Manuel d’utilisation Clarion APX401.4

16 pages 0.51 mb
Télécharger

Aller à la page of 16

Summary
  • Clarion APX401.4 - page 1

    OPERAT I ON I NSTALLAT I ON MANUAL 4-CHANNEL POWER AMPLIFIER APX401.4.qxd 12/5/01 12:58 PM Page 1 ...

  • Clarion APX401.4 - page 2

    4 Channel Power System Amplifier 2 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Input Connections and Audio Controls . . . . . . . . . . . . . . 3 Connections for Power and Speakers . . . . . . . . . . . . . . ...

  • Clarion APX401.4 - page 3

    Owner’s Manual 3 Owner’s Manual DESCRIPTION The Clarion APX401.4 4-channel car audio amplifier is an excellent choice for creating a variety of multi-channel sound systems. The amplifier features flexi - bility of 2, 3 or 4 channel system by a flip of a switch. You can also configure the front or rear amplifier sections for a mixed mode operati ...

  • Clarion APX401.4 - page 4

    4 Channel Power System Amplifier 4 The Input Connections are gold-plated RCA Jacks and are labeled as FRONT RIGHT, FRONT LEFT, REAR RIGHT and REAR LEFT. The Gain Controls provide a wide adjustment range to accommodate output levels from any brand of source unit. • Gain Controls - Seperate Front and Rear Gain Controls allow you to set the nominal ...

  • Clarion APX401.4 - page 5

    Owner’s Manual 5 • Rear Channel Input Select - This switch allows the flexibility of using either 2 or 4 inputs to operate the amplifier. • Speaker Level Inputs - These provide connections for a high-level stereo source. These connections are provided for installations when the source unit does not have RCA outputs. WARNING : When using the s ...

  • Clarion APX401.4 - page 6

    4 Channel Power System Amplifier 6 APPLICATIONS The Clarion APX401.4 4-channel car audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. Figure 3 - In this application, the APX401.4 is used as a 4-channel amplifier to drive four full-range speakers in stereo. 4-Channel Full-Range ...

  • Clarion APX401.4 - page 7

    Owner’s Manual 7 Figure 4 - In this 4-channel system, the APX401.4 drives a pair of stereo satellites for the front and a pair of subwoofers for the rear. Note the filter settings. 4-Channel Stereo System 2-Channel High-Pass, 2-Channel Low-Pass APX401.4.qxd 12/5/01 12:58 PM Page 7 ...

  • Clarion APX401.4 - page 8

    4 Channel Power System Amplifier 8 2-Channel Stereo System with Low-Pass Bridged Mono Channel Figure 5 - The APX401.4 can also be used to drive a pair of stereo satellites for the front and a single mono subwoofer for the rear. Note the filter settings. APX401.4.qxd 12/5/01 12:58 PM Page 8 ...

  • Clarion APX401.4 - page 9

    Owner’s Manual 9 2-Channel High Power System (Satellite or Subwoofer) Figure 6 - The APX401.4 can be set up as a 2-channel high-power amplifier to drive a pair of satellites (or subwoofers). APX401.4.qxd 12/5/01 12:58 PM Page 9 ...

  • Clarion APX401.4 - page 10

    4 Channel Power System Amplifier 10 NOTE: Chart values based on 4 ohm speakers. Figure 7 - The amplifier can be configured for a mixed-mode operation on either channels 1/2 or 3/4 amplifier sections. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use components that have a + 5% tolerance and capac ...

  • Clarion APX401.4 - page 11

    Owner’s Manual 11 INSTALLATION This section lists Mounting and Wiring Precautions prior to installing the Clarion APX401.4. These safeguards provide enough detail to complete an installation successfully. If you do not have the necessary skills, do not attempt to install the amplifier yourself. Instead, see your authorized Clarion dealer for inst ...

  • Clarion APX401.4 - page 12

    4 Channel Power System Amplifier 12 6. Refer to the Figure 8 when making electrical connections. Connect the amplifier’s positive (+) lead via a fuse directly to the positive (+) terminal on the battery. Do not connect this wire to the car’s fuse panel. Use red-insulat - ed 10-gauge (or larger) wire for the amplifier’s positive (+) power lead ...

  • Clarion APX401.4 - page 13

    Owner’s Manual 13 SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON position. Set all T ...

  • Clarion APX401.4 - page 14

    4 Channel Power System Amplifier 14 Problem No Audio. Solution Low or no remote turn-on voltage. Check remote connections at amplifier and source unit. Blown amplifier fuse. Replace with new fast-blow fuse (same rating). Power wires not connected. Check battery and ground wiring at amplifier; also check battery connections. Speaker leads shorted. C ...

  • Clarion APX401.4 - page 15

    Owner’s Manual 15 Problem Amplifier fuse keeps blowing. Solution Incorrect wiring or short circuit. Review Installation and check all wiring connections. Problem Whining or ticking noise in the audio with engine on. Solution Amplifier is picking up alternator noise or radiated noise. Turn down input gain; move audio cables away from power wires. ...

  • Clarion APX401.4 - page 16

    Clarion Corporation of America 661 W. Redondo Beach Blvd. Gardena, CA 90247-4201 U.S.A. APX401.4 Rev. 1(11/01) WARRANTY INFORMATION This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products except for speakers are covered by a two year warranty when i ...

Fabricant Clarion Catégorie Stereo Amplifier

Les documents que nous recevons du fabricant de l'appareilClarion APX401.4 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Clarion
- manuels d’utilisations APX401.4
- fiches produit Clarion
- dépliants
- ou étiquettes-énergie Clarion APX401.4
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Clarion APX401.4.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Clarion APX401.4, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Clarion APX401.4. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Clarion APX401.4.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Clarion APX401.4, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Clarion APX401.4 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Clarion APX401.4.

Le manuel d’utilisation complet Clarion, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Clarion APX401.4 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Clarion APX401.4, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lClarion APX401.4 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Clarion APX401.4 - qui devraient nous aider dans les premières étapes lors de l'utilisation Clarion APX401.4
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Clarion APX401.4
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Clarion APX401.4 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Clarion APX401.4?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Clarion APX401.4, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Clarion APX401.4 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)