Manuel d’utilisation Magnadyne MV1020

20 pages 0.58 mb
Télécharger

Aller à la page of 20

Summary
  • Magnadyne MV1020 - page 1

    Owner's Manual Mobile DVD/CD Player with 10.2" TFT Monitor Model: MV1020 / MV1020C For operational or technical assistance, after reading this manual, please call us toll free at (800) 638-3600 or visit www .magnadyne.com ...

  • Magnadyne MV1020 - page 2

    2 Safety Information . . . . . . . . . . . . . . . . . . . . 2-3 Disc and SD Card Notes . . . . . . . . . . . . . . . . . 4 Screen and DVD/CD Functions . . . . . . . . . . 5-7 Location of Functions . . . . . . . . . . . . . . . . . . 5 T urning the Unit On . . . . . . . . . . . . . . . . . . . 6 Adjusting the Monitor . . . . . . . . . . . . . . . . ...

  • Magnadyne MV1020 - page 3

    3 Features • This unit can play compatible discs recorded in either P AL or NTSC format. • CD, DVD, CD-R, CD-RW and MP3 Compatible. • SD Card Support. • Full-Function Wireless Remote Controller . • Multi-Language On-Screen Display Menu. • Built-In Dome Light System. • Front Panel Controls. • Wireless IR T ransmitter Module so audio ...

  • Magnadyne MV1020 - page 4

    Disc Formats Supported by this Player: Discs which cannot be played with this player: • DVD-ROM • DVD-R/DVD-RAM • CDV • CD-G 4 Disc and SD Card Notes V I D E O (Single-sided disc only) 8 cm disc 8 cm disc Label side up Do not touch the underside of the disc Do not bend Wipe the disc from center toward the outside edge. Disc Handling • Dir ...

  • Magnadyne MV1020 - page 5

    5 Screen and DVD/CD Functions 1. POWER Button: Press this button to turn the unit On/Off. 2. SOURCE Button: Press this button to change the play source between DVD/CD player and an auxiliary input source. 3. STOP Button: Stops play of picture or audio. 4. Power On LED Indicator 5. Infrared Remote Sensor: Receives the signals from the remote control ...

  • Magnadyne MV1020 - page 6

    T urning the Unit On: Press the POWER on either the remote or the screen housing. Adjusting the Monitor: 1. Press the MODE button on the remote to activate the monitor adjustment menu. The following will be displayed on the screen: 2. Press the MODE button again to select the adjustment bar . 3. Use the UP and DOWN buttons on the remote to adjust t ...

  • Magnadyne MV1020 - page 7

    Screen and DVD/CD Functions 7 Dome Light Switch Infrared Remote Control Sensor: The Infrared remote control sensor receives the signals from the remote control. Wireless T ransmitter Modules Wireless T ransmitter Modules: The audio signal is converted to an infrared light and FM frequency that is transmitted to the IR headphones or the vehicle’ s ...

  • Magnadyne MV1020 - page 8

    8 1 9 10 6 18 19 11 13 22 23 24 14 15 17 5 2 3 4 16 20 21 8 12 7 25 POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 Remote Control Locations and Operation 1. POWER : T ...

  • Magnadyne MV1020 - page 9

    POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 30 29 26 27 28 31 32 Remote Control Locations and Operation 26. Use CURSOR buttons when selecting items or to move curso ...

  • Magnadyne MV1020 - page 10

    Slow Play Each time the SLOW button is pressed during DVD play the speed is reduced as follows: 10 Basic Operation and Special Functions Display DVD Menu Screen 1. Press the MENU button to display the DVD menu screen. 2. Use the cursor button to select item. 3. Press ENTER or PLA Y to play the selected. Searching for a Specific Chapter or T rack 1. ...

  • Magnadyne MV1020 - page 11

    11 Special Functions and Setup Menu DVD SPECIAL FUNCTIONS (Continued) Multi-Subtitle Language Function Press the SUBTITLE button during playback. Each time the button is pressed the subtitle language on the screen changes. Multi-Audio Language Function Press the AUDIO button during playback. Each time the button is pressed the audio sound- track la ...

