Manuel d’utilisation Clarion DPX1001.2

16 pages 0.77 mb
Télécharger

Aller à la page of 16

Summary
  • Clarion DPX1001.2 - page 1

    OPERAT I ON I NSTALLAT I ON MANUAL 2/1 CHANNEL POWER AMPLIFIER ...

  • Clarion DPX1001.2 - page 2

    DPX1001.2 Power System Amplifier 2 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Input Connections and Audio Controls . . . . . . . . . . 4 Connections for Power and Speakers . . . . . . . . . . 5 Applications . . . . . . . . . . ...

  • Clarion DPX1001.2 - page 3

    Owner’s Manual 3 Owner’s Manual • Gold-plated input/output connectors • Aluminum heat sink for efficient heat dissipation • Low profile, compact size for space limited installations • Wired remote Sub Level Control (BC2) included • Full range or low pass output mode • High level inputs • Built-in Subsonic filter ABOUT THE MANUAL A ...

  • Clarion DPX1001.2 - page 4

    DPX1001.2 Power System Amplifier 4 INPUT CONNECTIONS AND AUDIO CONTROLS The front panel of the DPX1001.2 contains connections for RCA Inputs, Speaker Level Inputs and Audio Controls as shown below. The RCA Input Connections are gold-plated RCA jacks and are labeled as RIGHT and LEFT. • Remote Sub level Control - This port is for the supplied remo ...

  • Clarion DPX1001.2 - page 5

    Owner’s Manual 5 Use this feature, along with your speaker manufacturer’s recommended crossover frequencies, to quickly design a more advanced system. • X-Over Slope Switch - This switch will change the X-Over between a 12db and 24dB per octave slope. The steep crossover slope keeps midrange tones out of the subwoofer and thereby eliminates a ...

  • Clarion DPX1001.2 - page 6

    DPX1001.2 Power System Amplifier 6 APPLICATIONS The Clarion DPX1001.2 2-channel car audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. Figure 3 - In this application the amplifier is bridged for mono operation to drive a subwoofer. Minimum load in the bridged mode is 2 ohms. B ...

  • Clarion DPX1001.2 - page 7

    Owner’s Manual 7 Figure 4 - In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE: A passive crossover must be used with satellite speakers. Minimum load in the stereo mode is 1ohm. 2-Channel Full Range, Satellite, or Subwoofer Stereo System Set Amp Mode as shown Set Amp Mode as ...

  • Clarion DPX1001.2 - page 8

    DPX1001.2 Power System Amplifier 8 (Set INPUT SELECT Switch to STEREO) Mixed-Mode Satellite and Subwoofer System NOTE: Chart values based on 4 ohm speakers. Figure 5 - The amplifier can be configured for a mixed-mode operation. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use components that hav ...

  • Clarion DPX1001.2 - page 9

    Owner’s Manual 9 INSTALLATION This section lists Mounting and Wiring Precautions for installing the Clarion DPX1001.2. These safeguards provide enough detail to complete the installation successfully. If you do not have the necessary skills, Clarion recommends consulting your authorized Clarion dealer for installation. MOUNTING PRECAUTIONS Althou ...

  • Clarion DPX1001.2 - page 10

    DPX1001.2 Power System Amplifier 10 5. Add an external fuse on the amplifier’s positive (+) power lead and connect it as close as possible to the vehicle’s (+) battery terminal. Use a fuse rated to the total current consumption of the amplifier(s). Adding an external fuse will protect the electrical system from short circuits that can cause a f ...

  • Clarion DPX1001.2 - page 11

    Owner’s Manual 11 Figure 6. - Electrical connections for the DPX1001.2 ...

  • Clarion DPX1001.2 - page 12

    DPX1001.2 Power System Amplifier 12 SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON pos ...

  • Clarion DPX1001.2 - page 13

    Owner’s Manual 13 FINAL SYSTEM CHECKS 1. Start the engine and turn on the source unit. After a two-second delay, slowly increase the Volume Control and listen to the audio. If you hear any noise, static, distortion or no sound at all, check the connections, and also refer to Troubleshooting. Depending on your system design, the levels may become ...

  • Clarion DPX1001.2 - page 14

    DPX1001.2 Power System Amplifier 14 Frequency Response Signal Noise Ratio THD Input Sensitivity Low Level Input Sensitivity Speaker Level Max. Power Output Cont. Power Output 2-Ohm Stereo Output Bridged Power Dimensions Current Consumption at output @ max power 20Hz ~ 20kHz >95db .2% all channels driven 250mV ~ 2.5 V 500mV - 5V 500 watts x 2 @1 ...

  • Clarion DPX1001.2 - page 15

    Owner’s Manual 15 WARRANTY INFORMATION This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products except for speakers are covered by a two year warranty when installed by an authorized Clarion dealer. The conditions of this warranty and the extent of ...

  • Clarion DPX1001.2 - page 16

    Clarion Corporation of America 661 W. Redondo Beach Blvd. Gardena, CA 90247-4201 U.S.A. Tel 1.800.GO.CLARION www.clarion.com DPX1001.2 Rev. 1(11/01) ...

Fabricant Clarion Catégorie Stereo Amplifier

Les documents que nous recevons du fabricant de l'appareilClarion DPX1001.2 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Clarion
- manuels d’utilisations DPX1001.2
- fiches produit Clarion
- dépliants
- ou étiquettes-énergie Clarion DPX1001.2
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Clarion DPX1001.2.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Clarion DPX1001.2, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Clarion DPX1001.2. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Clarion DPX1001.2.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Clarion DPX1001.2, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Clarion DPX1001.2 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Clarion DPX1001.2.

Le manuel d’utilisation complet Clarion, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Clarion DPX1001.2 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Clarion DPX1001.2, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lClarion DPX1001.2 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Clarion DPX1001.2 - qui devraient nous aider dans les premières étapes lors de l'utilisation Clarion DPX1001.2
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Clarion DPX1001.2
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Clarion DPX1001.2 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Clarion DPX1001.2?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Clarion DPX1001.2, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Clarion DPX1001.2 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)