Français dropdown-ico

Manuel d’utilisation iRobot 300

28 pages 3.02 mb
Télécharger

Aller à la page of 28

Summary
  • iRobot 300 - page 1

    iRobot ® V er ro ™ O WNER’S MANUAL Model 300 ...

  • iRobot 300 - page 2

    2 iRobot V erro Owner’ s Manual Safety Notes WARNING: Y our cleaner should not be used while people are swimming in the pool. A Ground F ault Current Inter rupter (GFCI) must be installed to protect your electric outlet and prevent an y possible electric shock. The unit must be supplied through a Ground F ault Current Inter rupter outlet. The con ...

  • iRobot 300 - page 3

    www .irobot.com 3 Cautions Please read this manual completely before operating your pool cleaner . Retain the safety and operating instructions for future reference. Do not switch the pool cleaner ON if it is not fully immersed in water . Operating the cleaner out of water will cause se vere damage immediately and will result in loss of warranty . ...

  • iRobot 300 - page 4

    4 iRobot V erro Owner’ s Manual Tips Tip Clean the filter bag regularly . V erro uses the force of the water pumped through its filter bag to move properly . If the filter bag is not k ept clean, V erro will not move or clean properly . Tip Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenh ...

  • iRobot 300 - page 5

    www .irobot.com 5 T able of Contents Anatom y ..................................................................... 6 - 7 P ar ts List .................................................................... 6 - 7 Using V er ro ................................................................. 8 How V er ro W orks ....................................... ...

  • iRobot 300 - page 6

    6 iRobot V erro Owner’ s Manual Anatom y P ar ts List 1. Cable Grommet 2. Body Assembly 3. Jet T ube Bushing 4. Jet T ube 5. F ilter Screen 6. Pump Motor 7. Axle 8. 6” Wheel 9. W asher 10. Steering Axle Housing 11. Square Foam Float 12. F ilter Bag 13. Foam Float Clip 14. Bottom Lid Assembly 15. Jet V alve P or t 16. Jet V alve Housing 17. Floa ...

  • iRobot 300 - page 7

    www .irobot.com 7 3. P ower (ON/OFF) Switch 4. Time Control Dial 5. Socket (F or Floating P ower Cord) 6. Reset Button Jet V alve Housing Assembly T ime Control Dial 15. Jet V alve P or t 15A. Jet V alve P or t Screw 16. Jet V alve Housing Rear View F ront V iew 1. Fuse Holder 2. P ower Supply cord 16 1 5 A 15 ...

  • iRobot 300 - page 8

    8 iRobot V erro Owner’ s Manual Using V er ro 2 Place V erro upside down in the pool and rock it from side to side to allow air to escape. T urn V er ro o ver and allow it to sink to the bottom of the pool so that the wheels rest on the bottom of the pool. 1 Uncoil the floating pow er cord and spread it over the surface of the water , ensuring t ...

  • iRobot 300 - page 9

    www .irobot.com 9 Using V er ro (cont...) 6 Set the time control dial to 30 seconds. See Adjusting the Time Control Dial, below . 7 T urn the Power Supply switch ON then press the reset button. The light on the P ower Supply will illuminate and V erro will star t to clean your pool. 8 After approximately two hours, V erro will stop and the Power Su ...

  • iRobot 300 - page 10

    10 iRobot V erro Owner’ s Manual Using V er ro (cont...) 12 Use the floating power cord to pull V erro to the edge of the pool, then use the handle to lift it out of the water . W ater will drain from V erro as it is lifted. CAUTION: Removing V erro by its floating pow er cord may cause severe damage to the cord requiring costly repairs. 9 W ai ...

  • iRobot 300 - page 11

    www .irobot.com 11 How V er ro W or ks iRobot V erro uses a powerful motor to dra w 80 gallons of water per minute through the filter bag. This creates strong suction at two inlet por ts under the robot that dra ws dir t and debris, such as bacteria, algae, leaves, and even coins into the filter bag where they are trapped. The pump motor also dri ...

  • iRobot 300 - page 12

    12 iRobot V erro Owner’ s Manual Adjusting the Time Control Dial The time control dial determines how long iRobot V erro tra vels in one direction before stopping and reversing direction. Adjust it so that V erro goes from the waterline on one side of the pool to the waterline on the other side at the widest point, w aiting approximately two seco ...

  • iRobot 300 - page 13

    www .irobot.com 13 Cleaning the F ilter Bag It is ver y impor tant to clean V erro’ s filter regular ly in order to k eep it running at peak efficiency . The fine filter bag can trap par ticles as small as two microns across. (For comparison, the period at the end of this sentence is more than 500 microns across.) These small par ticles can c ...

