Manuel d’utilisation Metra Electronics Automobile Parts

16 pages 1.16 mb
Télécharger

Aller à la page of 16

Summary
  • Metra Electronics Automobile Parts - page 1

    © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION 1-800-221-0932 axxessinterf ace.com INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK The ASWCST ALK is the newest addition to the Axxess steering wheel control solution, allowing you to add steering wheel control options to your vehicle. Using an aftermarket radio that is equipped with a steering ...

  • Metra Electronics Automobile Parts - page 2

    T OOLS REQUIRED FOR INST ALLA TION •Cutting T ool •T ape •Crimping T ool •Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors IGNITION TERMINALS WIRE CUTTER M3.5 M2.6 M3 M5 M4 ISO 6 2.5 1.5 *Impor tant: Please chec k steering shroud before drilling to mak e sure you hav e enough depth. *After mar k et r adio mus ...

  • Metra Electronics Automobile Parts - page 3

    ASWCST ALK ASSEMBL Y 1. Remove and drill a 3/8 hole in the steering wheel shroud. 2. Select desired length rod and thread a 3/8 hex nut on to the shorter threaded section. 3. Run the four wires from the ASWCST ALK through the rod of choice and screw it into the ASWCST ALK 4. T ake the twist on cover , run the wires through, and twist the cap on to ...

  • Metra Electronics Automobile Parts - page 4

    Wiring Of ASWCST ALK And Interface 1. Connect the BLACK wires of the ASWCST ALK and the BLACK wire of the interface to ground. Y ou may use the same ground point that is used for the radio. 2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCST ALK to the corresponding wires on the interface. 3. Connect the RED wire to 12 volt accessory 4. ...

  • Metra Electronics Automobile Parts - page 5

    Programming the ASWCST ALK * If this is the rst time the ASWCST ALK is being installed: 1. T urn the ignition on; the led will start ashing rapidly which means the interface is looking for the ASWCST ALK and the radio. Go to step 3. OR * If the ASWCST ALK was installed before: 1. T urn the ignition on, the led will ash slowly 2. Hold down ...

  • Metra Electronics Automobile Parts - page 6

    4. The ASWCST ALK is now congured for the right side. T roubleshooting the Auto Detect Mode So you tried the auto detect feature and at the end the led did not stay on solid red, it started ashing, or the steering wheel controls did not function properly . That means the interface did not detect the ASWCST ALK or the proper radio. Follow thes ...

  • Metra Electronics Automobile Parts - page 7

    • Long ashes represent the wire(s) that are connected to the interface • 3rd led ash is the Green/Orange wire on the interface • 5th led ash is the Black/Green wire on the interface If during the auto detect sequence there was no long led ash, just short ones, the interface was not connected to the correct wire on the ASWCST ALK o ...

  • Metra Electronics Automobile Parts - page 8

    1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) 1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) Remapping the ASWCST ALK Let’s say you have the ASWCST ALK programmed to your radio and you want to change the button assignment for the steering wheel controls. For instance you would like Seek Up to be Mu ...

  • Metra Electronics Automobile Parts - page 9

    NOTES: • The interface must have detected the ASWCST ALK and radio it is attached to before you can remap any buttons. • Y ou can only start the remapping of the steering wheel controls process within the rst 20 seconds of turning the ignition key on. If you wait longer then the 20 seconds you will have to turn the ignition off then back on ...

  • Metra Electronics Automobile Parts - page 10

    5. Source/Mode 6. Mute 7. Preset Up 8. Preset Down 9. Power 10. Band 1 1. Play/Enter 12. PTT (Push T o T alk) 13. On Hook 14. Off Hook 15. Fan Up 16. Fan Down 17. T emp Up 18. T emp Down * Note: Remember not all radios will have all these commands. Please refer to the radios’ owners manual for specic commands recognized by the radio. For insta ...

  • Metra Electronics Automobile Parts - page 11

    After the 18th button is programmed or skipped the led will go out and the remapping is completed. If for any reason after remapping the steering wheel controls you want to go back to the original steering wheel control settings, follow the step in “IF the ASWCST ALK was installed before”. Manually Setting The Radio T ype 1. Within the rst 2 ...

  • Metra Electronics Automobile Parts - page 12

    programmed Kenwood. 5) Here is the chart to show how many presses of the V olume Up button is needed for which radio you are trying to program: 1st led ash is for Eclipse 2nd led ash is for Kenwood 3rd led ash is for Clarion 4th led ash is for Sony and Dual 5th led ash is for JVC 6th led ash is for Pioneer and Jensen 7th led as ...

  • Metra Electronics Automobile Parts - page 13

    NO TES ...

  • Metra Electronics Automobile Parts - page 14

    NO TES ...

  • Metra Electronics Automobile Parts - page 15

    NO TES ...

  • Metra Electronics Automobile Parts - page 16

    REV . 8/22/1 1 1-800-221-0932 axxessinterf ace.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK K NO WLEDGE IS P OW ER E nhance your installation and fabrication skills by enrolling in the most re cognized and re spected mobile electronics school in our industry . Log onto www .installerinsti ...

Fabricant Metra Electronics Catégorie Automobile Parts

Les documents que nous recevons du fabricant de l'appareilMetra Electronics Automobile Parts peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Metra Electronics
- manuels d’utilisations Automobile Parts
- fiches produit Metra Electronics
- dépliants
- ou étiquettes-énergie Metra Electronics Automobile Parts
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Metra Electronics Automobile Parts.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Metra Electronics Automobile Parts, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Metra Electronics Automobile Parts. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Metra Electronics Automobile Parts.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Metra Electronics Automobile Parts, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Metra Electronics Automobile Parts par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Metra Electronics Automobile Parts.

Le manuel d’utilisation complet Metra Electronics, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Metra Electronics Automobile Parts - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Metra Electronics Automobile Parts, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lMetra Electronics Automobile Parts qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Metra Electronics Automobile Parts - qui devraient nous aider dans les premières étapes lors de l'utilisation Metra Electronics Automobile Parts
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Metra Electronics Automobile Parts
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Metra Electronics Automobile Parts dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Metra Electronics Automobile Parts?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Metra Electronics Automobile Parts, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Metra Electronics Automobile Parts il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)