-
Craftsman 358.794941 - page 1
Instruction Manual I CRAFTSMAN°I 25cc/1.5 cu.in. 2-Cycle 200 MPH/400 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.794941 • Safety • Assembly • Operation • Maintenance • Parts List • Espar_ol WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this p ...
-
Craftsman 358.794941 - page 2
Warranty Statement 2 Troubleshooting Table 11 Safety Rules 2 Emissions Statement 12 Assembly 4 Parts List 14 Operation 6 Spanish 17 Maintenance 9 Parts and Ordering Back Storage 11 FULL TWO YEAR WARRANTY ON CRAFTSMAN® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the i ...
-
Craftsman 358.794941 - page 3
• Do not operate unit when you are tired, ill, upset, or if you are under the influence of alcohol, drugs, or medi- cation. • Keep children, bystanders, and ani- mals away from work area a mini- mum of 30 feet (10 meters) when starting or operating unit. Do not point blower nozzle in the direction of people or pets. HANDLE FUEL WITH CAUTION, IT ...
-
Craftsman 358.794941 - page 4
• Empty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops. • Do not use any accessory or attach- ment other than those recommended by manufacturer for use with your unit. • Do not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame fro ...
-
Craftsman 358.794941 - page 5
2. Secure the tube by turning the knob clockwise. 3. To remove the tube, turn the knob counterclockwise to loosen the tube; remove the tube. VACUUM ASSEMBLY VACUUM BAG ASSEMBLY 1. Open tile zipper on the vacuum bag and insert the elbow tube. 2. Push the small end of the elbow tube through the small opening in the bag. Elbow Tube Small Opening i, Zi ...
-
Craftsman 358.794941 - page 6
3. Remove the vacuum bag. 4= Close the vacuum inlet cover and make sure it is latched closed. 5= Reinstallthe blowertube (see BLOWER TUBE ASSEMBLY). SHOULDER STRAP ADJUSTMENT (for vacuum use only) 1. Hold the unit as shown with the muffler side facing away from your body and clothes. 2= Pass the shoulder strap over your head and onto your right sho ...
-
Craftsman 358.794941 - page 7
CHOKE LEVER The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After engine OPERATING TIPS • While vacuuming or blowing debris, hold the unit with the muffler side fac- ing away from your body and clothes (see OPERATING POSITION below). • To reduce the r ...
-
Craftsman 358.794941 - page 8
To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. Fuel stabilizer is an acceptable alter- n ...
-
Craftsman 358.794941 - page 9
1. Move the throttle lever to the position. 2. Pull the starter handle sharply until the engine starts, but no more than 5 pulis. NOTE" If the engine has not started, pull starter handle sharply for 5 more pulls. If engine still does not run, it is probably flooded. Proceed to START- ING A FLOODED ENGINE. 3. To stop the engine, move the thrott ...
-
Craftsman 358.794941 - page 10
CLEAN AIR FILTER _" / Air Filter _ Air Filter Cover Screws A dirty air filter decreases engine per- formance and increases fuel consump- tion and harmful emissions. Always clean after every 5 hours of operation. Cleaning the air filter: 1. Clean the cover and the area around it to keep debris from falling into the carburetor chamber when the c ...
-
Craftsman 358.794941 - page 11
A dBi WARNING: Perform the following steps after each use: • Allow engine to cool, and secure the unit before storing or transporting. • Store unit and fuel in a well venti- lated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. • Store unit with all guards in place. Pos ...
-
Craftsman 358.794941 - page 12
TROUBLESHOOTING TABLE (continued) TROUBLE Engh_e will not accelerate, lacks power, or dies under a load. Engine smokes excessively. Engine runs hot. CAUSE 1. Air filter dirty. 2. Fuel not reaching carburetor. 3. Spark plug fouted. 4. Carburetor requires 4. adjustment. 5. Carbon build up. 5. 6. Compression low. 6. 1. Choke partially on. 1. 2. Fuel m ...
-
Craftsman 358.794941 - page 13
off-road engine is purchased. LENGTH OF COVERAGE: This warranty shall be for a period of two years from the initial date of purchase. WHAT IS COV- ERED: REPAIR OR REPLACEMENT OF PARTS. Repair or replacement of any warranted part will be performed at no charge to the owner at an approved Sears Service Center. If you have any questions regarding your ...
¿Tienes una pregunta acerca de Craftsman 358.794941?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Craftsman 358.794941, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Craftsman 358.794941 probablemente compartirá una forma de solucionarlo.