Bedienungsanleitung Clarion APX401.4

16 Seiten 0.51 mb
Download

Zur Seite of 16

Summary
  • Clarion APX401.4 - page 1

    OPERAT I ON I NSTALLAT I ON MANUAL 4-CHANNEL POWER AMPLIFIER APX401.4.qxd 12/5/01 12:58 PM Page 1 ...

  • Clarion APX401.4 - page 2

    4 Channel Power System Amplifier 2 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Input Connections and Audio Controls . . . . . . . . . . . . . . 3 Connections for Power and Speakers . . . . . . . . . . . . . . ...

  • Clarion APX401.4 - page 3

    Owner’s Manual 3 Owner’s Manual DESCRIPTION The Clarion APX401.4 4-channel car audio amplifier is an excellent choice for creating a variety of multi-channel sound systems. The amplifier features flexi - bility of 2, 3 or 4 channel system by a flip of a switch. You can also configure the front or rear amplifier sections for a mixed mode operati ...

  • Clarion APX401.4 - page 4

    4 Channel Power System Amplifier 4 The Input Connections are gold-plated RCA Jacks and are labeled as FRONT RIGHT, FRONT LEFT, REAR RIGHT and REAR LEFT. The Gain Controls provide a wide adjustment range to accommodate output levels from any brand of source unit. • Gain Controls - Seperate Front and Rear Gain Controls allow you to set the nominal ...

  • Clarion APX401.4 - page 5

    Owner’s Manual 5 • Rear Channel Input Select - This switch allows the flexibility of using either 2 or 4 inputs to operate the amplifier. • Speaker Level Inputs - These provide connections for a high-level stereo source. These connections are provided for installations when the source unit does not have RCA outputs. WARNING : When using the s ...

  • Clarion APX401.4 - page 6

    4 Channel Power System Amplifier 6 APPLICATIONS The Clarion APX401.4 4-channel car audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. Figure 3 - In this application, the APX401.4 is used as a 4-channel amplifier to drive four full-range speakers in stereo. 4-Channel Full-Range ...

  • Clarion APX401.4 - page 7

    Owner’s Manual 7 Figure 4 - In this 4-channel system, the APX401.4 drives a pair of stereo satellites for the front and a pair of subwoofers for the rear. Note the filter settings. 4-Channel Stereo System 2-Channel High-Pass, 2-Channel Low-Pass APX401.4.qxd 12/5/01 12:58 PM Page 7 ...

  • Clarion APX401.4 - page 8

    4 Channel Power System Amplifier 8 2-Channel Stereo System with Low-Pass Bridged Mono Channel Figure 5 - The APX401.4 can also be used to drive a pair of stereo satellites for the front and a single mono subwoofer for the rear. Note the filter settings. APX401.4.qxd 12/5/01 12:58 PM Page 8 ...

  • Clarion APX401.4 - page 9

    Owner’s Manual 9 2-Channel High Power System (Satellite or Subwoofer) Figure 6 - The APX401.4 can be set up as a 2-channel high-power amplifier to drive a pair of satellites (or subwoofers). APX401.4.qxd 12/5/01 12:58 PM Page 9 ...

  • Clarion APX401.4 - page 10

    4 Channel Power System Amplifier 10 NOTE: Chart values based on 4 ohm speakers. Figure 7 - The amplifier can be configured for a mixed-mode operation on either channels 1/2 or 3/4 amplifier sections. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use components that have a + 5% tolerance and capac ...

  • Clarion APX401.4 - page 11

    Owner’s Manual 11 INSTALLATION This section lists Mounting and Wiring Precautions prior to installing the Clarion APX401.4. These safeguards provide enough detail to complete an installation successfully. If you do not have the necessary skills, do not attempt to install the amplifier yourself. Instead, see your authorized Clarion dealer for inst ...

  • Clarion APX401.4 - page 12

    4 Channel Power System Amplifier 12 6. Refer to the Figure 8 when making electrical connections. Connect the amplifier’s positive (+) lead via a fuse directly to the positive (+) terminal on the battery. Do not connect this wire to the car’s fuse panel. Use red-insulat - ed 10-gauge (or larger) wire for the amplifier’s positive (+) power lead ...

  • Clarion APX401.4 - page 13

    Owner’s Manual 13 SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON position. Set all T ...

  • Clarion APX401.4 - page 14

    4 Channel Power System Amplifier 14 Problem No Audio. Solution Low or no remote turn-on voltage. Check remote connections at amplifier and source unit. Blown amplifier fuse. Replace with new fast-blow fuse (same rating). Power wires not connected. Check battery and ground wiring at amplifier; also check battery connections. Speaker leads shorted. C ...

  • Clarion APX401.4 - page 15

    Owner’s Manual 15 Problem Amplifier fuse keeps blowing. Solution Incorrect wiring or short circuit. Review Installation and check all wiring connections. Problem Whining or ticking noise in the audio with engine on. Solution Amplifier is picking up alternator noise or radiated noise. Turn down input gain; move audio cables away from power wires. ...

  • Clarion APX401.4 - page 16

    Clarion Corporation of America 661 W. Redondo Beach Blvd. Gardena, CA 90247-4201 U.S.A. APX401.4 Rev. 1(11/01) WARRANTY INFORMATION This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products except for speakers are covered by a two year warranty when i ...

Produzent Clarion Kategorie Stereo Amplifier

Dokumente, die wir vom Produzenten des Geräts Clarion APX401.4 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Clarion
- Bedienungsanleitungen APX401.4
- Produktkarten Clarion
- Informationsbroschüren
- oder Energieetiketten Clarion APX401.4
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Clarion APX401.4.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Clarion APX401.4, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Clarion APX401.4. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Clarion APX401.4 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Clarion APX401.4, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Clarion APX401.4 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Clarion APX401.4 verständlich ist.

Eine gänzliche Bedienungsanleitung von Clarion sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Clarion APX401.4 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Clarion APX401.4 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Clarion APX401.4, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Clarion APX401.4 - die uns die ersten Schritte während der Nutzung von Clarion APX401.4 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Clarion APX401.4 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Clarion APX401.4 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Clarion APX401.4?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Clarion APX401.4 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Clarion APX401.4 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)