Apollo 1600の取扱説明書

17ページ 2.01 mb
ダウンロード

ページに移動 of 17

Summary
  • Apollo 1600 - page 1

    APOLLO Gate Operators, Inc. Model 1500 / 1600 Swing Gate Operator INS TALLATION MANUAL 051104 ...

  • Apollo 1600 - page 2

    2 CONTENTS Safety Precautions ................................................... 3 Applications ............................... ............................... 4 Pre - Ins tallation Checklist ........................................ 5 Par ts Identification . .................................................. 6 Operator Ins tallation .............. ...

  • Apollo 1600 - page 3

    3 WARNING - To reduce the risk of injury or death: • READ AND FOLLOW ALL INSTRUCTIONS. • Installation should be performed by a professional installer. • Required welding should be performed by a qualified welder. • Should electricity be required, use a certified electrician only. • Any device that requires 120 Volts AC should be U.L. appr ...

  • Apollo 1600 - page 4

    4 APPLIC ATIONS The Apollo Model 1500/1600 Swing Gate Operator is designed to handle swing gates up to 14 feet in length and 400 pounds each. A professional fence or gate dealer is recommended to assure proper installation. Apollo Gate Operators are available only through qualified dealers with an outstanding reputation in the fence and gate indust ...

  • Apollo 1600 - page 5

    5 PRE - INS TALLATION CHECKLIST The following checklist should be used before beginning installation: Verify that the proper operator has been selected for this application. Verify proper installation and operation of the gate. 1. Are the hinges servicable? 2. Does the gate swing free and level? 3. Will the gate require a locking device? 4. Is the ...

  • Apollo 1600 - page 6

    6 PARTS IDENTIFIC ATION CAUTION Signs (2 each) (4 each with 1600) Gate Bracket (2 with 1600) Hardware Kit (2 with 1600) Automatic Battery Charger (optional) 5 Watt Solar Panel & Bracket (optional) (2 required with 1600) Actuator with 8’ cable (slave actuator with 38’ cable supplied with 1600) Control Box Pivot Arm (2 with 1600) Bolt On Pivo ...

  • Apollo 1600 - page 7

    7 OPER ATOR INSTALL ATION Location of Pivot Point. 1/2” Center Line of attachment point for gate bracket Hinge post Vertical position of pivot arm Measurements are taken from the center of the hinge. STEP 1 PIVOT ARM INSTALLATION (standard pull to open) Front View Pivot ArmMust be level Notes: PULL TO OPEN pulls gate open ( actuator is extended w ...

  • Apollo 1600 - page 8

    8 STEP 3 Control Box Installation Mount the control box within 4 feet of the pivot arm. Use mounting hardware capable of supporting the weight of the control box with the battery installed. Mounting holes are not provided since mounting surfaces will vary. STEP 4 Connecting the Actuator (s) Set battery inside of control box with terminals toward th ...

  • Apollo 1600 - page 9

    9 STEP 6 Limit Switch Adjustment To Retract More Turn Retract Limit Screw Clockwise To Retract Less Turn Retract Limit Screw Counter - Clockwise To Extend More Turn Extend Limit Screw Counter - Clockwise To Extend Less Turn Extend Limit Screw Clockwise Remove limit switch end caps Cycle the operator and adjust limits as required. If the operator op ...

  • Apollo 1600 - page 10

    10 635/636 CONTROL BOARD CONNECTIONS Emergency Bypass Connector Used when the control board is not functioning. Unplug the motor harness from the Master (or Slave) Connector and momentarily insert into the Emergency Bypass Connector to open the gate. In the event the motor is not disconnected quickly enough, the blue 15 amp fuse will protect the ci ...

  • Apollo 1600 - page 11

    11 635 /63 6 CONTROL BOARD ADJUSTMENTS PROGRAM SWITCHES Factory Description Setting #1 ON TIMER TO CLOSE - Automatically closes gate ON - Close timer enabled OFF - Close timer disabled #2 OFF CURRENT SENSITIVITY OPTION - Delays current sensing from start ON - 4 second delay OFF - 2 second delay #3 ON TIMER TO CLOSE OPTION ON - timer to close works ...

  • Apollo 1600 - page 12

    12 PUSH TO OPEN INS TALLATION Both measurements are taken from the center of the hinge. 11” 6” Direction of opening Gate (closed) Hinge post Top View Vertical position of pivot arm (s) Pivot arm must be level 1/2” Hinge post Center Line of attachment point for gate bracket Front View PIVOT ARM (s) INSTALLATION STEP 1 Location of pivot point R ...

  • Apollo 1600 - page 13

    13 APOLLO Gate Operators RECEIVER OPTIONS Do not confuse the receiver code switches with the red program switches on the gate control board. Never set all code switches to the same position. Transmitters must match code switches for proper operation. If power is taken directly from battery or connected as shown below, receiver should be configured ...

  • Apollo 1600 - page 14

    14 TROUBLESHOOTING OPER ATOR & ACCESSORIES SYMPTOM Some troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may be purchased at Radio Shack or a local electric supply company. Refer to the owners manual for instructions. Gate opens OK but after closing, opens back up. 1. Excessive closing pressure on gate. Re ...

  • Apollo 1600 - page 15

    15 SYMPTOM Gate will open using push button on side of box, but not with transmitter. 1. Code switches do not match. Check that the code switches in the transmitter and the receiver match. 2. Low or dead battery in transmitter. Replace battery. 3. Fuse blown on circuit board. Check fuses on gate control board. 4. Low battery in operator. Battery vo ...

  • Apollo 1600 - page 16

    16 SYMPTOM Gate will not open or close. Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and never drop below 11 volts when gate is operating. Reset program switches to factory setting. # 1,# 3,# 7,# 8 ON, all others OFF . Disconnect all accessories from the circuit board - receivers, push ...

  • Apollo 1600 - page 17

    17 LIMITED TWO - YE AR WARRANTY Apollo Gate Operators are warranted against defects for a period of 24 months from the date of purchase, providing recommended installation procedures are followed. This warranty is in lieu of all other warranties expressed or implied (some states do not allow limitations on how long an implied warranty lasts, so thi ...

メーカー Apollo カテゴリー Safety Gate

Apollo 1600のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 1600の取扱説明書
- Apolloの製品カード
- パンフレット
- またはApollo 1600の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Apollo 1600の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Apollo 1600の取り付け説明書、サービスマニュアル、簡易説明書、またはApollo 1600のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Apollo 1600の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Apollo 1600デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがApollo 1600を使用するのを助ける技術的文書のことです。説明書は通常、全てのApollo 1600ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Apolloの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Apollo 1600の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははApollo 1600の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Apollo 1600に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Apollo 1600デバイスの基本機能を使うにあたってのヒント。 Apollo 1600のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Apollo 1600に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるApollo 1600のメーカー/サービスへの連絡先に関する情報。

Apollo 1600についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもApollo 1600の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがApollo 1600で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)