Manuel d’utilisation Clifford 6000

13 pages 0.82 mb
Télécharger

Aller à la page of 13

Summary
  • Clifford 6000 - page 1

    Standard Features of the IntelliGuard 600 0 Programmable (+) or (-) require relays . System Component s The IntelliGuard 6000 installation kit contains the following components : One Prewired 22-pin connector harnes s One Extended Range Receiver One Prewired 4-pin connector harness One Plain V iew 2 Coded V alet Switc h One IntelliGuard 6000 Contro ...

  • Clifford 6000 - page 2

    Wiring Description for the 4-Pin Connector Pi n Wire Colo r Con nects t o 1 Green/Blu e Ignition Outpu t 2 White/Blu e Starter Outpu t 3 White/Brow n Ignition Inpu t 4 White/Green Starter Inpu t Wiring Description for the 22-Pin Connecto r Pi n Wire Colo r Con nects t o 1 Gray/Blu e Channel 4 output 2 Black Prewired to the V alet Switch and Glass T ...

  • Clifford 6000 - page 3

    Passenger Compartment Connection s Control Unit and Extended Range Receive r The IntelliGuard 6000 con trol unit must be in stalled in side the ve hi cle. Un der no cir cum st a nces should the uni t be in stalled un der the hood or other simi larly hos tile en vi ron ment . 1 . Select an area behind the dash to mount the control unit using the sup ...

  • Clifford 6000 - page 4

    Passenger Compartment Connections (Continued ) Trunk Trigge r V ehicles with a ground-switching trunk light will interface directly with the IntelliGuard 6000 (o n positive switching Rolls - Royce vehicles , use a relay to invert polarity). The switch may be located in or near the trunk latch or at the tr u nk light. If a switch cannot b e located, ...

  • Clifford 6000 - page 5

    Engine Bay Connections (Continued ) Hood Trigge r V ehicles with a ground-switching hood light will interface directly with the IntelliGuard 6000 (on positive switching vehicles, use a relay t o invert polarity). The switch may be located in or near the hood latch or at the hood light. If a s witch cannot be located, you must add a pin switch in a ...

  • Clifford 6000 - page 6

    FACT—False Alarm Control and Tes t The system microprocessor automatically checks for another activated sensor or trigger before soun d ing the siren a second time, thus preventing any further false alarms. If you wish to test FAC T , simpl y , 1 . Arm the sys tem with the re mote con trol . 2 . W ait 10 seconds after the interior light turns off ...

  • Clifford 6000 - page 7

    Certificate of Installatio n After installation and testing has been completed, you mus t fill in the Clifford Electronics Certificate of Installatio n . Programmable Feature s IntelliGuard 6000 comes from the factory with its features preprogrammed as noted in bol d text in the tables on pages 8 and 9. Som e features can be programmed by the insta ...

  • Clifford 6000 - page 8

    User-Programmable Feature s User-Programmable Features (1 Chirp = OF F , 2 Chirps = ON ) Fea tur e Selec t Unmarked 1 Unmarked 2 Unmarked 3 Unmarked 4 ✱ 1 Add New Remote NOTE 1 Chirps (Off / O n /Quiet*) (1 chirp / 2 chirps /3 chirps ) *Quiet chirps are only available wit h SSPS Sire n AutoArmin g ( On /Off ) Arm/Disarm with Secondary Remot e NOT ...

  • Clifford 6000 - page 9

    Installer-Programmable Feature s T o access the installer-programmable features, use the procedure defined in the User-Programmable s ection, but after completing step 4, continue to press and hold the ✱ side of the Plain V iew 2 Switch for another 10 seconds. Y ou will hear three confirmatio n chirps indicating that the system is in installer-pr ...

  • Clifford 6000 - page 10

    System Checklist & Troubleshooting (Continued) n Arm the IntelliGuard 6000 (either from inside or outside the vehicle) and wait 10 seconds. T urn th e ignition to the “ON ” position. o Engine does not respond and alarm triggers. This is the correct response, proceed to step 3. o Engine starts or cranks. The starter im mo bi li sa tion cir c ...

  • Clifford 6000 - page 11

    System Checklist & Troubleshooting (Continued) Step 4. Test the park ing lights. Arm the sys tem . n T wo flashes . This is the correct response, proceed to step 5 . n One flash. If the parking lights flash only once, the IntelliGuard 6000 had pre vi ously AutoArmed it self pa s sively and by press ing the arm/disarm but ton the sys tem dis arm ...

  • Clifford 6000 - page 12

    System Checklist & Troubleshooting (Continued ) Step 8. Test the dis arm func tion . n Disarm the system. The following should occur : o Siren chirps onc e . If the siren does not chirp once, refer to step 3 . o Parking lights flash once. If the parking lights do not flash once, refer to step 4. o LED stops flashing . If not refer to step 6 . o ...

  • Clifford 6000 - page 13

    System Checklist & Troubleshooting (Continued ) Step 13 . Test the AutoArming By pass fea ture . Disarm the system. T urn the ignition to the “ON” position, then turn the ignition “OF F . ” n One Chirp . This is the correct response, wait 30 seconds after the interior lights have turned off to insur e the system does not passively arm. ...

Fabricant Clifford Catégorie Automobile Alarm

Les documents que nous recevons du fabricant de l'appareilClifford 6000 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Clifford
- manuels d’utilisations 6000
- fiches produit Clifford
- dépliants
- ou étiquettes-énergie Clifford 6000
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Clifford 6000.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Clifford 6000, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Clifford 6000. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Clifford 6000.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Clifford 6000, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Clifford 6000 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Clifford 6000.

Le manuel d’utilisation complet Clifford, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Clifford 6000 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Clifford 6000, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lClifford 6000 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Clifford 6000 - qui devraient nous aider dans les premières étapes lors de l'utilisation Clifford 6000
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Clifford 6000
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Clifford 6000 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Clifford 6000?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Clifford 6000, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Clifford 6000 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (1)

Гена

Нужна инструкция на русском языке. Где взять?