  • Magnadyne MV1020 - page 12

    12 Setup Menu DISC SETTINGS Use the CURSOR buttons to make DISC setting selections. Press the ENTER button to confirm the setting. Audio Setting Use this screen to setup the audio language on multi-language discs. Subtitle Language Setting Use this screen to setup the subtitle language on multi-subtitle language discs. Menu Language Setting Use thi ...

  • Magnadyne MV1020 - page 13

    Setup Menu VIDEO SETTINGS Use the CURSOR buttons to make VIDEO setting selections. Press the ENTER but- ton to confirm the setting. TV Aspect Setting Use this screen to setup the desired TV Aspect Ratio. AUDIO SETTINGS Use the CURSOR buttons to make AUDIO setting selections. Press the ENTER but- ton to confirm the setting. TV System Setting Use thi ...

  • Magnadyne MV1020 - page 14

    14 Setup Menu Last Play Function The Last Play function automatically book- marks the position on a DVD/CD disc and remembers the playback settings. Playback will resumes at the position which the player was turned off, the disc was ejected, or the power was cut off. T urning Off Last Play Function Press the SETUP button to display the main menu. T ...

  • Magnadyne MV1020 - page 15

    15 Installation When installing the MV1020 using a Custom Bracket Mounting System refer to the instructions included wi th with the bra cket. War ning: T ake e x tra ca re not to p enetrate the roof of your v ehicle during i nst allati on. Veh icl e ’ s Cei ling Su pp ort Beams Custom B ra cket Mou n t ing System (Opt i o na l) Custom Sh r oud/B ...

  • Magnadyne MV1020 - page 16

    16 Wiring Diagram Black (Video Out) White (L-Audio Out) Red (R-Audio Out) Audio Video Output (Female RCA) Mini DIN Connector Black Wire - Ground Red Wire - Ignition Y ellow Wire - Batter y Blue Wire - Door (+) Y ellow (Video In) White (L-Audio In) Red (R-Audio In) Audio Video Input (Female RCA) 3A ...

  • Magnadyne MV1020 - page 17

    17 Power Harness Wiring: The 4-wire harness provides battery and ignition 12 volts as well as a chassis ground. Route the power harness to the point in the vehicle that you will make the connections. Red Wire: The red wire in the harness should be connected to a +12 volt power wire that is turned on and of by the position of the ignition key . Y el ...

  • Magnadyne MV1020 - page 18

    18 Only qualified service personnel can remove the cover or service this player . Other wise the warranty will become invalid. No Power: • Check to see if the player is set to “On”. • Check to see that the power plug of the main unit is properly connected. • Check to see if that power to the outlet is properly working. No Picture: • Che ...

  • Magnadyne MV1020 - page 19

    19 Replacement Parts Order Form Send Orders T o : Magnadyne Corporation We Accept Checks, Money Orders, Visa and Master Card A TTN: Consumer Parts Sales Make Checks Payable to: Magnadyne Corporation P . O. Box 5365 Carson, CA 90749-5365 SHIP TO: (No P .O. Boxes) LAST NAME FIRST NAME INITIAL STREET ADDRESS (IF P AYING WITH A CREDIT CARD, YOUR BILLIN ...

  • Magnadyne MV1020 - page 20

    Order By Mail Replacement Parts for MovieVision ® Systems DESCRIPTION MODEL # PRICE DVD Remote Control MV-1020RM $39.95 Ea. ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair , replace or refund the retail sales price of said product or any part thereof, at the optio ...

Fabricant Magnadyne Catégorie DVD Player

Les documents que nous recevons du fabricant de l'appareilMagnadyne MV1020 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Magnadyne
- manuels d’utilisations MV1020
- fiches produit Magnadyne
- dépliants
- ou étiquettes-énergie Magnadyne MV1020
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Magnadyne MV1020.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Magnadyne MV1020, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Magnadyne MV1020. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Magnadyne MV1020.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Magnadyne MV1020, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Magnadyne MV1020 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Magnadyne MV1020.

Le manuel d’utilisation complet Magnadyne, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Magnadyne MV1020 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Magnadyne MV1020, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lMagnadyne MV1020 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Magnadyne MV1020 - qui devraient nous aider dans les premières étapes lors de l'utilisation Magnadyne MV1020
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Magnadyne MV1020
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Magnadyne MV1020 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Magnadyne MV1020?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Magnadyne MV1020, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Magnadyne MV1020 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)