Manuel d’utilisation KitchenAid W10189714A

12 pages 0.26 mb
Télécharger

Aller à la page of 12

Summary
  • KitchenAid W10189714A - page 1

    MICROWAVE HOOD COMBINATION INSTALLATION INSTRUCTIONS MICROWAVE HOOD COMBINATION SAFETY This pro duct is suitable for us e above electric or gas cooking pr oducts up to and including 30" (76.2 c m) wide. See “Installati on Requirements” section for further notes. These installation inst ru ctions cover dif feren t models. The appearance of ...

  • KitchenAid W10189714A - page 2

    2 INSTALLATION REQUIREMENTS The microwave oven is set for r ecirculation installation. For exte rnal (wall or roof) venting, se e “V enting Design Specificatio ns” sect ion. Tools and Parts T ools Needed Gather the r equir ed tools and part s befor e starting installation. Read and follow the instructio ns provided with a ny tools listed here. ...

  • KitchenAid W10189714A - page 3

    3 Installation Dimensions NOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requir ements” section. * 33" (83.2 cm) is typical for 69" (175.3 cm) inst allation height. Exact dimension may vary depending on type of range/cooktop below . Product Dimensions Electrical Requirements Observe all governing c ...

  • KitchenAid W10189714A - page 4

    4 INSTALLATION INSTRUCTIONS Remove Mounting Plate NOTE: T o avoid possible damage to the work surface, cover the work surface. 1. Remove any remaining co ntents from the microwav e oven cavity . 2. Remove the mounting plate by peeling off the strips of tape that attach it to the back of the microw ave oven, and set the mounting plate aside. 3. T ap ...

  • KitchenAid W10189714A - page 5

    5 3. When the vent de flector is a s far back as it can easily sl ide, flip it so that the wide side is to the back of the microwave oven , and the narrow side (with holes) is down. The vent deflector holes should align with mounti ng holes in the vent opening, as shown in inset. 4. Secur e vent deflector with 2 mounti ng screws (1 on eac h end). 5 ...

  • KitchenAid W10189714A - page 6

    6 Locate Wall Stud(s) NOTE: If no wall studs exist within the cabin et opening, do not install the microwave oven. See illustrat ions in “Possible W all Stud Configurati ons.” 1. Using a stud finder , locate the ed ges of the wall stud(s) wit hin the opening. 2. Mark the center of e ach stud, and draw a plumb line down each stud center . See il ...

  • KitchenAid W10189714A - page 7

    7 Mark Rear Wall The microwave oven must be inst alled on a minimum of 1 wall stud, preferably 2 , using a minimum of 1 lag screw , preferably 2. 1. Using measuring tape, find an d clearly mark the vertical centerlin e of the open ing. A. Centerline 2. With the suppor t tabs facing f orward (se e illustration s in “Possible W all Stud Configurati ...

  • KitchenAid W10189714A - page 8

    8 Attach Mounting Plate to Wall NOTE: Secure the mounting plate to the wall at both bottom cor ner holes drill ed into the wa ll studs and/or drywall using either 1/4-20 x 3" r ound-he ad bolts and toggle nuts or 1 /4 x 2" lag screws. Refer to illustrat ions in “Possible W all Stud Configu rations” in “Locate W all Stud(s)” sectio ...

  • KitchenAid W10189714A - page 9

    9 5. Cut the 1 ¹⁄₂ " (3.8 cm) diameter hole at the circu lar shaded ar ea “G” on the template. This hole is for the power supply cor d. NOTE: If upper cabinet is metal, the supply cord bushing needs to be installed ar ound the supply cor d hole, as shown. 6. Drill 3/8" (10 mm) holes at poin ts “D” and “E” on the template. ...

  • KitchenAid W10189714A - page 10

    10 For Roof V enting Installation Only 1. Insert damper assembly through th e cabinet cutou t so that the long tab of the damper assembly slid es into the slot on the left side of the damper vent opening, as shown. Then secu re with mounting scr ew . NOTE: The screw cannot be instal led if the damper assembly is not positioned as shown. 2. Connect ...

  • KitchenAid W10189714A - page 11

    11 VENTING DESIGN SPECIFICATIONS This section is i ntended fo r ar chitectural designer and builder/contractor refer ence only . NOTES: ■ V ent materials needed for instal lation are not pr ovided with microw ave hood. ■ W e do not recommend using a flexible metal vent. ■ T o avoid possible product damage, be sur e to vent air outside, unless ...

  • KitchenAid W10189714A - page 12

    Recommended V ent Length A 3 ¹⁄₄ " x 10 " (8.3 x 25.4 cm) r ectangular or 6 " (15.2 cm) ro und vent should be used. The total lengt h of the vent sys tem includin g straight vent, elbow(s), transitions and wall or roof caps must not exc eed the equivalent of 140 ft (42.7 m) for eit her type of vent. See “Recommended Standar d ...

Fabricant KitchenAid Catégorie Microwave Oven

Les documents que nous recevons du fabricant de l'appareilKitchenAid W10189714A peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques KitchenAid
- manuels d’utilisations W10189714A
- fiches produit KitchenAid
- dépliants
- ou étiquettes-énergie KitchenAid W10189714A
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation KitchenAid W10189714A.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation KitchenAid W10189714A, manuels d’entretien, brefs manuels ou manuels de l’utilisateur KitchenAid W10189714A. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit KitchenAid W10189714A.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil KitchenAid W10189714A, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser KitchenAid W10189714A par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs KitchenAid W10189714A.

Le manuel d’utilisation complet KitchenAid, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel KitchenAid W10189714A - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières KitchenAid W10189714A, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lKitchenAid W10189714A qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil KitchenAid W10189714A - qui devraient nous aider dans les premières étapes lors de l'utilisation KitchenAid W10189714A
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de KitchenAid W10189714A
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service KitchenAid W10189714A dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de KitchenAid W10189714A?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec KitchenAid W10189714A, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec KitchenAid W10189714A il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)