  • iRobot 300 - page 14

    14 iRobot V erro Owner’ s Manual Cleaning the F ilter Bag (cont...) 4 Remove the filter bag assembly . 5 Remove the filter bag from the suppor t bars. 6 T ur n the filter bag inside out and rinse a wa y any accumulated debris with a hose. Gently agitate and squeeze the bag while rinsing it until the water is clear . If this does not remove all ...

  • iRobot 300 - page 15

    www .irobot.com 15 Maintenance and Adjustment Rinsing V er ro iRobot recommends that you rinse V erro with a garden hose after using it. This will extend the life of the plastic and keep your robot looking good for years to come. Storage Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenheit. The ...

  • iRobot 300 - page 16

    16 iRobot V erro Owner’ s Manual Maintenance and Adjustment (cont...) Untwisting the Floating P ower Cord V erro is designed to tra vel around your pool in a wa y that reduces any tendency for the cord to become twisted. Howe ver , if the cord tangles or kinks, and will not lie properly on the surface of the water , it may be neces- sar y to untw ...

  • iRobot 300 - page 17

    www .irobot.com 17 Maintenance and Adjustment (cont...) Cleaning the Impeller 1 Unplug the Pow er Supply . (Please keep the plug a wa y from contact with water .) Unplug the floating power cord from the P ower Supply . 2 Remove the scre ws that attach the jet valve por ts. (See Jet V alve Housing Assembly illustration on page 7.) V erro uses an im ...

  • iRobot 300 - page 18

    18 iRobot V erro Owner’ s Manual 6 Using the bent paper clip, hook the material fouling the impeller . It may be helpful to use a small flashlight to see better . 7 Replace the jet valve por t. 8 Replace the screws. ...

  • iRobot 300 - page 19

    www .irobot.com 19 Maintenance and Adjustment (cont...) Cleaning the Jet T ubes V erro uses two powerful jets of w ater like pow er washers to loosen attached dir t and debris as it moves around the pool. If the tubes that carr y these jets from the impeller to the nozzles under the robot become blocked, V erro will not be able to clean as well. If ...

  • iRobot 300 - page 20

    20 iRobot V erro Owner’ s Manual Checking the Flaps in the V acuum Intak es There is a flap just inside each vacuum intake at the bottom of the robot. These flaps must freely open and close. If they do not, remove any dir t or debris that is interfering with their operation. Cleaning the Direction Baffle V erro uses a baffle to redirect the ? ...

  • iRobot 300 - page 21

    www .irobot.com 21 T roubleshooting Problem likely Cause What to Do V erro moves slowly The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by dirt or debris Clean the filter bag. (p. 13) Check the flaps in the vacuum intakes. (p. 20) Che ...

  • iRobot 300 - page 22

    22 iRobot V erro Owner’ s Manual T roubleshooting (cont...) Problem Likely Cause What to Do V erro reverses direction before reaching end of pool The filter bag needs to be cleaned Time control dial is not set properly Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by ...

  • iRobot 300 - page 23

    www .irobot.com 23 T roubleshooting (cont...) Problem Likely Cause What to Do V erro is not removing attached dir t and debris The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked The pump impeller is fouled by dirt or debris Jet tube is blocked Clean the filter bag. (p. 13) Check the flaps in the vacuum ...

  • iRobot 300 - page 24

    24 iRobot V erro Owner’ s Manual iRobot Customer Care Please visit our web site at www .irobot.com for suppor t tips, frequently asked questions or information about accessories and other iRobot products. We would like to hear from you. Should you still need assistance, call our customer care representative at 877.855.8593 iRobot Customer Care Ho ...

  • iRobot 300 - page 25

    ...

  • iRobot 300 - page 26

    ...

  • iRobot 300 - page 27

    ...

  • iRobot 300 - page 28

    © 2007 iRobot Corporation, 63 South A venue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademark and Verro is a trademark of iRobot Corporation. Cover photo © V eer Incorporated 2002 - 2005. All rights Reser ved. T o purchase accessories: Call 800.727.9077 or visit our w ebsite at store.irobot.com *See registration card fo ...

Fabricant iRobot Catégorie Swimming Pool Vacuum

Les documents que nous recevons du fabricant de l'appareiliRobot 300 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques iRobot
- manuels d’utilisations 300
- fiches produit iRobot
- dépliants
- ou étiquettes-énergie iRobot 300
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation iRobot 300.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation iRobot 300, manuels d’entretien, brefs manuels ou manuels de l’utilisateur iRobot 300. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit iRobot 300.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil iRobot 300, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser iRobot 300 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs iRobot 300.

Le manuel d’utilisation complet iRobot, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel iRobot 300 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières iRobot 300, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour liRobot 300 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil iRobot 300 - qui devraient nous aider dans les premières étapes lors de l'utilisation iRobot 300
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de iRobot 300
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service iRobot 300 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de iRobot 300?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec iRobot 300, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec iRobot 300 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)