ cable (slave actuator with 38’ cable supplied with 1600) Control Box Pivot Arm (2 with 1600) Bolt On Pivo ...

  • Apollo 1600 - page 7

    7 OPER ATOR INSTALL ATION Location of Pivot Point. 1/2” Center Line of attachment point for gate bracket Hinge post Vertical position of pivot arm Measurements are taken from the center of the hinge. STEP 1 PIVOT ARM INSTALLATION (standard pull to open) Front View Pivot ArmMust be level Notes: PULL TO OPEN pulls gate open ( actuator is extended w ...

  • Apollo 1600 - page 8

    8 STEP 3 Control Box Installation Mount the control box within 4 feet of the pivot arm. Use mounting hardware capable of supporting the weight of the control box with the battery installed. Mounting holes are not provided since mounting surfaces will vary. STEP 4 Connecting the Actuator (s) Set battery inside of control box with terminals toward th ...

  • Apollo 1600 - page 9

    9 STEP 6 Limit Switch Adjustment To Retract More Turn Retract Limit Screw Clockwise To Retract Less Turn Retract Limit Screw Counter - Clockwise To Extend More Turn Extend Limit Screw Counter - Clockwise To Extend Less Turn Extend Limit Screw Clockwise Remove limit switch end caps Cycle the operator and adjust limits as required. If the operator op ...

  • Apollo 1600 - page 10

    10 635/636 CONTROL BOARD CONNECTIONS Emergency Bypass Connector Used when the control board is not functioning. Unplug the motor harness from the Master (or Slave) Connector and momentarily insert into the Emergency Bypass Connector to open the gate. In the event the motor is not disconnected quickly enough, the blue 15 amp fuse will protect the ci ...

  • Apollo 1600 - page 11

    11 635 /63 6 CONTROL BOARD ADJUSTMENTS PROGRAM SWITCHES Factory Description Setting #1 ON TIMER TO CLOSE - Automatically closes gate ON - Close timer enabled OFF - Close timer disabled #2 OFF CURRENT SENSITIVITY OPTION - Delays current sensing from start ON - 4 second delay OFF - 2 second delay #3 ON TIMER TO CLOSE OPTION ON - timer to close works ...

  • Apollo 1600 - page 12

    12 PUSH TO OPEN INS TALLATION Both measurements are taken from the center of the hinge. 11” 6” Direction of opening Gate (closed) Hinge post Top View Vertical position of pivot arm (s) Pivot arm must be level 1/2” Hinge post Center Line of attachment point for gate bracket Front View PIVOT ARM (s) INSTALLATION STEP 1 Location of pivot point R ...

  • Apollo 1600 - page 13

    13 APOLLO Gate Operators RECEIVER OPTIONS Do not confuse the receiver code switches with the red program switches on the gate control board. Never set all code switches to the same position. Transmitters must match code switches for proper operation. If power is taken directly from battery or connected as shown below, receiver should be configured ...

  • Apollo 1600 - page 14

    14 TROUBLESHOOTING OPER ATOR & ACCESSORIES SYMPTOM Some troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may be purchased at Radio Shack or a local electric supply company. Refer to the owners manual for instructions. Gate opens OK but after closing, opens back up. 1. Excessive closing pressure on gate. Re ...

  • Apollo 1600 - page 15

    15 SYMPTOM Gate will open using push button on side of box, but not with transmitter. 1. Code switches do not match. Check that the code switches in the transmitter and the receiver match. 2. Low or dead battery in transmitter. Replace battery. 3. Fuse blown on circuit board. Check fuses on gate control board. 4. Low battery in operator. Battery vo ...

  • Apollo 1600 - page 16

    16 SYMPTOM Gate will not open or close. Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and never drop below 11 volts when gate is operating. Reset program switches to factory setting. # 1,# 3,# 7,# 8 ON, all others OFF . Disconnect all accessories from the circuit board - receivers, push ...

  • Apollo 1600 - page 17

    17 LIMITED TWO - YE AR WARRANTY Apollo Gate Operators are warranted against defects for a period of 24 months from the date of purchase, providing recommended installation procedures are followed. This warranty is in lieu of all other warranties expressed or implied (some states do not allow limitations on how long an implied warranty lasts, so thi ...

Fabricante Apollo Categoría Safety Gate

Los documentos del dispositivo Apollo 1600 que obtenemos del fabricante se pueden dividir en varios grupos. Entre ellos están::
- dibujos técnicos Apollo
- manuales de instrucciones 1600
- hojas de producto Apollo
- folletos informativos
- o etiquetas energéticas Apollo 1600
Todos son importantes, pero lo más importante desde el punto de vista del usuario de un dispositivo lo encontraremos en el manual de instrucciones Apollo 1600.

Un conjunto de documentos determinado como manual de instrucciones se divide también en tipos más detallados, tales como: instrucciones de montaje Apollo 1600, instrucciones de servicio, instrucciones cortas o instrucciones de usuario Apollo 1600. Dependiendo de la situación debes buscar el documento que necesitas. En nuestra página puedes consultar el manual de instrucciones más popular del producto Apollo 1600.

Manuales de instrucciones parecidos

El manual de instrucciones del dispositivo Apollo 1600, ¿cómo debería ser?
El manual de instrucciones, también determinado como el manual de usuario o simplemente instrucciones, es un documento técnico que tiene como objetivo ayudar a los usuarios a utilizar Apollo 1600. Las instrucciones normalmente las realiza un escritor técnico pero en un lenguaje comprensible para todos los usuarios de Apollo 1600.

El manual de instrucciones completo de Apollo debe contener unos elementos básicos. Una parte de ellos es menos importante, como por ejemplo: la portada / la página principal o las páginas de autor. Sin embargo, lo demás debe facilitarnos la información más importante desde el punto de vista del usuario.

1. Introducción y pistas sobre cómo orientarse con el manual Apollo 1600 - Al principio de cada manual se deben encontrar las indicaciones acerca de la manera de usar un manual de instrucciones. Debe contener información sobre dónde encontrar el índice Apollo 1600, preguntas frecuentes o problemas más comunes – son los apartados más buscados por los usuarios de cada manual de instrucciones.
2. Índice - listados de todos los consejos acerca de Apollo 1600 que encontraremos en el documento
3. Consejos de uso de las funciones básicas del dispositivo Apollo 1600 - que deben facilitarnos los primeros pasos durante el uso de Apollo 1600
4. Troubleshooting - una secuencia sistematizada de acciones que nos ayudará a diagnosticar los problemas más importantes con Apollo 1600
5. FAQ - las preguntas frecuentes
6. Datos de contacto Información acerca de cómo encontrar los datos de contacto del fabricante / servicio de Apollo 1600 en cada país si no somos capaces de solucionar el problema por nuestra cuenta.

¿Tienes una pregunta acerca de Apollo 1600?

Utiliza el formulario que se encuentra abajo

Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Apollo 1600, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Apollo 1600 probablemente compartirá una forma de solucionarlo.

Copia el texto de la imagen

Captcha
Nueva imagen

Comentarios (0)